calibration gas instrument Articles

  • A simple radon chamber for use with soil gas for calibration of radon measuring devices and instruments

    A simple and easy to use radon calibration chamber of volume of 216 litres was designed and constructed for applications in calibration of radon measuring devices and for research studies. The main advantage of this chamber is that instead of using 226Ra source to generate the 222Rn inside the chamber, ...


    By Inderscience Publishers

  • How Often Should Gas Detectors be Calibrated and by Whom?

    Calibration frequency is one of the most commonly asked questions concerning the use of gas detection instruments. Common factors to consider when deciding how frequently to calibrate are: type of sensor, type of gas detector (fixed vs. portable), the required use and accuracy of the detector, manufacturer’s recommendations, how confident you are about the functioning of your instrument ...

  • Environics - Reducing calibration gas cost by up to 60%

    EPA's appendix 'M' 40 CFR 51 reduces calibration gas cost by 60%By: Terrence P. Dunn, President of EnvironicsOn May 30, 1995, the EPA published the final version of Method 205 for inclusion in Appendix M of 40 CFR Part 51 entitled, 'Verification of Gas Dilution Systems for Field Instrument Calibrations.' Continuous emissions monitoring systems (CEMS) require ...


    By Environics, Inc.

  • Primary Standard Gas Flow Calibration—The Only Guarantee of Accuracy

    At Sierra, we have a saying: “An instrument’s accuracy is only as good as its calibration.” The accuracy of your mass flow controller (MFC) is essential in assuring the efficiency, performance, and quality of your flow meter. In many cases, if your instrumentation is not calibrated, then a decline in performance is possible due to ...


    By Sierra Instruments, Inc.

  • Validation and calibration of a spectroscopic technique for determination of gas plume temperature

    Abstract Results are reported from a continuing program of research into the physics and spectroscopy of heated stack plumes. Simultaneous thermocouple and spectrometer measurements are used to study sideways—directed plumes from an internal combustion engine and a propane-burning plume generator. A previously-reported result, that the ratio of optically thin signals from two CO2 ...


    By D&P Instruments, Inc

  • The Fundamentals of the Air Sampler Calibration-Verification Process

    INTRODUCTION The calibration of an air sampling instrument using a reference air flow calibrator requires attention to scientific detail in order to establish that the instrument’s reported values are correctly stated and valid under the actual operating conditions of the air sampling instrument. DEFINITIONS For the purposes of this ...

  • Tech update: Plant instrumentation - food engineering

    Sensors and other devices are the foot soldiers in automation architecture, but most food and beverage manufacturers still are looking for full value. You know an equipment category has arrived when it starts getting its own industry-specific center. For the food production sensors that do the heavy lifting in instrumentation technology, that day could arrive earlier rather than ...


    By Hardy Process Solutions

  • Gas detector communication technology for offshore oil and gas platforms

    In few applications is safety as important as on offshore oil and gas platforms. Explosive hazards from hydrocarbon gases and vapours are an ever-present risk, whilst toxic hydrogen sulphide gas and depleted oxygen environments can pose significant risks to personnel. Gas detectors are therefore essential to provide dependable early warning of gas hazards. Gas detectors are permanently installed ...

  • Why instrument hire makes occupational safety sense

    Background Decisions concerning the acquisition of occupational safety monitoring instrumentation are often made by operational staff that may not have visibility of the full financial implications of their choices. The following article will examine the factors affecting these decisions and explain why a strategic decision to hire instrumentation can deliver substantial and wide-ranging ...


    By Ashtead Technology Ltd

  • Gas Safety in Confined Spaces

    Introduction An offshore worker ensures a vessel is safe to enter; a plant manager enters a small plant room; a contractor inspects the lining of a sewage pipe.  All these personnel face common dangers, despite working in widely different industries.  Gas-related injury poses a serious threat in any confined space where the free movement of air is limited. A confined space ...

