cems stack monitor Articles

  • Continous Emission Monitoring (CEMs)

    Presented in Track B1: CEMs at EUEC 2011,January 31 Phoenix, Arizona   B1.1  | Particulate CEM for wet FGD plant William Averdieck |  Managing ...

  • CEMS: An Overview

    We've written an overview to where CEMS are required, types of site that require CEMS and future requirements. Continuous Emissions Monitoring Systems are used to continuously collect, record and report data from industrial process operators that produce emissions to air. CEMS are used as a means to comply with ...


    By a1-cbiss

  • How has MCERTS impacted CEMS?

    Industrial process operators that produce gas emissions to atmosphere are regulated by the Environment Agency. Monitoring of these emissions ensures that the environment is being properly protected and helps them manage their own impact on the environment. Under the Environmental Permitting Regulations, these sites are required to continually measure emission parameters from their chimney-stacks ...


    By a1-cbiss

  • How Do PEMS Stack Up?

    Chemical Engineering Magazine journalist, Amer Khaqan investigates the installation of a relatively unknown method of emissions monitoring, PEMS (Predictive Emissions Monitoring System) at the methanol production facility of Arrazi in Saudi Arabia. The article shines light on the advancing technology of PEMS and explains the advantages of installing one, over the commonly used CEMS (Continuous ...


  • Continuous emission monitoring and control of packed tower odor control systems using the sycamore CEM

    ABSTRACT Packed-tower chemical scrubbers, with sodium hydroxide (caustic) and sodium hypochlorite (bleach), are commonly used to treat foul air from wastewater treatment processes. The available control mechanisms include a pH probe and controller for the sodium hydroxide feed, an oxidation reduction potential (ORP) probe with a controller toestablish the bleach feed, and proprietary ...

  • An analysis of extinction coefficients of particles and water moisture in the stack after flue gas desulfurization at a coal-fired power plant

    Two important factors that affect in-stack opacity—light extinction by emitted particles and that by water moisture after a flue gas desulfurization (FGD) unit—are investigated. The mass light extinction coefficients for particles and water moisture, kp and kw, respectively, were determined using the Lambert-Beer law of opacity with a nonlinear least-squares regression method. The ...

  • Pollution monitoring in Cement Industry

    The rising use of waste based fuels in the cement industry, both for economic and Environmental objectives, combined with the strengthening of air emission regulations around the world is pushing many operators to face a wider list of pollutants to monitor this, with associated costs. The design of appropriate solutions meeting local regulation is the key to maximize the cost benefit of the fuel ...


    By Environnement S.A

  • Innovative emissions monitoring uptake soars

    Firms in the UK’s waste and power sectors are proactively seeking Best Available Techniques for emissions monitoring, according to Enviro Technology. Over recent months there has been a surge in demand for sophisticated equipment, such as monitors of total gaseous mercury. The air quality and emissions monitoring specialist believes that a combination of factors, such as the recast ...

  • Compliance to standards in continuous emissions monitoring case study

    Customer: Glass Manufacturer Application: Continuous Emissions Monitoring Service (CEMS) for Glass Manufacturing Background: A glass factory is required to ...


    By Ecotech Pty Ltd

  • In-situ continuous emissions monitoring & regulatory compliance

    As environmental scrutiny has risen and regulation has tightened in recent years, the importance of having accurate information on the environmental performance of your power plant has increased. After all, if you want to manage something, you need to be able to measure it. The analogy is obvious; you wouldn't start a diet without first investing in a set of scales. So it is with Continuous ...

  • FTIR gas monitor for diverse applications

    QUANTITECH, a leading supplier of environmental monitoring instrumentation, has recently supplied EURO Environmental Services in Ireland with a transportable Gasmet FTIR multiparameter gas analyser which EURO Environmental's Managing Director Geoff Fitzpatrick says, “is proving invaluable in many varied applications across a broad selection of industries.” With headquarters in Drogheda in Ireland ...


    By Quantitech Ltd

  • Wastewater Treatment Plant Monitors Greenhouse Gas Emissions

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By Sigrist-Photometer AG

  • Navigating NSPS subpart Db for boilers: a case study

    Over the past year, Trinity assisted a chemical company with the permitting and installation of a new 220 MMBtu/hr package boiler. The new natural gas-fired boiler replaces coal-fired units that were installed in the 1940s. Navigating through the numerous, and at times conflicting, regulatory requirements applicable to such a unit has been challenging. With careful planning and implementation, ...


    By Trinity Consultants

  • Mobile Stationary Source Emissions Testing, Coming to a Facility Near You?

    Last week, Antea Group had the unique opportunity to perform a RATA (relative accuracy test audit) of the emissions from a thermal oxidizer at an ethanol production facility located in Minnesota using a state-of-the-art mobile testing laboratory. During this RATA audit, actual stack emissions levels (including NOx, SOx, CO2, CO, O2, flow rate, temperature, velocity and pressure) from the ...


    By Antea Group - USA

  • Case study - Catalytic products international replaces RTO with a VECTOR Catalytic Oxidizer

    A chemical processing facility recently installed a VECTOR Catalytic Oxidizer to replace a competitors Regenerative Thermal Oxidizer. The RTO was installed 5 years earlier and could not provide the reliability demanded by the client. The problem stemmed from a basic mis-application of the technology. As is very common, many air pollution control equipment manufactures have abandoned recuperative ...

  • Modest Growth for Air Pollution Control Market

    The Clean Air Act amendments of 1990 created a wave of optimism in the air pollution control (APC) business. The subsequent decade, however, resulted in backwash of disappointment for APC companies as the market for stationary source equipment declined from 1-4% per year from 1993-1998. Growth returned to the APC market, however, with 1999 and 2000 characterized as 'good' years by the Institute ...

  • Popular analysers are portable and rentable

    The MCERTS approved HORIBA PG-250 has been one of the most popular  instruments in Ashtead Technology’s fleet of rental equipment for a number of  years. Jay Neermul, the company’s Environmental Product Manager says “This  is because it is able to analyse CO, NO/NOx, SO2 and CO2 using standard  reference methods in a portable instrument that can be easily and ...


    By Ashtead Technology Ltd

  • Cementing the PC MACT

    On September 9, 2010, the U.S. EPA promulgated the final amendments to the National Emissions Standard for Hazardous Air Pollutants from Portland Cement Manufacturing Industry (40 CFR 63 Subpart LLL), also known as the PC MACT. EPA’s self-proclaimed “historic” rulemaking includes some important implications for cement manufacturers and other sources that may be subject to ...


    By Trinity Consultants

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you