borehole casing Articles

  • Borehole logging case study

    Corozal, Puerto Rico GeoView was tasked to conduct borehole geophysical logging of at a groundwater extraction well in the rural area of the Municipality of Corozal, Puerto Rico. Prior groundwater tests indicated possible contamination of the groundwater. The study area was primarily underlain by stratified, mostly dark gray basaltic tuff, andesite and basalt porphyry rocks assigned to ...


    By GeoView, Inc.

  • Surface borehole resistivity survey case study 1

    Surface borehole method can be used to effectively maximise the value of existing boreholes. This is because surface-boreholre method can give operator more geological and geophysical information around the borehole. For example, we did a surface-borehole survey, where there was already well-known mineralisation existing between 60-80m in Figure one and 100-115m. The inversion resistivity ...

  • Scanning proposed borehole locations for Utilities case study

    Environmental and engineering firms often are tasked with performing soil borings for monitor well installation as part of a Phase II Environmental Site Assessment. This task becomes more challenging when the borings are to be installed in gasoline stations, right of ways or other areas where there are numerous underground utilities that are either unmarked or not properly located. GeoView can ...


    By GeoView, Inc.

  • Measuring and interpreting gas flow from landfill boreholes case study

    Current landfill gas measurement practice for measuring the gas composition is well understood, and there are standard procedures and instruments available to analyse the gas. It is also current recognised practice to measure the gas 'flow' from boreholes to monitor the production of gas in a landfill site. If care is taken to make the measurement in the same way each time, changes in the ...

  • GPS-enabled gas analyser finds & proves borehole locations case study

    Prove it? They can now! Landfill technicians and environmental consultants can now find and prove borehole locations with a GPS-enhanced portable gas analyser from Geotech. Its on-board GPS guidance system takes staff to the precise location of the 1000 it can store. It adds the GPS-received location, date and time to the gas analysis record. GPS locations can be added at boreholes or pre-loaded ...

  • Waterquality in irrigation canals and boreholes - Greece

    Background Kavala is located in the North East of Greece, 680 km from the capital Athens. The population of the prefecture of Kavala is around 85,000 people. The River Nestos which flows through this prefecture is very important for the agriculture of the area. To allow for a fair distribution of the water for irrigation purposes, a number of Boreholes and canals have been established. The ...


    By OTT HydroMet

  • Water Active: Borehole Management in Civil Engineering Projects

    Groundwater wells are common to many civil engineering schemes and their operational performance can play a crucial role in the successful delivery of a project, whether used for construction dewatering, alternative water supplies for facilities or any other application , the well performance must be optimized and high levels of operational efficiency and service availability achieved. A ...


    By Geoquip Water Solutions

  • Pollution mapping case study

    This exploration survey used the cross-hole resistivity method to detect if there was industrial waste water leakage from an industrial waste water process pond. Chemical analyses concluded that this specific waste water has a much lower resistivity than normal water. The figure below shows that the area above 45m is a relatively high resistive zone made of limestone. Below this depth is a middle ...

  • Void and cave detection case study

    Case 3 A crosshole resistivity survey to find karst caves for deep foundation construction          This survey is aimed to find voids for construction safety purpose, as figure below shows, 32 and 20 electrodes were placed into two boreholes respectively. Inversion image found low resistivity areas beside boreholes were likely to be karst caves. Later ...

  • Case Study, Colnbrook Leachate Plant.

    Triangle Ltd was contracted in 2008 by Biffa Waste Services at Colnbrook, Heathrow to resolve the problem of the landfill leachate borehole pumping system failing to deliver acceptable volumes to the SBR leachate plant. Initially they were achieving a maximum of 110m³/month during the fill/aerate treatment ...


    By Triangle Ltd

  • Using Grid Tools in the RockWorks Utilities to Modify a Borehole Manager Stratigraphy Model

    Summary Creating a geological model with RockWorks can be tricky with certain datasets. When a Stratigraphy Model is created in the Borehole Manager, the program creates a top and base grid for each unit listed in the Stratigraphy Table. After model generation, you can view these grids, stored in the Project Directory, in the RockWorks Project Manager. The following steps demonstrate how you ...


    By RockWare, Inc.

  • Bridge/tunnel base exploration case study

    Case 1 A surface-borehole resistivity survey completed for bridge construction As shown infigure 1, this surface-borehole survey was configured to accurately locate known caves for structural reasons. The operator collected 60k data points in only one hour as a result of how the FlashRES-UNIVERSAL can collect all voltage readings for each combination of current electrodes. Figure 2 shows that the ...

  • Surface-point resistivity survey - Case Study

    Drilling boreholes for exploration can be cost ineffective and time consuming. Doing surface-point resistivity survey can provide fast and accurate results, with known position of the target, FlashRES can utilize its electrodes in borehole to target the position of the target, this enables operators to have a good understanding of the interested area. Surface-point resistivity method can also ...

  • Mineral prospecting case study 2

    We had recently carried out a copper prospecting survey. Electrodes were placed on the surface at 5m interval, one cable was connected to electrodes on surface and another cable is put in to the borehole. After repeating the surveys at nearby borehole, we generated two resistivity distribution images. We determined that the band of low resistivity approximately 30m below surface has a high chance ...

  • Fractured Bedrock Remediation - Case Study

    ABSTRACT BOS 200® successfully remediates petroleum groundwater impacts in fractured bedrock at a former truck stop. Based on the post-injection groundwater results from the pilot test and full-scale injection, a No Further Action letter was issued in February 2015. CHALLENGES Over a period of 20 years, site investigation activities revealed a 320 foot ...

  • Sand & Gravel - Case Study

    Creating a Borehole Database A series of exploration boreholes were drilled. Samples were taken every five feet and sieved in order to determine the relative percentages of sand, gravel and clay (or other non-sand/gravel material). These samples were restricted to the interval below the base of the soil profile and the top of the bedrock. The borehole locations, stratigraphy (see Table 1), ...


    By RockWare, Inc.

  • National Grid, Croydon case study

    Morgan Est Contractors for National Grid Supply and installation of telemetred groundwater monitoring network, May 2006 - ongoing Hydro-Logic recently completed the supply and installation of borehole instrumentation and a telemetry monitoring system to monitor groundwater conditions in 28 observation wells located at 19 sites in the vicinity of Croydon. The project was required to ...


    By Hydro-Logic Services

  • National Grid, Croydon case study

    National Grid, Croydon Morgan Est Contractors for National Grid Supply and installation of telemetred groundwater monitoring network, May 2006 - ongoing Hydro-Logic recently completed the supply and installation of borehole instrumentation and a telemetry monitoring system to monitor groundwater conditions in 28 observation wells ...


    By Hydro-Logic Services

  • Brynhoffnant Primary School case study

    Location: London, NW9 6PR Job Type: School Description of Work: 150Kw Vertical Closed loop system Working with Vinci construction and Lorne Stewart, the appointed mechanical contractors, Perfect Green has played its’ part in the early handover of the new Brynhoffnant primary school. The school replaces a number of older schools and ...


    By Perfect Green Group Ltd

  • Hydrometric Network, DCWW case study

    Dwr Cymru Welsh Water, Wales, 2000 - 2008 (ongoing) Rehabilitation and ongoing maintenance of Hydrometric network for monitoring water abstraction and compensation flow gauges across the whole of Wales. Hydro-Logic has been commissioned by Dwr Cymru Welsh Water to install, operate and maintain a large network of telemetry enabled reservoir level and compensation ...


    By Hydro-Logic Services

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you