cement kiln continuous emissions monitoring Articles

  • Continuous Mercury Monitoring Benefits Cement Plants

    Antti Heikkilä from Gasmet Technologies highlights the challenges faced by mercury monitoring in cement kilns, and explains how a new continuous mercury monitoring system addresses these issues and provides process operators with an opportunity to improve environmental performance and demonstrate compliance with forthcoming legislation. Background The production of cement ...


    By Gasmet Technologies Oy

  • Air Rule for Cement Kilns Requires 92 Percent Cut in Mercury Emissions

    Portland cement kilns will be required to reduce emissions of mercury by 92 percent as part of an Environmental Protection Agency final rule announced Aug. 9 that imposes controls for several toxic pollutants. Although most of the emissions standards in the final rule are less stringent than what the agency had proposed in 2009, the cement industry said the cost to operate the required controls ...


    By Ohio Lumex

  • Cementing the PC MACT

    On September 9, 2010, the U.S. EPA promulgated the final amendments to the National Emissions Standard for Hazardous Air Pollutants from Portland Cement Manufacturing Industry (40 CFR 63 Subpart LLL), also known as the PC MACT. EPA’s self-proclaimed “historic” rulemaking includes some important implications for cement manufacturers and other sources that may be subject to ...


    By Trinity Consultants

  • Wastewater Treatment Plant Monitors Greenhouse Gas Emissions

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By SIGRIST - PHOTOMETER AG

  • PC MACT proposal may signal widespread change

    On May 6, 2009, EPA proposed amendments to the National Emission Standards for Hazardous Air Pollutants from the Portland Cement Manufacturing Industry (PC MACT) in response to numerous petitions and court mandates. The proposed revisions present significant challenges to the portland cement industry by establishing a new lower maximum achievable control technology (MACT) floor that would require ...


    By Trinity Consultants

  • EPA proposes updates to CISWI rules

    On June 4, 2010, the U.S. EPA proposed updates to the Standards of Performance for New Stationary Sources (NSPS) for Commercial and Industrial Solid Waste Incineration (CISWI) Units (NSPS Subpart CCCC) and Emission Guidelines (EG) for Existing CISWI Units (EG Subpart DDDD), collectively referred to as the "CISWI Rules." In order to describe the proposed updates to the CISWI Rules, it is necessary ...


    By Trinity Consultants

  • Final CISWI rule

    On March 21, 2011, in parallel with publication of the Boiler National Emission Standard for Hazardous Air Pollutants (NESHAP) rules and the Non-Hazardous Secondary Material (NHSM) rule, EPA promulgated the final updates to the New Source Performance Standards (NSPS) and Emission Guidelines (EG) for Existing CISWI Units, collectively referred to as the “2011 CISWI Rules.”1 The 2011 ...


    By Trinity Consultants

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you