condensate meter Articles

  • Performance monitoring & troubleshooting with a new individual condenser tube circulating water flow and fouling (ClA/FF) meter - case study

    Introduction Midwest Generation Joliet Station in Illinois has two coal-fired units, Unit 7 and Unit 8. Roth 550 MW units are located on the Des Plaines River and have been in operation since 1963-1964. The circulating water system is a once-through system comprised of a bar rack, traveling screens, circulating water pumps and reversible condensers. The original condenser tubes on Unit ...


    By Intek, Inc.

  • Preventable Mistakes with Vortex Flow Meters

    Vortex flow meter technology is an ideal technology for many applications particularly saturated and supersaturated steam, volumetric water applications as well as flow energy management (natural gas, compressed air, steam, water) in facilities and large campuses. In some of these applications, vortex installations can be tricky and take flow expertise for the most successful installations. Kam ...


    By Sierra Instruments, Inc.

  • 1st Tech applications range case study

    Paper industry: roller, air compressor, after cooler, calender bowl, chemical scrubber, closed cooling system, condenser, cooling tower, gas cooler, heat exchanger, intercooler, filtrate tank, filtrate pipe, vacuum filter, vacuum pump, slush pump, lime pump, evaporimeter, digester, scrubber, flow box, squeezer, indirect cooler, absorption plant, gas steam room, steam ...


    By Mibo International Corp.

  • GEM provides fast payback for Italcables

    Metered tests carried out on Thermal Energy International’s GEM steam traps by Italcables, Italy’s largest producer of wire strands for pre-stressed concrete and post-tensioned structures, have shown steam savings of up to 30% compared to mechanical traps.  Now, Italcables has fitted GEM traps to its steam baths and kettle boiler used for ‘pickling’ and treating iron ...

  • Oil refinery vapour gas case study

    1.0 Evaluation of Refinery Gases Various refinery gases are generated in the process of oil refining. These vary, depending upon the type of crude oil being distilled, such as Reduced Crude distillation, or Naphtha cracker. For the purposes of this case study the description and range of refinery gases are those gases produced from refining Crude Oil and Reduced Crude only. Crude ...

  • Waste Fuel Case History

    The Customer The company engages in the design, manufacture, and sale of machinery for decomposing petroleum-based materials. The company uses microwave technology for recovering hydrocarbons and fossil fuels from sources, such as tires, oil shale, capped wells, coal, automotive shredded residue, municipal solid waste, shale deposits, and waste oil streams. The ...

  • 4.5 MWe Refuse Derived Fuel to Energy Plant Case Study

    This 4.5 MWe Biomass Power Plant is one of the turnkey products of Biomass Power. The plant has a capacity of 24 MW thermal and rated at 4.5 MWe producing 35,476MWh of green electricity per year, 100% of which is exported to the grid. The fuel used is segregated biomass from a commercial and industrial waste collection business. The fuel is produced by removing some of the recyclable material ...


    By Biomass Power Limited (BPL)

  • World`s largest air purifier produces gem stones

    How Clean Air Produces Jewelry Cleaner air has never been this rewarding. Well, let’s face it, clean air alone is its own reward - something everyone should try and make an effort and do their part. Daan Roosegaarde, a designer from Rotterdam, has taken this one large step farther by building the ...


    By Allerair Industries

  • Achieving

    Introduction The leak repair requirements, under Title VI Section 608 of the Clean Air Act Amendments of 1990, require that when an owner or operator of an appliance that normally contains a refrigerant charge of more than 50 pounds discovers that refrigerant is leaking at a rate that would exceed the applicable trigger rate during a 12-month period, the owner or operator must take corrective ...


  • Noise Measurement

    Definitions Threshold and criterion levels The threshold level is the A-weighted sound level at which a personal noise dosimeter begins to integrate noise into a measured exposure. For example, if the threshold level on a sound level meter is set at 80 decibels (dB), it will capture and integrate into the computation of dose all noise in the employee's hearing zone that equals or exceeds 80 dB. ...


