cardboard separation Articles

  • Simple Separation: Diverting Wood And Cardboard at Construction Sites

    Diverting Wood And Cardboard At Construction Sites Residential home construction in Wisconsin generates 128,000 tons of residuals annually, according to a 1998 study by Camp, Dresser & McKee. Ten builders are participating in a project to demonstrate how easily major components of this waste stream can be recycled. The Metropolitan Builders Association (MBA) of Greater Milwaukee, the ...


    By BioCycle Magazine

  • Paper and Cardboard - Recovery or Disposal?

    To provide a solid basis for policies and policymakingin the field of waste management, the environmental and economic impacts causedby different waste treatment options should be examined. In recent years, a large number of studies comparing recycling with recovery or final disposal have been published, which are based on life cycle assessment (LCA) and cost-benefit analysis (CBA). To the ...

  • The Atritor Turbo Separator

    Due to the changes in restrictions and the increase in the cost of landfill, the Gypsum Industry is looking for an alternative to handle the estimated 300,000 tons of new build plasterboard waste generated every year. The traditional way of separating gypsum from its backing is to use hammer mills, in conjunction with sieves, which is costly and generates a lot of dust.Atritor offers reprocessing ...


    By Atritor Limited

  • Plastics Separation in Compost

    Untitled Document Operators say their number one contamination problem is plastic - small, large and in-between - in the compost ...


    By BioCycle Magazine

  • How waste and recycling are separated at the French Open - Case Study

    Once again, the French Open (Roland-Garros) is setting new standards in sustainability and recycling! Over the past few years, the French Tennis Federation and Roland Garros have aimed to increase awareness of recycling and ...


    By Harmony Enterprises, Inc.

  • Case study - Altpapier Sortierung Dachau Gmbh – Germany - Sensor based optical sorting for paper de-inking

    Customer ASD - Altpapier Sortierung Dachau GmbH - are specialists in recycling of waste paper. The company produces high quality paper grades for their industry partners. Requirements The requirements are maximised gain output with the highest purities of 97% of sorted paper grades from waste paper with less than 8% de-inking loss overall. ...

  • Granada Eco-Center: Technology at the service of efficient material recovery - Case Study

    Granada Eco-Center, in Alhendin (Granada), with a nominal capacity of 450,000 tons per annum, is totally automated and is one of the leading facilities in waste recycling at the national level, and had a 10.8% waste recovery rate on inputs last year. The plant features 4 treatment lines that process 30 tons per hour and has 10 AUTOSORT ...


    By TOMRA Sorting GmbH.

  • Case study - RDF plant Tel Aviv

    Engineering and planning, procurement, production and delivery of the complete plant engineering as well as installation and commissioning. Retention: September 2012 Throughput: 540,000 Mg/a Operational time: at least 6,200 Mg/a Input: municipal solid waste, commercial and industrial ...


    By Eggersmann Anlagenbau

  • Baling saves time and makes money

    Somerset West is situated approximately 50 km east of Cape Town in South Africa. The town has 30,000 inhabitants, some of which shop at one of the town’s SPAR supermarkets, where more than 700 customers fill their baskets with groceries every day. As a result, the supermarket generates ca. 100-130 kg. of cardboard, paper and plastic waste a day and until recently, handling it all was ...


    By Bramidan Balers

  • Food service zero waste program case study

    Foodservice client that was looking to increase waste diversion but didn't want to increase costs by adding a recycling program. Before RecycleSmart, all materials were being disposed of in a roll off garbage bin. A variety of different material types were being produced at the facility: Cardboard Paper Bags (flour/sugar/other), Plastic Buckets and Bottles (#1, #2, #3 and ...

  • A three month test run was a success at OBI - Case Study

    People used to get tools and nails from the ironmonger, they bought paint and wallpaper from the specialist paint shop and wood from the timber merchant. Now the customers can obtain everything from the OBI store. Loads of loose waste The variety of goods on the shelves in an OBI store means loads of waste in the goods reception, which take up a lot of space. The OBI ...


    By Bramidan Balers

  • Case study - MBT Wrexham

    Planning, delivery, installation, commissioning, testing and turnkey delivery of a plant for mechanical-biological treatment of municipal waste. Customer: FCC Environment Throughput: (50,000 Mg/a): 33,500 Mg/a Household waste and 16,500 Mg/a Commercial waste Commissioning: March/April 2015 ...


    By Eggersmann Anlagenbau

  • Case study - Grundon Waste Management Ltd. – England - Single stream waste sorting plant for MRF

    Customer Grundon Waste Management Ltd. is the largest privately owned waste management company in the UK. The company was founded in 1929 and has moved into landfill operation, waste collection, and most recently into harnessing energy from waste. The company offers a wide range of waste collection services spanning mixed recyclables, general (non-recyclable) waste, clinical and hazardous ...

  • Case study - Papyrus Austria paper sorting

    Customer For 30 years, Papyrus Altpapier Service has been active in the disposal and secondary raw material industry in Austria. The Papyrus Group has 180 employees at 5 locations. Request Conversion and automation of an existing manual sorting system, combined with a throughput increase of 12 tonnes per hour, as well as compliance with the purity ...

  • Rental agreement gives more flexibility - Case Study

    Sunarc Technology A/S treats glass with a special antireflection treatment for use in solar power plants and greenhouses. When the glass is delivered from various suppliers it arrives safely wrapped in paper, cardboard, plastic and styrofoam. Previously the used packaging was emptied into containers, which were picked up by the company’s waste collector against payment. “In February ...


    By Bramidan Balers

  • Case study - Municipal Company of Waste Management Ltd - Recycling MRF with RDF production – Katowice, Poland

    Customer The Municipal Company of Waste Management Ltd in Katowice provides a framework of service activities such as: The collection and transport of waste Selective collection and utilization of waste Composting organic waste All year round road maintenance Automotive diagnostics Requirements ...

  • Extraction of many emission sources in extensive factory premises - Case Study

    Example: Packaging Similar tasks: Coating, Automobile industry, paint production Different production processes lead to decentralised ventilation of emission sources. These decentralised ventilations are consolidated within a central air pollution control system. A producer of plastic, cardboard and composite material packages uses a range of printing units, laminating machines ...

  • Time saved is money earned - Case Study

    When spring arrives the garden centre Æ Gårne feels it immediately. Thousands of customers spend the first warm days searching for new plants and garden tools for their garden projects this year. This swirl of activity also makes the staff busy in the warehouse, where they quickly unpack goods delivered and move them into the sales areas. Left in the stock area are heaps of cardboard, ...


    By Bramidan Balers

  • Dewatered waste is disposed at lower cost

    By compacting and dewatering  reject, a paper recycling company avoid having to transport water for no useful purpose. SKJERN PAPIR A/S in Denmark produces 54,000 tons of liner and cardboard from recycled paper annually. In the initial sorting, the paper material is separated out from large, insoluble materials such as plastic, staples and other unwanted elements using a pulper. The ...


    By Runi A/S

  • HSM vertical baling press provides order and cleanliness at the ROBINSON Club Daidalos on the island of Kos - Case Study

    The ROBINSON Club DAIDALOS on the Greek island of Kos is a magical location. Regardless of whether you are looking out from the balcony of a room or from the bar: the view of the Aegean Sea and the offshore islands puts hotel guests under a spell at any time of day. The hospitality of the staff and the unbelievably great sports and leisure activities make this club unique. Of course, guests know ...


    By HSM GmbH + Co. KG

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you