calibration kit Articles

  • Case study - TPH in produced sand for overboard discharge

    Customer uses TD-500D to measure TPH concentrations in produced sand on an offshore oil platform in Malaysia.  The sand contains high levels of crude oils and must be treated on-site prior to dumping it overboard.  The TD-500D was calibrated to Sitelab's TPH calibration kit, product CAL-056.  Methanol solvent was used to extract the samples.  For comparison, samples were also ...


    By Sitelab Corporation

  • Case study - Nigeria crude oil in soil site

    Safic Technologies, Ltd. - Port Harcourt A pilot study was conducted testing soil samples collected from a pipeline spill. Split samples were sent to Sitelab for EDRO analysis and results were the same. Samples were also sent to a Nigerian lab and a highly reputable lab in the United States for confirmation. After testing the samples a second time, the American lab got better results. ...


    By Sitelab Corporation

  • Testing Tar & Asphalt for Polyaromatic Hydrocarbons

    New regulations by the European Union require laboratory testing for polyaromatic hydrocarbons (PAHs) when recycling or disposing old tar or asphalt from road planings. Sitelab’s portable UVF-3100D and TD-500D analyzers have similar sensitivity to these types of compounds. The equipment is easy to operate and samples can be tested in the field in less than ...

  • Case study - Canada crude oil sites

    The Canadian Council of Ministers of the Environment requires laboratories to use the CCME’s Petroleum Hydrocarbon (PHC) Method, where GC-FID instrumentation is used to report VPH and EPH hydrocarbon fractions. Sitelab’s popular Extended Diesel Range Organics (EDRO) test typically detects hydrocarbons in the C10 to C36 carbon range, but the UVF will pick up heavier compounds up to ...


    By Sitelab Corporation

  • Field method developed testing asphalt for PAHs and Benzo[a]Pyrene

    New regulations by the European Union require laboratory testing for polyaromatic hydrocarbons (PAHs) when recycling or disposing old tar or asphalt from road planings.  Sitelab’s portable UVF-3100D and TD-500D analyzers have similar sensitivity to these types of compounds. The equipment is easy ...


    By Sitelab Corporation

  • Case study - EDRO in soil at wharf remediation site

    Sitelab Calibration Kit CAL-042 is used for EDRO analysis. The UVF-3100 detects hydrocarbons in the C10-C36 range. A Licensed Site Professional (LSP) used Sitelab to investigate a commercial waterfront property, contaminated with a plume of LNAPL resulting from fuel tanks which once stored heating oil, diesel and gasoline dating back to the 1950s. The site is in Massachusetts, where laboratories ...


    By Sitelab Corporation

  • Case study - NAPL forensics analysis at refinery site in Kansas

    An environmental consultant at Subsurface Environmental Solutions, LLC used Sitelab to fingerprint a large plume of Non Aqueous Phase Liquids (NAPL) located at a former oil refinery in Kansas. The plume is commingled with gasoline, diesel, crude oil and other petroleum products. Sitelab’s portable UVF-3100D analyzer is fitted with optical filters which can measure the C6 to C10 gasoline ...


    By Sitelab Corporation

  • Case study - EPH in soil with No. 6 fuel oil

    No. 6 fuel oils (heavy fuel oil, bunker C oil) is often used in industry for heat, steam or power generation. A consultant used Sitelab to investigate two different spill sites contaminated with subsurface plumes of NAPL resulting from leaking underground storage tanks (USTs). Soils were collected from borings using a drill rig and field screened for their EPH aromatic content. Split samples ...


    By Sitelab Corporation

  • Case study - Texas crude oil in soil sites

    Sunset Well Service, Inc. is an environmental contractor located in the Midland/Odessa area of Texas. They use their UVF-3100D analyzer to help excavate and remediate soils contaminated by produced water and crude oil. Laboratories in Texas test TPH using the TX 1005 GC-FID Method. This method is similar to U.S. EPA Method 8015M, but reports the GRO, DRO and ORO fractions separately. Soils from ...


    By Sitelab Corporation

  • Case study - EPH in soil with diesel and home heating oils

    Sitelab’s UVF-3100 analyzer is a popular tool when excavating soils contaminated by fuel oils from underground storage tanks (USTs). These studies show the accuracy testing samples for Extractable Petroleum Hydrocarbons, EPH C11- C22 aromatic hydrocarbons. Samples are extracted in solvent using test kits and measured on the UVF analyzer’s EPH optics, calibrated to Sitelab’s PAH ...


