chemical hazard neutralization system Articles

  • FAST-ACT Chemical hazard containment and neutralization system - Technical Report

    ABSTRACT FAST-ACT is a proprietary formulation of non-toxic high-performance specialty materials effective at neutralizing a wide range of toxic chemicals with the added capability to destroy chemical warfare agents. The FAST-ACT formulation is non-flammable, non-corrosive, and significantly reduces both liquid and vapor hazards. Since the dry powder neutralizes threats upon contact, on-site ...


    By Fast-ACT

  • Hazardous waste and not, Baioni-Dicatech system

    The identification, characterization and restoration of contaminated areas now represent a big environmental issue, both at European and national level. In the major industrialized countries the issue of contaminated land has come out in all its gravity in the late seventies when, against a widespread awakening of environmental consciousness, important pollutions events emerged. Consequently, in ...


    By Baioni Crushing Plants Spa

  • Chemicals used for pH Adjustment

    The Chemistry of Limestone Treatment: Limestone is an alkaline agent with the ability to neutralize, or partially neutralize strong acids. The neutralization process occurs when strong acids, in intimate contact with limestone chips, react with Calcium Carbonate (CaCO3, the primary constituent of limestone) to form water, carbon dioxide and calcium salts. The following depicts the neutralization ...


    By Digital Analysis Corp.

  • Chemicals used for pH Adjustment

    The most commonly used neutralization chemicals for acid or base neutralization are 98% Sulfuric acid and 50% Sodium hydroxide. In many cases these are very good choices, however, there are many considerations when selecting chemicals and these may not always be the best selection. The selection of the chemicals used for the neutralization of an acid or base is almost as important as the design ...


    By Digital Analysis Corp.

  • Chemical Spill Response Products & Procedures

    The current political and world climate has forced the Emergency Response Community to take a closer look at the number of potential hazards that they may be called upon to deal with. Of particular concerns are the response to terrorist and/or chemical incidents. Depending on the type of event, responders may be faced with a myriad of challenges and onsite dangers. With a chemical release, the ...


    By Fast-ACT

  • How to Handle Chemical Spills in Laboratories

    Chemical Spill Response Products & Procedures The current political and world climate has forced the Emergency Response Community to take a closer look at the number of potential hazards that they may be called upon to deal with. Of particular concerns are the response to terrorist and/or chemical incidents. Depending on the type of event, responders may be faced with a myriad of ...


    By Fast-ACT

  • How to prepare for a chemical attack

    It is a shocking and sad reality that chemical attacks are happening in the world today. The threats continue to rise as global tensions become greater. It can only be a good thing to be prepared if one was to occur in your area. The first step in preparation is to understand more about what chemical attacks are. What are chemical attacks? Chemical attacks involve using toxic ...


    By Fast-ACT

  • How To Handle Chemical Spills & Cleanups

    FAST-ACT is designed for liquid and vapor chemical releases, but the chemicals it attacks does not need to be limited to what we traditionally think of as a chemical spill. Toxic and noxious chemicals can come from a variety of sources such as waste water, decomposition, household chemicals, and animals. Since FAST-ACT can be applied to liquid spill or vapor release enabling Emergency Responders ...


    By Fast-ACT

  • Chemical Engineering Magazine: Odor Issues and Solutions for Wastewater Treatment

    Today, there has been a dramatic increase in the number of industrial operations that are located within or near small towns and even large cities. When local residents constantly smell these industrial processes – particularly from wastewater treatment — unhappy neighborhoods are generally the result. In addition, many wastewater facilities can no longer produce odors without facing ...


    By OMI Industries (OMI)

  • The Accidental Incident: Are you prepared in the event your company has a hazardous materials spill?

    Untitled Document Whenever a company stores hazardous substances and materials, there is always the potential for a spill. Taking precautions ...


    By Verisk 3E

  • Antifouling System Reduces Algal and Biological Growth on the In-Situ TROLL 9500 Water Quality Instrument

    Abstract New regulations regarding clean water have increased the need for long-term environmental monitoring. As water quality sensor technology improves and becomes more stable, the limiting factor in these projects becomes biological and non-biological fouling of instrumentation. Biofouling of environmental equipment increases site visits and maintenance, which elevate monitoring costs. ...


