ambient emissions monitoring Articles

  • The Portable FID for Stack Emissions: lightweight, compact, ergonomic, safe

    POLLUTION S.r.l. manufactures POLARIS FID analyser, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution S.r.l.

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution S.r.l.

  • Tekran instruments—monitoring around the world

    Tekran provides trace-level mercury analytical and monitoring technology for a variety of applications including laboratory-based sample analysis, continuous point-source emissions and ambient air monitoring. This article focuses on and highlights the results of an application of Tekran’s Ambient Air Mercury Speciation System. In contrast to most other heavy metals, mercury (Hg) and mercury ...

  • TDLAS Gas Detection Instrumentation

    PKL Technologies Inc. manufactures tunable diode laser (TDLAS) based gas detectors and monitors. Spectra-1 open path gas sensors are used in a variety of environmental and safety remote sensing applications. Spectra-1 gas sensors have been designed in a compact, easy to use, robust and portable format. Spectra-1 has been developed using proprietary hardware and software, to produce a low cost ...


    By PKL Technologies Inc.

  • Introduction to the A&WMA 2005 Critical Review: Nanoparticles and the Environment

    Untitled Document

    Nanoparticles are loosely defined as particles with diameters in the range of 1 nm to 50 or 100 nm ...

  • DOAS Explained

    DOAS stands for Differential Optical Absorption Spectroscopy. The DOAS technique was conceived almost a century ago, and it was applied on research level to air quality monitoring already in the 1970s. In the mid-1980s, the technology was then commercialised and turned into practical and wide-spread use.


    By Opsis AB

  • Critical Monitoring of Forklift Emissions and Warehouse Ambient Air Quality - Case Study

    Our team of experts has been hard at work and has just released an industry-leading report detailing Forklift Emissions in Warehouses: The main objectives of this study were to investigate the effects of different engine conditions on exhaust gas emissions and to observe the effect that forklift emissions have on the ambient air quality of the warehouse.             ...

  • Air quality in Europe — 2011 report

    The present report provides an overview and analysis of air quality in Europe. The analysis covers up to 38 European countries (EEA-38) (1) and spans the two decades of data that countries have made officially available up to 2009. The evaluation of the status and trends of air quality is based on ambient air measurements and data on anthropogenic emissions and trends. Emissions of the main air ...

  • Field demonstration of a near-real-time multi-metals ambient fence line monitor case study

    National emissions standards for hazardous air pollutants (HAPs) are required under Section 112 of the Clean Air Act to limit the release of specified HAPs. Permitting, monitoring and enforcement of these emission limits are an integral part of managing air quality to protect human health and the environment. However, this is difficult and highly uncertain in the case of fugitive emissions ...

  • Environics - Reducing calibration gas cost by up to 60%

    EPA's appendix 'M' 40 CFR 51 reduces calibration gas cost by 60%By: Terrence P. Dunn, President of EnvironicsOn May 30, 1995, the EPA published the final version of Method 205 for inclusion in Appendix M of 40 CFR Part 51 entitled, 'Verification of Gas Dilution Systems for Field Instrument Calibrations.' Continuous emissions monitoring systems (CEMS) require ...


    By Environics, Inc.

  • Monitoring Environmental Quality

    ' In order to determine the effectiveness of actions to improve environmental quality it is necessary to be able to measure relevant environmental parameters at a level of detail which is accurate enough to distinguish the anticipated changes. However, the establishment and maintenance of monitoring systems is time-consuming and expensive and therefore the scale of such systems needs to be kept ...


    By The World Bank

  • Pollutant reduction control and Continuous Emissions Monitoring at Waste-to-Energy Plants

    Waste is generally undesired, and best not generated at all. The second best alternative to manage waste is to recycle it. However, there is also waste that for various reasons is not recycled. Landfills have then been the old-school solution, but it is for environmental reasons becoming a less viable option. What then remains is waste incineration, in most cases while recovering the energy ...


    By Opsis AB

  • How Does a Gas Analyser Work?

    Whatever you want to detect, you need to identify a property of the object that is easy-enough to measure. When it comes to monitoring and analysis of gaseous species (atoms or more commonly molecules), it turns out that it often is possible to utilize the optical properties of the gas. You need a light source, a light detector, and a characteristic behaviour of the gaseous species in question ...


    By Opsis AB

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you