air stripping tower packing Articles

  • Analysis and optimization of ammonia stripping using multi-fluid model

    Ammonia recovery from anaerobic digestion (AD) is a notably beneficial process for removing excess nitrogen, producing low cost fertilizer and enhancing odor abatement. A process was developed for nutrients recovery by integrating a simple and effective stripping process with AD system. To design, optimize and scale up this system, multi-fluid model was developed to simulate flow, mass transfer ...


    By IWA Publishing

  • Efficient cleaning of effluent gases from optical fibre production processes using a V-tex scrubber

    In this paper we discuss a unique process technology called the V-tex scrubber. Its design makes it particularly suitable for a wide range of scrubbing and stripping applications, where it can deliver economic and technical advantages for the operator versus conventional packed tower or tray scrubbers, venturi and fluidized bed scrubbers. In cases where there are both particulate and gaseous ...

  • Common Treatment Technologies for Nonhalogenated VOCs in Ground Water, Surface Water and Leachate

    It may be necessary to know other subsurface information to provide remediation of VOCs in the ground water. Treatability studies to characterize the biodegradability may be needed for any biodegradation technology. Treatability studies are usually necessary to ensure that the contaminated ground water can be treated effectively at the design flow. A subsurface geologic characterization would be ...

  • Common Treatment Technologies for Halogenated VOCs in Ground Water, Surface Water and Leachate

    It may be necessary to know other subsurface information to provide remediation of VOCs in the ground water. Treatability studies to characterize the biodegradability may be needed for any biodegradation technologies. Treatability studies are usually necessary to ensure that the contaminated ground water can be treated effectively at the design flow. A subsurface geologic characterization would ...

  • Common Treatment Technologies for Fuels in Ground Water, Surface Water, and Leachate

    It may be necessary to know other subsurface information to remediate fuels in ground water. Treatability testing to characterize contaminant biodegradability and nutrient content may be needed for any biodegradation technology. A subsurface geologic characterization would be particularly important to characterize the migration of NAPLs. Recovery tests are usually necessary to design a ...

  • Boiler feedwater deaerators

    The thermophysical deaerator is by far the most applied technology when oxygen and carbon dioxide in Boiler Feed Water must be reduced to negligible concentrations Bono ARTES has inherited the experience in the design of Deaerators that started up within the BONO Group in 1959. The Boiler Feed Water, if in equilibrium with the atmosphere, may contain significant levels of corrosive gases, mainly ...


    By Artes Ingegneria SpA

  • Food Processing: Odor Control in Edible Oil Processing

    Abstract: The problems with odor around a typical edible oil deodorizer are discussed in detail, and a three-step solution to eliminate these problems is presented. The three steps are a distillate recovery system which recovers most of the fatty acid in the deodorizer vapor discharge as a valuable byproduct, a closed loop barometric cooling water system which keeps the fatladen ...


    By CR Clean Air Group, LLC

  • Common Treatment Technologies for Nonhalogenated VOCs

    Soil vapor extraction (SVE), thermal desorption, and incineration are the presumptive remedies for Superfund sites with nonhalogenated VOC-contaminated soil. Because a presumptive remedy is a technology that EPA believes, based upon its past experience, generally will be the most appropriate remedy for a specified type of site, the presumptive remedy approach will accelerate site-specific ...

  • A.E.S. 1977 paper to with plating emission problems

    A.E.S. PAPER The following paper has NOT been altered whatsoever. Some notes a) A.E.S. stands for American Electroplating Society. b) the mention of l¼ million cfm is now incorrect as it is well over 3 million cfm c) The Grandview E.C.E. scrubber is a condensed name for Eliminate, Coalesce, Eliminate …. and this design is called by various names such as LMS …low micron scrubber and LMITS …low ...


Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you