boiler energy Articles

  • Reduced Emissions for Landfill Gas Installations

    The use of landfill gas as a source of renewable energy is increasing. For environmental and safety reasons, the owners of the waste storage sites have to strictly monitor and control the construction, operations, and emissions generated. Sulzer offers solutions to control these emissions within the limits given by the government. Landfill gas is similar to natural gas, but it is created by ...


    By Sulzer

  • Frequency Converter energy savings on Boilers

    Boilers and heaters account for a significant share of a plant's purchased fuel cost. Combustion air fans are necessary to provide enough combustion air to the boiler or heater's burner system. Louvers, inlet guide vanes or frequency converters control the amount of air allowed into a boiler. Configuring a combustion air fan to allow the proper amount of air into the burner can improve boiler ...


  • The potential of energy conservation and emission reduction for the Chinese boilers

    With the publication of the coal convert to gas fired boiler policy, to control the pollution from the resource, all the provinces has removed, stopped and reformed to the high energy saving coal fired boilers. It is reported that there is a huge space in the energy saving and emission. low combustion, high energy saving potential the Chinese industrial boiler has a wide market,and most of them ...


  • Tuning Your Boiler for EPA Boiler MACT Compliance

    The EPA’s Boiler MACT regulations are heating up. Boiler MACT is an EPA rule to limit hazardous air pollutants (HAP) from commercial and industrial boilers and process heaters. Originally proposed in 2011 as a mandate driven by the Clean Air Act,  the rules are Area Source Boiler MACT 40 CFR 63, subpart JJJJJJ for smaller boilers (stores, hotels, apartments, ...


    By Sierra Instruments, Inc.

  • EPA finalizes boiler NESHAP

    EPA published the final National Emission Standards for Hazardous Air Pollutants (NESHAP) for industrial, commercial, and institutional boilers and process heaters at both major and area sources of hazardous air pollutants (HAP) emissions. EPA developed separate rules for units at major sources of HAP emissions (greater than 10 tons per year [tpy] of any single HAP and/or greater than 25 tpy of ...


    By Trinity Consultants

  • Saving waste in the boiler house

    Burner technology has improved greatly in recent years. Older Burners had a series of cams and levers that were calibrated to provide specific amounts of air for a particular rate of firing. Being mechanical items, these wore and sometimes required calibration. They, therefore, had to be regularly serviced and calibrated. Generally, new burners use frequency controlled motors and cams to open air ...


    By EBE Engineering Ltd.

  • Rectify dry cycling of gas boilers and reduce energy costs by 25%

    Building engineers, energy and facilities managers tend to overlook that many gas boilers waste energy through dry cycling when they are not actively contributing to the building heating and hot water demand. It is often thought that existing building management systems (BMS) and building energy management systems (BEMS) are optimising the boilers to remove dry cycling. However, the BMS is ...


    By Vital Efficienci Ltd.

  • Energy, exergy, thermoeconomic and sustainability analyses of a building heating system with a combi–boiler

    The energy, exergy, thermoeconomic and sustainability analyses are applied to the building heating system with a natural gas–fired combi–boiler. The building area is considered as 90 m². Furthermore, the design and analysis of the natural gas installation of the building are done. Two different methodologies (Fine–HVAC and LowEx analyses) are used for energy analyses (heat loss and demand) of the ...


    By Inderscience Publishers

  • Widespread Applicability and Energy Assessment highlight the Proposed New Boiler MACT Rules

    As we reported in last month’s 4 The Record, April 29, 2010 was a busy day for U.S. EPA and marked the culmination of years of background effort and planning related to air toxic emissions from boilers. U.S. EPA has proposed four (4) rules that, when finalized, will impact thousands of facilities. Two (2) of these rules are intended to reduce emissions of toxic air pollutants from boilers ...


    By All4 Inc.