  • Gas safety in confined spaces

    An engineer repairs buried cables; a plant manager enters a small plant room; a contractor inspects the lining of a sewage pipe.  All these personnel face a common danger, despite working in widely different industries.  Gas-related injury poses a serious threat in any confined space where the free movement of air is limited.  ...

  • Geotech sets the industry standard with ISO 17025 Calibration and five days servicing

    Geotech is a trusted manufacturer and supplier of portable and fixed gas analysers for a wide range of industries.  With our vast network of established international distributors, we are able to supply to and support our customers in over 60 countries worldwide. We offer a total support package for our entire product range from our UK-based Service Centre.  The in-house dedicated and ...

  • H2S Safety in Sour Gas Operations

    How GasFinder works Boreal Laser’s GasFinder & GasFinder MC are open-path gas detectors that use an integrated transmitter/receiver unit and a remote, passive retro-reflector. In GasFinder (see below) the transceiver als o houses the laser diode, drive electronics, detector module and micro-computer subsystems. The transceiver unit is contained in an IP65 enclosure and has connectors for ...


    By Boreal Laser Inc.

  • FTIR gas monitor for diverse applications

    QUANTITECH, a leading supplier of environmental monitoring instrumentation, has recently supplied EURO Environmental Services in Ireland with a transportable Gasmet FTIR multiparameter gas analyser which EURO Environmental's Managing Director Geoff Fitzpatrick says, “is proving invaluable in many varied applications across a broad selection of industries.” With headquarters in Drogheda in Ireland ...


    By Quantitech Ltd

  • Geotech expands current instrument hire business - Case Study

    Geotech the market leading manufacturer of gas analysers are increasing their hire fleet due to continued successful growth in their rental business. Customers can enjoy a quick and easy process while choosing from the latest instruments to suit their specific needs.  Whether it is to replace an instrument that is being serviced or a project-based hire, Geotech delivers an excellent  ...

  • CO2 Gas Hazards in the Brewing Industry

    The hazards associated with CO2 in the brewing industry are well known, yet people still die needlessly every year in tragic and completely avoidable accidents in breweries. Just last year in Germany, which has a good safety record, two workers died in separate incidents at the same brewery. In the first incident, the owner was found dead with his head and torso in a beer mixing tank. It is ...

  • Axetris achieves Silver Gas Award 2013

    Here the original text from G&I: „The Axetris AG LGD F200 self-contained laser gas detector module is designed for integration by original equipment manufacturers (OEMs) of selective catalytic reduction (SCR) systems and monitoring equipment and is based on proprietary technology- enhanced tuneable diode laser spectrometry. The OEM module can measure concentrations from well under ...


    By Axetris AG

  • Advances in Thermal Dispersion Mass Flow Meters - Part 2 Installation and Flow Calibration

    Abstract Part 1 of this two-part series describes the principle of operation of a new microprocessor-based thermal dispersion mass flow meter that uses four temperature sensing elements in its flow sensor and has a dry velocity sensor. Part 1 shows how this unique system provides automatic management of changes in gas selection, gas temperature, gas pressure, and outside temperature. This ...


    By Sierra Instruments, Inc.

  • GPR survey to delineate edges of USTs at a gas station

    PROJECT: GPR survey with confirmatory drilling LOCATION: Moyie Springs, Idaho PROJECT DESCRIPTION: Performed a saturation GPR survey of an active gas station, to identify / locate the edges and ends of three inactive closed-in-place USTs. Performed onsite instrument "calibration" with active UST, to establish reliable depth estimates. Recommended ...


    By ECA Geophysics

  • Gas Dilution With The Equal Capillaries Technique

    The advantages of the equal capillaries technique are surprising and leads to reach accuracy values of one order of magnitude higher than all the other dynamic dilution techniques. This comparison will be supported by analyzing the accuracy available with two different techniques. Nozzles (sonic or non-sonic) technique With this technique, a series of different size nozzles is used ...


    By Be.T.A. Strumentazione Srl

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you