benchtop analyzer Articles

  • In compliance with the ASTM D 4294-08 method at low concentrations of sulfur in diesel.

    This application note show the excellent performance of Xenemetrix EDXRF benchtop analyzers X-Calibur and S-Mobile for ultra low sulfur in diesel determinations according to the requirements of the ASTM method D4294-08.The applicable concentration range of the ASTM method is from 17.0 ppm to 4.6 mass%.  This  note show the performance at the very low concentration end ...


    By Xenemetrix Ltd.

  • Application Note - Comparison of minimum detection limits on X-Calibur with SDD detyector or Si-PIN diode detector

    ABSTRACT - The minimum detection limits of several different elements in water and in oil solutions were determined on X-Calibur with a SDD detector installed or a Si-PIN diode detector installed. The MDL was determined at 3 sigma and 300 seconds acquisition times. The result is reported here. OBJECTIVE - To perform a quantitative comparison between the performance of ...


    By Xenemetrix Ltd.

  • Minimum detection limits of several different elements in water and in oil

    Abstract  The minimum detection limits of several different elements in water and in oil solutions were determined on X-Calibur with a SDD detector installed or a Si-PIN diode detector installed. The MDL was determined at 3 sigma and 300 seconds acquisition times. The result is reported here. Objective  To perform a quantitative comparison between the ...


    By Xenemetrix Ltd.

  • The Rebel Accelerates Process-Development Cycles and Maximizes Bioreactor Utilization

    908 Devices launched its new bioprocess analyzer, the Rebel™, at last month’s Bioprocessing Summit in Boston. The benchtop analyzer allows biopharma researchers to accelerate process-development cycles and maximize their bioreactor utilization by running media analysis at-line, anytime. “We’re focused on building disruptive products that enable customers to make critical ...


    By 908 Devices Inc.

  • Automated Optimized TOC using PeCOD Technology

    Almost half of the population of Ontario relies on Lake Ontario for their drinking water. Source water from the great lake must be monitored and protected constantly to ensure chemical and biological agents remain below the accepted limits. Despite best efforts, it is possible that natural organic matter (NOM) can still exist in our drinking water. General methods of determining NOM are by ...


    By MANTECH Inc.

  • Clearwell thm removal consulting engineer report - Case study

    Introduction In July, 2014 the [City] contracted with Medora, Inc for the purchase and installation of a spray aeration system including: one ventilator, seven SolarBee spray aeration units, and one SolarBee mixer at the [8 MG Reservoir]. Contract requirements for the spray aeration system included a performance evaluation to verify the installed system provided a minimum net reduction of ...


    By Medora Corporation

  • Pulp and paper mill operators testing the benefits of simple and fast PeCOD method - Case Study

    A pulp and paper mill in Atlantic Canada is testing the benefits of implementing the PeCOD™ technology at the influent of their secondary treatment.  Since September 2017, operators have run comparative samples for chemical oxygen demand (COD) analysis by photoelectrochemical method (peCOD) and by the conventional dichromate method (CODcr).  The correlation between peCOD and CODcr ...


    By MANTECH Inc.

  • PeCOD correlates COD results in pulp and paper industry

    PeCOD Directly Correlates to Standard Method 5220 A chemical supply company in the pulp and paper industry in the UK has demonstrated the successful correlation between the PeCOD COD (Chemical Oxygen Demand) Analyzer and Standard Method 5220. The standard method uses dichromate, mercury, silver, and sulfuric acid. These reagents are toxic to humans and highly hazardous to the environment. ...


    By MANTECH Inc.

  • Application note issue #5 - Cement Analysis August 2017

    Cement analysis using FP program (Fundamental Parameters) Cement is a blend of several minerals. It is critical to control the elemental composition and properties such as strength, setting, time and color. ED-XRF is being used to analyze the raw components, raw meal, clinker, and the final cement product (Na, Mg, Al, ...


    By Xenemetrix Ltd.

  • Different technology options for monitoring oil in produced water – inline continuous monitoring and IR analysis

    No offshore facility wants to be caught with a sheen around their platform as that can result in a costly fine for exceeding discharge permit limits for oil. Onboard oil in water analyzers are necessary to ensure the oil/water separation systems are functioning properly before overboard disposal of the produced water. Bench top analyzers have traditionally been used to test oil in water although ...


    By Spectro Scientific

  • MicroLab Series – Fully Automated Oil Analyzer

    Introduction The MicroLab 1 is a fully automated, bench-top analyzer specifically designed for the analysis of oil samples to provide comprehensive analytical and diagnostic results of engine, generator, gearbox, hydraulics, power steering and transmission fluids. The MicroLab was developed to bring oil analysis capability to any company that maintains equipment and seeks to improve their ...


    By Spectro Scientific

  • Validation of a fully autonomous phosphate analyser based on a microfluidic lab-on-a-chip

    This work describes the design of a phosphate analyser that utilises a microfluidic lab-on-a-chip. The analyser contains all the required chemical storage, pumping and electronic components to carry out a complete phosphate assay. The system is self-calibrating and self-cleaning, thus capable of long-term operation. This was proven by a bench top calibration of the analyser using standard ...


    By IWA Publishing

  • PolluDet research project - Case Study

    The main goal of this project funded by the Italian regional Government is to develop and test prototype analyzers for routine laboratory use and for on-line application to measure algal toxins in fresh and coastal water. An automated method for the quantitative detection of micrcystins in surface water, to be applied in the above mentioned prototype analyzers in under ...


    By SYSTEA S.p.A.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you