    By In-Situ, Inc.

  • Electrodeionization

    Electrodeionization (EDI) is a water treatment technology that has gone from an unproven and unknown commodity to one that has revolutionized the industry in the past 20 years. The technology was first introduced to the market in 1987 by Ionpure Technologies. EDI is used in small and large applications. Laboratories use EDI in systems as low as 360 gallons per day (gpd), while power plants, ...


    By Agape Water Solutions, Inc.

  • Cost reduction and operating results of RO-EDI

    Electrodeionization (EDI) uses electrical current, in lieu of acid and caustic chemicals, to regenerate cation and anion resin. Reverse osmosis/EDI systems are now widely used to replace conventional mixed-bed ion-exchange (IX) technology in a broad range of applications. Proven effective at high flowrates, EDI has in recent years been incorporated in water treatment plants around the world, ...


    By Agape Water Solutions, Inc.

  • Add polish to high purity water

    Electrodeionization (EDI) has recently gained widespread acceptance by water treatment companies and end users alike for almost all applications requiring high-purity water. EDI has proven to be a reliable, cost-effective solution for both end users and water treatment companies. End users purchasing capital equipment can eliminate on-site chemical regeneration. Water treatment companies selling ...


    By Agape Water Solutions, Inc.

  • 20th Annual Presidential Green Chemistry Challenge Awards highlight biomass- and waste-to-resource technologies

    On July 13, 2015, the U.S. Environmental Protection Agency (EPA) announced the winners of the 20th Annual Presidential Green Chemistry Challenge Awards (PGCCA) and honored them at a ceremony at the National Academy of Sciences in Washington, D.C. The PGCCAs were created in partnership with the American Chemical ...


    By Bergeson & Campbell, P.C.

  • TopAir`s Fume Hood

    TopAir, Statitech Israel’s flagship brand, manufactures a full line of superior cleanroom equipment including a reliable fume hood for neutralizing potential airborne chemical hazards in the laboratory. The fume hood mechanism offers maximum protection to laboratory staff working at a cleanroom table under the fume hood.   There are two basic types of fume hood. Many industries use a ...


    By TopAir Systems

  • Pettit national ice center cuts operating costs, perfects ice quality with Culligan Matrix Solutions

    Challenge Pettit National Ice Center, located in Milwaukee, Wl, is a U.S. Olympic Training Site and the only indoor sea-level ice oval in the U.S. The facility has helped many top speed skaters reach their Olympic medal dreams - while also providing a location for frequent national and international competitions. In fact, all of the U.S. speed skaters who have participated in the last ...


    By Culligan Water

  • Preparing Spill Response

    Whether a company stores, uses, or transports hazardous materials (hazmat), there is always the potential for a chemical spill. And beyond regulatory requirements that all employees are trained to handle chemical spills, it is also the responsibility of an owner to keep employees safe when doing so. Below are answers to some of the most commonly asked questions about emergency response spills, as ...


    By Verisk 3E

  • Shop Spill Cleanup, Mitigation for Waste Applications

    Spills and effluent water around a shop can cause an operation time and money. Taking simple steps to understand and apply best practices and the right products can mitigate the problematic effects and make any shop safer. If you work in a maintenance shop in the waste industry, you know that one thing is unavoidable—spills. With so many pieces of equipment and so many fluids around ...


    By Waste Advantage Magazine

  • Q&A: OMI’s Dr. Laura Haupert Discusses Eco-Friendly Odor Solutions for Landfills

    The waste management arena is continually challenged when it comes to fighting odors, which often become a major nuance for neighbors. Landfills all throughout the U.S. also have to contend with finding the right odor-abatement solutions that are both effective, and safe for employees and surrounding communities. In the following “Clearing the Air” Q&A, we speak with Dr. Laura ...


    By OMI Industries (OMI)

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you