  • How to Get the Most Out of Your Boiler MACT Energy Assessment

    Congratulations!  You’ve made it through the first year of planning for compliance with the Major and Area Source Boiler MACT rules.  That means there are two years left for major sources to come into compliance by January 31, 2016 (or January 31, 2017 for those who requested and received a one-year extension), and just ...


    By All4 Inc.

  • Experience on coal reburn in a utility boiler

    Reburning is an in-furnace combustion modification technology for the reduction of NOx. By staging the introduction of the fuel, an environment is created where NOx generated by the combustion of the main fuel supply is subsequently consumed by the hydrocarbon radicals arising from the reburn fuel under reducing conditions. ENEL has retrofitted unit No. 4 of Vado ...


    By Inderscience Publishers

  • EPA issues final rules for boilers

    The U.S. Environmental Protection Agency (EPA) reports that more than 200,000 boilers, process heaters and incinerators will be impacted by a set of Clean Air Act regulations issued on February 21, 2011. Since EPA first proposed the ...


    By Bergeson & Campbell, P.C.

  • Monitoring flammable gas in boiler houses

    The most common fuels in use for space and water heating are Oil, Natural Gas and Liquid Petroleum Gas (LPG). By far the most popular, clean and cost effective solutions are utilising Natural Gas or LPG. The traditional safety measure derived from the time of oil fired boiler houses is the use of a fusible link placed above the each boiler. The fusible link is intended to melt if it becomes ...

  • Chemically Inclined: The Case for Clean Boilers

    Boiler cleaning is something most companies don’t want to think about — if boilers are working within operational limits it’s often easier to keep up with smaller preventative maintenance (PM) tasks but put off a total chemical clean ...

  • Dewatering of Boiler Ash - Case Study

    Ten Gate develops and produces materials that function to increase performance, reduce costs, and deliver measurable results by working with our customers to provide advanced solutions. THE PROJECT The Wheelabrator Technology Group provides design/build and operation of trash-to-energy facilities. The Wheelabrator facility located in Lisbon, CT utilizes a storage tank for ...

  • Cumulative exergetic assessment of LPFO utilised steam boilers

    This paper relates to a study on the energy and exergy resources, transfers, consumption and losses in the combustion and heat exchanging units of industrial steam boilers. Mass, energy and exergy analyses, which included the physical and chemical exergies of material streams, were used to investigate the energy resource utilisation of Low Pour Fuel Oil (LPFO) in industrial steam boilers. The ...


    By Inderscience Publishers

  • What is a Condensing Boiler and How Does it Work?

    It can be all too easy to get confused about the different types of boilers and which is right for you. Today, it’s all about the condensing boiler, and building regulations specify that any new boiler installed in the UK should be a condensing type. But what are these boilers all about, and how are they different to regular boilers? What is a condensing boiler? ...


    By Green Business Watch

  • Boiler mass spec diagnostic testing case study

    CK Environmental was retained by Ze-Gen, to conduct a diagnostic emissions test program on their pilot plant in New Bedford, Massachusetts. Ze-gen is a leading developer and integrator of waste gasification technology which converts construction and demolition waste (C&D) and municipal solid waste (MSW) into near zero-emissions syngas and electrical energy. The ...


    By CK Environmental, Inc.

  • Norwich - open vent boiler case study

    Customer: Malcolm Robinson Location: Norwich, Norfolk Heating System: Open Vent Glow Worm 85-100 Boiler Installed: 11/09 This is a spacious four bedroom detached house, which was built in 1979. The owner installed a Vortex in November 2009 and compared his energy bills from winter 2008-2009 (pre Vortex) against winter 2009-2010 (with Vortex). The heating for ...


    By Vortex Energy Saver

  • The solutions of industrial hot water boiler water evaporation

    When the water evaporation of industrial hot water boiler occurs,we should actively looks for the reasons and the corresponding solutions to extend its thermal efficiency. In the last article,the reasons of industrial hot water boiler water vaporization have been analyzed,after consulting the engineers of Zhengzhou Boiler Co., Ltd,this text will introduce the ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you