  • Landfill Leachate Treatment by Forced Circulation Vacuum Evaporation - Athens (Ano Liossia Landfill)

    This report describes how treatment of landfill leachate by means of forced circulation vacuum evaporation provided: an environmental benefit from use of biogas as power supply a big saving in disposal cost due to waste volume reduction a return on investment of less than two years Introduction Solid Waste Management in Greece has been remarkably upgraded during the last ...

  • Textiles Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Detection of moisture in ammonia gas

    Problem Statement As technologies advance, so does the request for ultra high purity ammonia. Ultra high purity (UHP) ammonia is used in the semiconductor industries, production of flat panel displays, and a number of other applications. Due to this rising interest in UHP ammonia, manufacturers are having to battle ammonia’s most prominent and damaging impurity--moisture. For ...


    By CIC Photonics, Inc.

  • Continuous measurement of Process oxygen for Claus sulfur recovery unit (sru) start-ups and shut-downs case study

    During start-up and shut-down, any time a sulfur recovery unit (SRU) transitions from ambient temperature through fuel gas warm up to the introduction of acid gas, measurement of 02 stoichiometry is critical. Historically, operators have manually taken samples using a portable electrochemical type Os analyzer. While giving more or less satisfactory results, the requirement for more stringent ...

  • Common Treatment Technologies for Fuels in Soil, Sediment, and Sludge

    Common treatment technologies for fuels in soil, sediment, and sludge include biodegradation, incineration, SVE, and low temperature thermal desorption. Incineration is typically used when chlorinated SVOCs are also present with fuel, and not specified for fuel-only contaminated soil, sediment, or sludge. All types of biodegradation, both in situ or ex situ, can be used to remediate soils: ...

  • Hydroflo diaphragm pumps help reduce boiler corrosion and maintenance costs

    ABTCo, located in Alpena, Michigan, is a decorative wood paneling producer using three boilers to generate 7 MW of electricity – half the power needed in the plant plus steam for pulp processing. As in many boiler operations, the main enemy is corrosion, which can destroy system components and lead to boiler failure. Although internal boiler surfaces are protected by a film of magnetic ...


    By Aquflow

  • Area-Velocity Flowmeter Installations in Denmark - Case Study

    Area-Velocity Flow Meters are designed to monitor flow rates in partially filled pipes and open channels without flumes or weirs. A sealed ultrasonic sensor is mounted on the bottom of the pipe or channel and connected to electronics through a watertight cable. The sensor measures both level and velocity and when calibrated with the pipe diameter or channel dimensions, the Greyline AVFM ...


    By Greyline Instruments Inc.

  • Solvent Recovery System Keeps Presses Rolling at World`s Largest Gravure Printing Plant

    When QUAD/GRAPHICS Inc. entered the publication gravure printing market, it followed the axiom of Daniel Burnham, the 19th century architect and urban planner, to 'make no small plans.' In 1985, the Pewaukee, Wis.-based printing company purchased two 96-inch web, eight-color, high-speed presses and installed them at its new printing plant in Lomira, Wis., near Milwaukee. Conventional wisdom at ...


    By AMCEC Inc.

  • A Look at the Impact of Proposed Water Standard to Prevent Legionnaires` Disease

    From the standpoint of water treatment industry experts, failure to prevent legionellosis (or Legionnaires’ Disease) is the most significant water treatment problem today. Essentially every case of the disease is the result of exposure to inadequately managed building watersystems, and both utility and potable water systems can be the source of the hazard (i.e., Legionella bacteria). In ...


    By Phigenics, LLC

  • Controlling scale deposits in the pulp & paper industry

    The pulp and paper industry is one of the heaviest users of water within the North American industrial economy, requiring on average 54 cubic meters of water per metric ton of finished product.  As water is used in nearly every part of the manufacturing process, accumulation of scale is a phenomenon that can occur in all pulp and paper making processes. This occurs even with the purest water ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you