air temperature sensor Articles

  • Typical Sensor Location Considerations

    The sensor mounting location within a space may be dependent on many variables. There are no specific formulas since each application will have it’s own determining factors and priorities. These include, but are not limited to: source of gas: Is the source a combustion exhaust from a vehicle or furnace or a vapour from a tank spill, pipe leak, or faulty valve? density of ...


    By Arjay Engineering Ltd.

  • An experimental method to estimate the temperature of individual nanowires

    In this paper, the authors present an effective experimental method to estimate the temperature of individual metal oxide nanowires that can be used to quantify the heating produced in conductometric or other operating conditions. The here-proposed method is based on the analysis of the recovery time of the nanowire's resistance after exposure to a gas pulse (0.5 ppm of NO2 in dry air). It is ...


    By Inderscience Publishers

  • Determining Concrete Maturity Using Temperature Data Loggers

    CAS DataLoggers has provided the temperature monitoring devices for a construction contractor which needed to monitor and record the cure of structural concrete onsite. Once workers could prove that the concrete was strong enough, they could then proceed with new construction. The company was on a tight ...


    By CAS DATALOGGERS

  • Effective Temperature Control for Cement Kiln Off-Gases

    INTRODUCTIONEffective off-gas temperature control without unwanted side effects can be achieved in many cement plants with state-of-the-art evaporative spray technology. Gas temperatures have elevated in recent years from as low as 180°C to over 370°C. This is coincident with a higher proportion of 'dry' operation kilns. Evaporative cooling water sprays in conditioning towers, ducts or at the ...


  • What is Temperature Mapping and Validation Study Service : UAE

    What is Temperature Mapping and validation In this video we are trying to explain what is temperature mapping and validation study for ware houses, cold rooms, chiller rooms, refrigerators, reefer, freezers, vehicles etc. Also we explain the procedures for carrying out the same. Vacker Group carries out Temperature Mapping and Validation Study across all Middle ...


    By Vacker LLC

  • Differential Pressure and Temperature Monitoring in a Hospital Cleanroom

    Accsense A1-01a Wireless Environmental Data Loggers CHESTERLAND OH—April 9, 2012 CAS DataLoggers recently provided the wireless pressure and temperature monitoring solution for a hospital maintaining a surgery cleanroom to protect patients from a variety of environmental contaminants. Staff entered and exited through airlocks and were required to wear cleanroom suits before entering. Air ...


    By CAS DATALOGGERS

  • Integrating Solar Lights with Motion Sensors

    Solar powered motion sensor lights are effective security accessories for remote locations that experience sufficient amounts of sunlight throughout the day. The units offer seamless installation, require minimal maintenance and remain operational without electrical support. Locations without dependable access to the grid may find solar security lights useful in maintaining illumination at night. ...


    By Larson Electronics LLC

  • The benefits of monitoring compressed air

    Compressed air is used in many manufacturing processes for many different reasons, from the actuation and control of pneumatic valves and cylinders to the operation of process machinery and tooling. It can also be used as a transport medium for bulk materials or as a purge gas. For all its uses it is nonetheless expensive. This is why, through detailed monitoring, a business can enjoy the ...


    By Contrec Europe Limited

  • Case study - Buoy-based temperature profiling in the Bavarian Lakes

    In summertime a temperature stratification occurs in deep lakes – the surface water is warm, but deep down the water is cold.  This has considerable influence on the nutrient balance and the biological habitat in these lakes. Due to generally higher air temperatures induced by the climate change, both change and have effects on the life conditions of the ecosystems in the lakes. ...

  • Safe Landings Whatever the Weather: Lufft Sensors on Airports

    Pilots, air traffic controllers and airport operators do their best to make air travel safer and more efficient. Sometimes, however, flight security depends on external factors we can hardly influence. This especially refers to risky weather conditions: Strong winds, icy cold or strong precipitation can have serious consequences. On average, 23% of all aircraft accidents and 68% of canceled ...