    By Sitelab Corporation

  • Case study - TPH Oil & Grease applications

    These case studies illustrate the performance generated from customers who have used Sitelab’s UVF-3100 analyzer for testing total petroleum hydrocarbons in the C10 to C50 range. Sitelab’s TPH-Oil calibration kit is designed to correlate well to laboratory “Oil and Grease” test methods. This includes EPA Methods 1664 and 9071B by Gravimetric, EPA Method 418.1 by Infrared ...


    By Sitelab Corporation

  • Case study - GRO in soil at gasoline UST site

    These case studies show the performance using Sitelab’s UVF-3100 analyzer testing gasoline range organic hydrocarbons.  This includes benzene, xylene, BTEX and other volatile petroleum compounds in the GRO or VPH C6 to C10 hydrocarbon range. When calibrated using Sitelab's GRO calibration kit (CAL-025), the UVF analyzer produces test results that correlate well to laboratory ...


    By Sitelab Corporation

  • Hydrogen Sulfide Continuous Emission Monitoring of Odor Control Systems

    ABSTRACT This paper discusses the use of the Sycamore Continuous Emissions Monitor (CEM) for monitoring Hydrogen Sulfide Gas concentrations within odor control systems. The CEM is configurable as a single, two or three point system and can measure from 5 ppb to 2 PPM, 0.1 – 20 PPM, and 0 – 200 PPM and is designed for monitoring of scrubbers, carbon adsorbers, biofilters and biotrickling ...

  • Field Detection of Chlorinated Alkenes in Well Water using the FROG-4000 Portable GC - Case Study

    Introduction Defiant’s FROG 4000, a portable GCPID system, was used to identify and determine the concentration of chlorinated alkenes in several extraction wells located in Tacoma Washington. Split samples were taken at each well and sent to an offsite lab for analysis. This case study examines the field exercise and highlights the high degree of agreement between the offsite lab and ...


    By Northern ANI Solutions Ltd.

  • Used noise meters, dosemeters and calibrators online

    Pulsar Instruments is pleased to announce that it has a selection of used sound level meters, noise dosimeters and acoustic calibrators available to buy online. The 'used' stock is from our ex-demonstration meters, ex-rental equipment and also from customer trade-ins. Brands on sale include Pulsar Instruments, Castle Group and Casella - with more expected to be added. Pulsar's General Manager, ...


    By Pulsar Instruments Plc

  • TEGAM Thermocouple Calibrators & AMS2750E Compliance for Heat Treatment

    AMS2750E Compliance for Heat Treatment and TEGAM Thermocouple Calibrators System Accuracy Tests (SATs) and Instrument Calibration as required by the AMS2750E Standard for thermal processing equipment used in heat treatment can be greatly simplified with ...


    By TEGAM, Inc

  • `Good to Go™ tags´ manage your daily or weekly calibration and safety checks

    Keeping up with safety regulations can be complicated and time-consuming. Having an easy to complete, simple visual guide to carry out safety or calibration checks solves this problem and helps to keep the workplace safe. One glance and you can see the equipment is “Good to ...


    By Camlab Limited

  • doseBadge Builds up a Head of Steam in York

    Here’s the latest case study from Cirrus Research, featuring the world-famous National Railway Museum. See how the doseBadge Noise Dosimeter helps Anna Kavanagh check that her teams are not exceeding their daily noise exposure limits. The Client: The Science Museum Group The Sites: National Railway Museum, York The Issue: Noise ...


    By Cirrus Research plc

  • Lifesaving weather warnings thanks to professional visibility sensors

    The new Lufft visibility sensor VS20k is now officially available. But what distinguishes it from the previous model and for which applications is it suitable? In the following article, you learn more about the new Lufft visibility sensor family… Reduced visibility – a risk for all traffic users Traffic accidents, flight cancellations and delays: Reduced visibility is ...


    By OTT HydroMet

  • How Often You Should Calibrate A Sound Level Meter

    Do you calibrate a sound level meter frequently? Most sound level meter users know they must calibrate their sound level meters but a questions I frequently get asked if “how often?” Here’s my best practice advice so you can calibrate with confidence. What Do We Mean by Sound Level Meter ...


    By Cirrus Research plc

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you