coal-fired boiler operator Articles

  • Tips of installing the coal fired hot water boiler

    After buying an coal fired hot water boiler as being the heat power, the other thing the enterprise should think about is to install it. As all of those other boilers, the installation work likewise need the customer’s attention. Because the installation quality is directly connected ...


  • A novel approach for modelling of NOx emission reduction in a tangentially fired coal boiler

    In this research paper, predictive modelling of NOx emission of a 210 MW capacity pulverised coal–fired boiler and combustion parameter optimisation to reduce NOx emission in flue gas is proposed. The effects of oxygen concentration in flue gas, coal properties, coal flow, boiler load, air distribution scheme, flue gas outlet temperature and nozzle tilt were studied. The data collected from ...


    By Inderscience Publishers

  • Fire prevention measures in gas fired boiler’s operation

    Gas fired boiler is a kind of industrial boiler using natural or coal gas as fuel,its fuel is risky,especially,fire leakage in the operation is easy to ...


  • Difficult Complex Decisions For Coal-fired Power Plant Operators

    Changing fuel prices, government regulations and technology all combine to make decision making difficult for operators and developers of coal-fired power generation facilities around the world. Power plant designers in developing countries face new local environmental regulations plus additional requirements stipulated by lenders such as the World Bank. In the developed world, the regulations ...


    By The McIlvaine Company

  • Problems of catalytic boiler safety and their role in designing and operation of gas-fired boiler

    In the following paper, some problems of safety for catalytic boilers with fixed and fluidised beds are discussed. The reason is to protect the boiler from gas and fuel-air mixture explosion. For it the conditions excluding the transition from catalytic combustion to flame must be observed, and they are presented in the article for different combustible gases. A special attention has been paid to ...


    By Inderscience Publishers

  • Experience on coal reburn in a utility boiler

    Reburning is an in-furnace combustion modification technology for the reduction of NOx. By staging the introduction of the fuel, an environment is created where NOx generated by the combustion of the main fuel supply is subsequently consumed by the hydrocarbon radicals arising from the reburn fuel under reducing conditions. ENEL has retrofitted unit No. 4 of Vado ...


    By Inderscience Publishers

  • Coal fired power plant achieves ZLD for FGD wastewater

    The Facility Illinois’ City of Springfield’s Dallman Power Station’s three coal-fired units and soon to be installed fourth unit, are equipped with flue gas desulfurization (FGD) systems (scrubbers) to control sulfur dioxide (SO2) emissions. The Problem A sharp increase in boron concentration in the FGD wastewater required that The City ...

  • Evaluation of the optimum efficiency of fire tubes boilers

    Three-stage pirotubular boilers using gasoil C have been studied. Two boilers were connected in parallel. The data has been obtained by means of an analyser; its probe was connected at the exit of the boilers. The operation parameters considered were the injection pressure and the number of burners. As the emission of pollutants must be within the values prescribed by legislation, these are ...


    By Inderscience Publishers

  • ZG chain grate biomass fired boiler in Pakistan

    The new chain grate boiler system with chain grate stocker permits a wide range of biomass fuels including Bagasse, crop stalk, mustard stalk, cotton stalk, rice husk, coffee grounds, de-oiled bran , wood waste , Coconut shell ,roasted chaff, lignite, paper sludge, coal,corn cob, spent grain with high ash contents to be combusted in an efficient manner with the added advantage of automatic ...


  • How to prolong the service life of biomass fired boiler

    Because of the shortage of energy and environmental deterioration caused by the extensive use of fossil fuel,biomass fired boiler has played a more and more important role in the industrial boilers.Therefore,we need to focus on the following aspects of work to ensure its normal operation and prolong its service life: ...

  • EPA finalizes boiler NESHAP

    EPA published the final National Emission Standards for Hazardous Air Pollutants (NESHAP) for industrial, commercial, and institutional boilers and process heaters at both major and area sources of hazardous air pollutants (HAP) emissions. EPA developed separate rules for units at major sources of HAP emissions (greater than 10 tons per year [tpy] of any single HAP and/or greater than 25 tpy of ...


    By Trinity Consultants

  • Saving waste in the boiler house

    Burner technology has improved greatly in recent years. Older Burners had a series of cams and levers that were calibrated to provide specific amounts of air for a particular rate of firing. Being mechanical items, these wore and sometimes required calibration. They, therefore, had to be regularly serviced and calibrated. Generally, new burners use frequency controlled motors and cams to open air ...


    By EBE Engineering Ltd.

  • EPA issues final rules for boilers

    The U.S. Environmental Protection Agency (EPA) reports that more than 200,000 boilers, process heaters and incinerators will be impacted by a set of Clean Air Act regulations issued on February 21, 2011. Since EPA first proposed the ...


    By Bergeson & Campbell, P.C.

  • Controlling Stack Emissions in the Wood Products Industry & Wood Fired Boilers

    Electrostatic precipitation has been a reliable technology since the early 1900's. Originally developed to abate serious smoke nuisances, the manufacturers of zinc, copper, and lead quickly found electric gas cleaning a cost efficient way to recover valuable product carried out of the stacks from furnace operations. Today electrostatic precipitators are found mainly on large power plants, cement ...

  • Frequency Converter energy savings on Boilers

    Boilers and heaters account for a significant share of a plant's purchased fuel cost. Combustion air fans are necessary to provide enough combustion air to the boiler or heater's burner system. Louvers, inlet guide vanes or frequency converters control the amount of air allowed into a boiler. Configuring a combustion air fan to allow the proper amount of air into the burner can improve boiler ...


  • Monitoring flammable gas in boiler houses

    The most common fuels in use for space and water heating are Oil, Natural Gas and Liquid Petroleum Gas (LPG). By far the most popular, clean and cost effective solutions are utilising Natural Gas or LPG. The traditional safety measure derived from the time of oil fired boiler houses is the use of a fusible link placed above the each boiler. The fusible link is intended to melt if it becomes ...

  • Navigating NSPS subpart Db for boilers: a case study

    Over the past year, Trinity assisted a chemical company with the permitting and installation of a new 220 MMBtu/hr package boiler. The new natural gas-fired boiler replaces coal-fired units that were installed in the 1940s. Navigating through the numerous, and at times conflicting, regulatory requirements applicable to such a unit has been challenging. With careful planning and implementation, ...


    By Trinity Consultants

  • Proposed boiler MACT sets aggressive emission limits

    On June 4, 2010, U.S. EPA proposed National Emission Standards for Hazardous Air Pollutants (NESHAP) for industrial, commercial, and institutional boilers and process heaters at both major and area sources of hazardous air pollutants (HAP) emissions.  EPA proposed separate rules for units at major sources of HAP emissions (greater than 10 tons per year [tpy] of any single HAP and/or greater ...


    By Trinity Consultants

  • 10 ton CFB Power Plant Boiler

    This type of boilers is very popular in recent years. ...


    By ZGZhengzhou boiler

  • High Purity Boiler Water Production Using Municipal Wastewater at a Combined Cycle Gas-Fired Generating Station

    The recovery of wastewater for industrial uses presents many challenges for the design and operation of water treatment equipment. Since the term wastewater can be applied to a wide range of water sources from municipal sewage to storm runoff to industrial discharge water, the water characteristics may have great variability. As such, the equipment to treat wastewater must be robust and ...


    By Eco-Tec Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you