  • The ‘ins and outs’ of air quality monitoring

    The National Institute for Health and Care Excellence (NICE) recently issued draft guidance on ‘Air pollution - outdoor air quality and health.’ In the following article Jim Mills, Managing Director of Air Monitors Ltd, explains why there will need to be more funding for monitoring if the mitigation measures mentioned in the guidance are to be implemented effectively. Jim also ...


    By Air Monitors Ltd.

  • The Fundamentals of the Air Sampler Calibration-Verification Process

    INTRODUCTION The calibration of an air sampling instrument using a reference air flow calibrator requires attention to scientific detail in order to establish that the instrument’s reported values are correctly stated and valid under the actual operating conditions of the air sampling instrument. DEFINITIONS For the purposes of this ...

  • Safety Systems Depend on Reliable Field Sensors (Emphasis on Fire and Gas Detectors)

    Abstract Because not all hazards are the same, identifying and quantifying the hazard is the starting point in choosing sensing technology. Not all detectors are the same, and they should be selected according to their ability to detect the hazard. This paper gives a broad summary of technologies that provide users reliable responses to hazardous conditions, that minimise false ...

  • 10 Reasons why you should continuously monitor low temperature and liquid chemical sterilants for worker safety

    1. Sterilant chemicals are highly toxic Low temperature and liquid chemical sterilants are designed to kill all microorganisms including resistant spores and if they were not toxic, they would not be effective in sufficiently high concentration to destroy all microbial life including the chemically resistant sporicidal forms of certain ...


    By ChemDAQ, Inc.

  • The challenges and benefits of local air quality monitoring

    A new generation of air quality monitors is now being offered to provide localised, real-time air quality readings – but the potential benefit is only just starting to be realised. It is generally accepted that whilst measurements from air quality reference stations are highly accurate, they are not sufficiently location-specific. Key pollutants – such as NO2 and PM2.5 ...


    By AQMesh

  • Multi-Stage Air Quality Monitoring in the Workplace

    CAS DataLoggers recently supplied the environmental datalogging solution for a factory with a small series of office rooms experiencing serious air quality issues. Employees reported headaches during the work day, indicating a possible lack of adequate ventilation. These workspaces were located next to the busy factory floor which caused an incidental ...


    By CAS DATALOGGERS

  • AQMesh: a new option for flexible air quality monitoring

    AQMesh has an impressive collection of global users and performance results measuring ambient air quality in applications ranging from traffic planning and urban hotspots to industrial fence line monitoring, building ventilation management, or environmental lobbying. This pole-mounted unit comes with an independent power supply and communications, so offering the possibility of measuring air ...


    By AQMesh

  • Air Separation Plants and the Use of Oxygen Monitors

    Air separation plants are critical for many different industries, from clean energy to manufacturing. Nowadays, cryogenic is the most common type of distillation used to separate air into its component gases - nitrogen, oxygen, and inert gases including helium and argon. If your industry relies on air separation for product development or manufacturing, then knowing how the process works is ...

  • Designing and Implementing Perimeter Air Monitoring Programs

    Perimeter or fenceline ambient air quality and meteorological monitoring programs have become increasingly valuable at hazardous waste, landfill, dredging, ports, and MGP remediation sites. Air quality monitoring programs protect public health and reduce owner liability ...


    By AECOM

  • WIRELESS NETWORK PROVIDES MONITORING AND CONTROL OF SENSORS, PUMPS AND OTHER DEVICES AT UP TO 56 REMOTE LOCATIONS

    WIRELESS NETWORK PROVIDES MONITORING AND CONTROL OF SENSORS, PUMPS AND OTHER DEVICES AT UP TO 56 REMOTE LOCATIONS DX80from Banner Engineering replaces costly wiring in wide area installations A scalable wireless network that can monitor and control I/O functions or provide serial communication at up to 56 locations is available from Banner Engineering. The SureCross DX80 product line replaces ...


    By Banner Engineering Corp.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you