bunded tank Articles

  • Tramore landfill tank bund - civils works - case study

    Construction works on a reinforced concrete secondary tank bund around the existing leachate tank have been completed at Tramore Landfill Site for Waterford County Council. The tank bund consisted of 200mm thick reinforced concrete slab and walls poured around the existing tank to provide a secondary containment of leachate in the event of failure of the primary tanks. Works involved the ...

  • Great Island Tank 4 and bund refurbishment - case study

    Lining works to refurbish the existing tank farm secondary containment bund and HFO Tank 4 are ongoing at Great Island CCGT project. Lining Tech are contracted in to Balfour Beatty Ireland on this design and build project for the client Tank 4 Works Installation of 1,140m2 of 1mm HDPE leak detection liner to the floor of HFO tank 4 Fabrication and installation ...

  • Fuel terminal upgrade installs advanced valve actuation and control - Case Study

    Sector: Oil & Gas Category: Control Networks, Electric Actuators, Fluid Power Actuators, Services Products: CP, Extended Scope, Field Service, IQ3 Range, Pakscan Overview Independent tank storage provider Vopak is increasing and enhancing fuel capacity at the Vopak Terminal Durban in South ...


    By Rotork

  • GRP Tank Failure

    CPS was contacted by a large waste treatment company after the catastrophic failure of a grp tank had caused major damage and halted production at the plant. The initial tank failure led to the failure of a second grp tank and compromised the integrity of the existing civils bund. Initial work involved a site clean up and disposal of the failed tanks and bund. New Polypropylene pipework was ...

  • NORA Crude Oil Storage Tanks Case study

    The National Oil Reserves Agency (NORA) was established in 1995 as a subsidiary of the Irish National Petroleum Corporation Limited (INPC). NORA is the State Agency responsible for the holding of national strategic oil stocks at a level determined annually by the Minister for Communications, Energy and Natural Resources. Mercury Engineering in conjunction with MICROPACK, supplied, installed and ...

  • Tuffa tanks keep ryanair flying high

    Tuffa UK Limited has completed the order to supply RyanAir with four fifteen thousand litre tanks to store aircraft de-icer, which will help their fleet flying out of Stanstead Airport through the winter's freezing conditions. The custom made bunded tanks, made from MDPE, are the perfect storage vessels for chemicals such as the industry-standard Killfrost de-icing fluids. Tuffa UK Limited are ...


    By Tuffa UK Limited

  • 10000 Litre Horizontal Tank For Triffit Trailers Collaboration

    Enduramaxx have been working with Triffitt Trailers in supplying a new 10,000 litre bowser for on farm use. This trailer is mounted with the Enduramaxx 10,000 litre horizontal tank and the trailer is rated at 32kph specification. ·         The axles on this unit are 2 x 70mm square beam axles, 6 stud, 2000mm track with 13 mt multi-leaf spring set ...


    By ENDURAMAXX

  • Uk`s largest ports business teams up with tuffa tanks.

    TUFFA UK undertook a recent workshop extension to cope with demand for it's larger steel tanks and the new steel fabrication workshop has been completed with state of the art equipment and overhead craneage to enable the production of the large commercial tanks. This enabled the construction of this 70,000 litre Dual Compartment Fuel Tank for delivery to a large Logistics company in the North ...


    By Tuffa UK Limited

  • Tank terminal demonstrates the electrically operated solution for ESD Valves - case study

    Overview Since the disastrous fire at the Buncefield fuel depot in 2005, much has been done to ensure that such a catastrophic accident should not happen again. Led by COMAH (Competent Authority/Industry Standards Task Group), safeguards have been put in place by the petroleum industry to provide additional safety and environmental protection to tank storage installations. Endorsing the ...


    By Rotork

  • Bulk Storage Installation

    CPS was awarded the contract to supply new Spiral Wound HDPE bulk storage vessels for a large pigments manufacturer. The contract involved the supply, fabrication and installation of new 34m3 Sodium Hydrogen sulphide and 30m3 Sodium Hydroxide storage tanks. Each tank was supplied with integral Spiral Wound HDPE Bund and rainskirt complete with actuated discharge valves, heaters and level ...

