chromatographic separation resin Articles

  • Non-woven electrostatic media for chromatographic separation of biological particles

    The filtration and separation of biological particles has been estimated as 40% of the cost in the manufacture of pharmaceuticals. Liquid chromatography that is the principal method for separating biological particles uses a permanent phase of ultrafine adsorbent particles such as porous silica or resin spheres with particle sizes down to about 1 micron. Speed and resolution are two competing ...


    By Argonide Corporation

  • Low-Chemical Solution for Juice Demineralization - Case Study

    PROJECT DETAILS LOCATION Vicenza, Italy CUSTOMER Italian Fruit Juice Company SOLUTION Juice Demineralization Plant TECHNOLOGY 4SMB Chromatography At an Italian organic foods plant, Fluence installed 4SMB chromatography for a low chemical, economical solution ...


    By Fluence Corporation

  • Introduction to Ion Exchange Part 1

    IMPURITIES IN WATERWater is often referred to as the 'universal solvent' as it will dissolve small amounts of everything it touches. Water collects or dissolves a variety of mineral salts, organic compounds and suspended solids as it flows over the earth's surface and through the ground. These impurities make water undesirable for use in many applications. It is, therefore, important to ...


  • Large Volume Splitless Injection Using an Unmodified Split/Splitless Inlet and GC-TOFMS for Pesticides and Brominated Flame Retardants

    Abstract Large volume splitless injection for gas chromatography typically requires a special injection port, for example, a programmable temperature vaporizer (PTV), but an alternative setup using concurrent solvent recondensation–large volume splitless injection (CSR-LVSI) and a split/splitless injection port has been reported. This technique was used here, both with and without ...


    By Restek Corporation

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you