burner fuel flow balance Articles

  • APPLICATION OF H-VARB TECHNOLOGY TO IMPROVE COAL FLOW BALANCE AT NANTICOKE GENERATING STATION

    ABSTRACT The power generation industry is constantly challenged with the need to improve the emissions and heat rate performance of their assets. In the case of pulverized coal fired units, poor fuel balance at the burners is a relatively common issue that impedes efforts for combustion optimisation. The problem of fuel imbalance is particularly acute on units that employ splitting devices ...


  • Applications guide to mass flow measurement in the power industry

    Precise, timely measurement of air, fuel, and gases is one way today's utilities can take action to protect themselves against rising costs and comply with increasingly stringent environmental requirements. Sierra thermal mass flow meters and control systems are designed expressly to fill these needs. They can make utilities more cost-effective in a variety of applications: Real-Time Fuel Line ...


    By Sierra Instruments, Inc.

  • Tuning Your Boiler for Fuel Savings – Out with the Old in with the New Technology

    The USA has about 811,000 MW of installed generation and over 52% of our Electric power is produced by aging coal fired power plants. The average utility boiler furnace was designed about 30-40 years ago. According to DOE records, the average boiler in 1974 was fired with 80% bituminous coal. Now, western PRB coal is much more prevalent and represents about 50% of total coal ...

  • Gas Fired Oven

      INDUSTRIAL GAS FIRED OVEN   CONSTRUCTION An industrial Gas Fired Oven is typically of steel construction, comprised of inner and outer shells of sheet steel panels, separated by 4” thick, 6 lb/ft3 density mineral wool insulation.  The panels are constructed as to minimize metal-to-metal contact between inner and outer shells and reduce heat flow from ...


    By Epcon Industrial Systems, LP

  • Metal Coating Emission Control

    The use of regenerative thermal oxidizers is expanding into applications where they wouldn’t have been considered years ago, says Mike Scholz As the first generation of oxidizer systems in the industry nears the end of their service life, many canmaking plants face repair or replacement of their existing air pollution control systems. Like many others in the industry, a Silgan canmaking ...

  • Case study - RTO handles high VOC loading at silgan containers

    OVERVIEW Regeneration Game - Originally printed in The Canmaker Magazine - Sayers Publishing Group As the first generation of oxidizer systems in the industry nears the end of their service life, many canmaking plants face repair or replacement of their existing air pollution control systems. Like many others in the industry, a Silgan canmaking plant in the ...

  • Catalytic Oxidizers…What You Should Know.

    Within the U.S., depending upon specific plant operations, geographic locations, etc.,  many companies concerned with controlling VOC emissions have been operating air pollution control systems for years.  However, due to business expansion, plant modifications or recent changes in EPA guidelines, an increasing number of companies are now finding it necessary to install new emission control ...


    By The CMM Group, LLC

  • How to Optimize Oxidation Systems for Efficient Operation

    Emphasis on air management within converting-process dryers and ovens is critical to the design of pollution-control systems for treating exhausts containing VOCs (volatile organic compounds). Efficient air management allows the pollution-control system to be optimally sized to meet the needs of the process. Good process control further defines the emission stream by avoiding the need for large ...


    By Babcock & Wilcox MEGTEC

  • A Breath of Fresh Air for Your

    As the full effect of the Federal Clean Air Act (CAA) Amendments continue to impact today’s industry, many companies will be required to install new or additional air pollution control equipment.  With over two decades of proven success, catalytic oxidation is a popular method for controlling volatile organic compound (VOC) emissions.During the past 25 years, industry has made progress in ...


    By The CMM Group, LLC

  • Regenerative Thermal Oxidizers…What You Should Know.

    Within industry today, the use of an Air Pollution Control System (APCS) to control harmful air pollutants is not new.  In response to Congressional guidelines passed in the 1970’s, a number of companies with VOC emissions have been operating air pollution control systems of one type or another for 25 years or more.  These guidelines have been revised and added to as the years ...


    By The CMM Group, LLC

  • Treatment Options for Molten Sulfur Storage

    Documento sin título ...


    By Merichem Company

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you