  • The Second Line of Defence

    The environment is at the top of everyone’s agenda. Oil and related products can be a threat to the natural world when they leak, causing major environmental consequences that kill wildlife, pollute water and spoil agricultural land. It takes both great expense and time to clean up a spill, so a second layer of protection is required as a safety net. The first layer of protection present at ...


    By Maple Grove Enterprises

  • Improving integrity - Bulk Storage

    IKM Consulting’s Alistair Kean reports on recent guidance that aims to improve the integrity of bunds and aboveground storage tanks for petroleum, petroleum products and other fuels. Two new publications, authored by IKM Consulting*, provide the first comprehensive Europe-wide review of the design process for environmental protection, below and within bunds for above-ground storage tank ...


    By Energy Institute (EI)

  • Soil and groundwater assessment, south-east England

    Project Remediation Strategies were appointed to undertake a soil and groundwater assessment to assist a client in understanding the potential environmental liabilities associated with the shallow soils beneath part of the site.  The client was undertaking a phased renewal of the site tank farm areas, which required the excavation and replacement of shallow soils to allow for new ...


    By Remediation Strategies Ltd.

  • New Inspection Facility

    CPS was awarded the contract to design and build a new inspection facility for a specialist alloy manufacturer. The contract included the design and construction of a new production building, electrics and processing equipment. The building works included the design and construction of a new building complete with 6 hoist overhead crane, production office and bunding with chemical resistant ...

  • Participatory watershed management (PWM): an approach for integrated development of rural India: a case study from Karnataka, southern India

    Watershed management is an emerging concept for the efficient use of rain run-off in the rural areas of India. The approach to watershed management is participatory in nature, people friendly, location specific, processed based and geared to cater to the problems and needs of the rural communities. Operation of watershed management is ideal where the rainfall pattern is very short, uneven and ...


    By Inderscience Publishers

  • J555 gasless disinfection

    Detailed design, works manufacture and site installation of Sodium Hypochlorite dosing systems for conversion of 6 sites from Chlorine gas to liquid Sodium Hypochlorite Client: MWH Area: Hertfordshire WES Ltd were involved from early on in the project design stage in developing new Sodium Hypochlorite and Sodium Bisulphite dosing systems for Three Valleys ...


    By WES Ltd / Weschem Ltd

  • Bawtry, Doncaster - Part IIA case sees High Court ruling on who is liable for contamination clean up

    Seventeen families in a Coventry street faced an uncertain future and major disruption to their lives following the discovery of the highly toxic chemical that had polluted the land on which they lived. The one-acre site was previously owned by the Courtaulds chemicals and textiles group, which used it to store carbon disulphide (CS2) – a raw material in the manufacture of viscose rayon at a ...


    By Landmark Information Group

  • Water Treatment - Torry Quay

    The Client: Civils Contractor The Challenge: Following identification of heavy hydrocarbon impacted water during de-watering works, Soilutions were contacted to provide a solution. Impacted waters comprised significant free phase oil on the surface, significant dissolved phase oils, and unknown sediment loading. Requested flow rates were 60m3/hr. Supervision was ...


    By Soilutions Ltd

  • Case study - Allburn Incinerators

    PROJECT 19 off containerised Allburn 3 Incinerators World Health Organisation—Ethiopia PROJECT DESCRIPTION Top loaded, diesel fired, low capacity incinera-tors, factory -installed within 20’ ISO shipping containers, for the disposal of bagged general/clinical waste from hospital and clinics, animal and industrial waste. To be ...


    By Todaysure Matthews

  • Heavy metal & hydrocarbon contaminated sludge

    Solidification of Heavy Metal & Hydrocarbon Contaminated Sewage Sludge Client: North Lanarkshire Council Project Managers: Jacobs Challenge: The former sewage treatment works were decommissioned in the 1970’s. It is thought that during the closure process, demolition material originating from the ...


    By Soilutions Ltd

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you