calibration gas zero Articles

  • Beyond Zero: Integrating behaviour-based safety at ORYX GTL - Case Study

    Situation Located in Ras Laffan Industrial City, the ORYX GTL plant is Qatar's first commercial producer to process natural gas into low-sulphur and environmentally friendly diesel, naphtha, and LPG. 32,000 barrels of diesel and 8,000 barrels of naphtha are produced every day at the site. Using a gas-to-liquids refining process, ORYX GTL is able to produce fuel low in sulphur and aromatic ...

  • Geotech sets the industry standard with ISO 17025 Calibration and five days servicing

    Geotech is a trusted manufacturer and supplier of portable and fixed gas analysers for a wide range of industries.  With our vast network of established international distributors, we are able to supply to and support our customers in over 60 countries worldwide. We offer a total support package for our entire product range from our UK-based Service Centre.  The in-house dedicated and ...

  • FTIR gas monitor for diverse applications

    QUANTITECH, a leading supplier of environmental monitoring instrumentation, has recently supplied EURO Environmental Services in Ireland with a transportable Gasmet FTIR multiparameter gas analyser which EURO Environmental's Managing Director Geoff Fitzpatrick says, “is proving invaluable in many varied applications across a broad selection of industries.” With headquarters in Drogheda in Ireland ...


    By Quantitech Ltd

  • Understanding the Benefits of Fixed Gas Detection

    "Fixed gas detection is an essential method of ensuring maximum protection for personnel and plant. There are a variety of technologies available for a multitude of applications. Understanding fixed gas detection is the first step in providing safety." What is fixed gas detection? Fixed gas detection is installed with the aim of providing continuous, area and personnel protection. ...


    By a1-cbiss

  • Chlorine Dioxide gas detection: A comprehensive guide

    Introduction Some years agoago, the bleaching process in the paper industry was changed from using Chlorine (Cl2) as bleaching agent to Chlorine dioxide (ClO2). This was a challenge forThis posed a major challenge to industrial hygienists, as there were no sensors or detectors available that were specific to Chlorine dioxide: There was no sensor technology for gas detectors available that ...

  • Gas Dilution With The Equal Capillaries Technique

    The advantages of the equal capillaries technique are surprising and leads to reach accuracy values of one order of magnitude higher than all the other dynamic dilution techniques. This comparison will be supported by analyzing the accuracy available with two different techniques. Nozzles (sonic or non-sonic) technique With this technique, a series of different size nozzles is used ...


    By Be.T.A. Strumentazione Srl

  • FTIR becomes best option for multi-gas emissions

    Globally, the number of industrial processes and emissions being monitored with Gasmet’s FTIR multi-gas technology has increased enormously in recent years as process managers exploit the benefits of being able to monitor a wide range of gases simultaneously and with minimal maintenance and calibration requirements. Gasmet CEMS (continuous emissions monitoring systems) are used for ...


    By Gasmet Technologies Oy

  • FTIR gas analysis improves container safety

    Introduction Entry to freight containers represents a significant hazard to staff responsible for inspection, stuffing or destuffing because of the large number of airborne chemicals that can be present. Research in Germany and the Netherlands found hazardous levels of gases and vapours in around 20% of all containers and this level of contamination is now accepted as commonplace. It ...


    By Gasmet Technologies Oy

  • Gas analysers support management of Swindon fire

    The capability to convene a multi-agency Air Quality Cell (AQC) was established in England in 2009 following the Buncefield Oil Storage Depot incident. A review of this event identified the need to rapidly co-ordinate the acquisition, analysis and interpretation of air quality data in major incidents. Arrangements have been made in England to bring together experts from the Environment Agency ...


    By Quantitech Ltd

  • Upgrading from Pellistor Gas Sensors to Infrared Technology

    In this article Andy Avenell, Crowcon’s Fixed Systems Product Manager, considers the shift towards infrared (IR) gas sensor technology in the oil and gas industry. Abstract Flammable gases and vapours can present considerable dangers in many industrial applications, none more so than the processes involved in extracting, transporting and processing oil and gas. Fast and reliable ...

  • Benefits of HART Communication-Enabled Gas and Flame Detectors

    Catastrophic results can occur when a fire or a flammable/toxic gas release goes undetected in any petrochemical facility. For early warning and prompt hazard mitigation, flame detectors and gas detectors are essential tools. Clear, usable, diagnostic information from these detection instruments is extremely valuable in ensuring the devices are properly maintained, tested, and poised to protect ...

  • PureAire O2 Monitor for Food Manufacturing Tunnel/Freezers with N2 and CO2: Using a 10 Year No Calibration Sensor

    For flash freezing nothing beats a liquid nitrogen or carbon dioxide immersion or tunnel style freezer for efficiency, overall performance, and cost savings. If you haven't yet switched to an immersion freezer, doing so now could position you to better compete in your market segment and save money over time. Learn more about why these freezers are a must for frozen food manufacturers. ...

  • Wastewater Treatment Plant Monitors Greenhouse Gas Emissions

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

  • Gas Analysis Improves Container Safety - Case study

    Entry to freight containers represents a significant hazard to staff responsible for inspection, stuffing or destuffing because of the large number of airborne chemicals that can be present. Research in Germany and the Netherlands found hazardous levels of gases and vapours in around 20 percent of all containers and this level of contamination is now accepted as commonplace. ...


    By Gasmet Technologies Oy

  • Innovation drives flue gas treatment - Case study

    Sharing a common goal, experts in emissions monitoring and emissions abatement have formed a working partnership to develop innovative new materials for treating pollutants in flue gas emissions. ...


    By Gasmet Technologies Oy

  • FTIR gas analyzers support management of fire at UK waste facility

    The capability to convene a multi-agency Air Quality Cell (AQC) was established in England in 2009 following the Buncefield Oil Storage Depot incident. A review of this event identified the need to rapidly co-ordinate the acquisition, analysis and interpretation of air quality data in major incidents.  Arrangements have been made in England to bring together experts from the Environment ...


    By Gasmet Technologies Oy

  • Wastewater treatment plant monitors Greenhouse Gas emissions - Case study

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

  • Safety Systems Depend on Reliable Field Sensors (Emphasis on Fire and Gas Detectors)

    Abstract Because not all hazards are the same, identifying and quantifying the hazard is the starting point in choosing sensing technology. Not all detectors are the same, and they should be selected according to their ability to detect the hazard. This paper gives a broad summary of technologies that provide users reliable responses to hazardous conditions, that minimise false ...

  • New air quality rules challenge oil & natural gas industry

    EPA Administrator signed a suite of proposed new air regulations affecting both the Production/Processing and Transmission/Storage sectors of the oil and natural gas industry. The proposed rules mandate the use of emission controls as well as work practices through two different air regulatory programs – New Source Performance Standards (NSPS) and National Emissions Standards for Hazardous ...


    By Trinity Consultants

  • Not All Hazards are the Same: Design considerations for matching flame and gas hazards to detector technologies

    Not all flame and gas hazards in facilities are the same, therefore the detection technology chosen should be specific to the type of hazard to be detected. How do users select technologies to see certain fires or detect certain gases? The intent of this paper is to give a broad introduction to the selection and use of flame and gas detector technologies. We will answer questions such as these: ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you