condensate monitoring Articles

  • Real Time TOC Analysis in Steam and Condensate

    Executive Summary Steam in petro/chemical plants could be contaminated with hydrocarbons (TOC = Total Organic Carbons) from various sources. In any case this is a sign for defects in the process, whether it they occur in the heat exchanger, the blow down vessel, the condensate recovery or other parts of the system. Conventional solutions to monitor such contaminations use TOC- ...


    By JCT Analysentechnik GmbH

  • Condenser performance monitoring, control and optimization

    Abstract During the past sixteen years, understanding of the condensation process within condensers has been advanced through the introduction of new monitoring and control instrumentation. Data gathered from a variety of condenser types employing these instruments have allowed comprehension of the condensation process to be advanced to the point where underperforming regions of tube ...


    By Intek, Inc.

  • Organics in boiler water condensate

    With the wide use of high efficiency boilers and current high-pressure boilers in industry today limiting condensate analysis to the more traditional parameters can result in very expensive repairs. Condensate return should be the highest quality least expensive water that most systems can generate. Boiler operators do not want to lose this or have it contaminated. Condensate return analysis has ...


    By LAR Process Analysers AG

  • Case study – condensate contamination

    Site: Natural Gas Wellhead Site (Colorado) Contaminant: BTEX (LNAPL/free product present) Soil Type: Well-sorted sand and gravel Injection Cost: $13,000 (material & labor): Size of Trenches: Approximately 5 feet by 55 feet No. of Trenches: 5 (4 at size above, 1 added in the field - ~5 feet by 21 feet Depth of Trench: ~7 feet below ground surface Goal: ...

  • Instrumentation, methods & analysis tools for comprehensive condenser testing, monitoring & troubleshooting

    Abstract Proper monitoring philosophy in combination with available, accurate and reliable instrumentation for comprehensive condenser performance testing, monitoring and troubleshooting is presented. Practical engineering guidance resulting from the use of advanced instrumentation with proven utility has contributed to the identification of new beneficial performance indicators. ...


    By Intek, Inc.

  • Notting hill - condensing boiler case study

    Customer: Notting Hill Housing Trust Location: Hammersmith Heating System: Worcester Bosch Condensing System Boiler Installed: 01/10 This is a large 6 Bedroom Victorian Terrace Town House, which was built over 100 years ago and is typical of thousands of similar houses in Suburban London. The ...


    By Vortex Energy Saver

  • Case Study - 6MW Non-Condensing Power Plant

    Lihir Island, Papua New Guinea – 2003 First Geothermal Power Station in PNG: Press Release, April 16, 2003 Lihir Gold Limited “Gold company Lihir Gold Limited is turning its vast geothermal resource into an opportunity. In April, the company started commissioning a 6MW geothermal power station, the first in Papua New Guinea to use natural geothermal ...

  • Performance monitoring & troubleshooting with a new individual condenser tube circulating water flow and fouling (ClA/FF) meter - case study

    Introduction Midwest Generation Joliet Station in Illinois has two coal-fired units, Unit 7 and Unit 8. Roth 550 MW units are located on the Des Plaines River and have been in operation since 1963-1964. The circulating water system is a once-through system comprised of a bar rack, traveling screens, circulating water pumps and reversible condensers. The original condenser tubes on Unit ...


    By Intek, Inc.

  • Unveiling root causes of chemistry and performance problems by putting condensers under a microscope

    Abstract The results obtained from Condenser Monitoring Systems installed at multiple operating units are presented. The Condenser Monitoring System is comprised of unique measurement instruments that eliminate the need to make several assumptions necessary to measure condenser performance for comparison with design predictions. These direct comparisons unveil root cause issues ...


    By Intek, Inc.

  • Texas refinery identifes the source of boiler contamination and restores production using on-line steam condensate analyzer

    Background A major refinery in Texas, USA, recently experienced steam condensate contamination and major fouling of a boiler resulting in damage that led to an unplanned shutdown. The financial impact of the damaged boiler, unscheduled maintenance and loss of production drove a review of current condensate monitoring techniques. The review panel concluded that current methods of ...


    By GE Analytical Instruments

  • GEM steam traps stop mechancial trap failure & reduce condensate return pressure by 51% at KNPC shuaiba refinery

    Keeping on top of the constant challenge of repairing and replacing thousands of mechanical steam traps is no longer a problem at KNPC’s Shauiba Refinery in Kuwait following the successful conversion of 1,750 mechanical traps to Thermal Energy International’s award winning GEM Venturi Orifice design.  In addition, KNPC, a subsidiary of the Kuwait Petroleum Association, has seen ...

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Emission Testing and Monitoring

    Presented in Track B4: EMISSION TESTING & MONITORING at EUEC 2011, January 31 Phoenix, Arizona B4.1  | Update on PM2.5 and Condensable Particulate Matter Emissions Measurement Methods Larry Hottenstein |  Partner, Environmental Resources Management Following the promulgation of the PM2.5 ...

  • Pollution monitoring in Cement Industry

    The rising use of waste based fuels in the cement industry, both for economic and Environmental objectives, combined with the strengthening of air emission regulations around the world is pushing many operators to face a wider list of pollutants to monitor this, with associated costs. The design of appropriate solutions meeting local regulation is the key to maximize the cost benefit of the fuel ...


    By Environnement S.A

  • Organics Monitoring: A Practical Guide

    Preventing product loss, lowering waste treatment costs, and reducing system maintenance and energy consumption through organics monitoring in the chemical, refining, food, and wastewater treatment industries. Summary Process water and steam condensate contamination includes organic, inorganic, and biological components. Sources of organic contamination include process ...


    By GE Analytical Instruments

  • Hydrocarbon in Water Monitors using Fluorescence

    Hydrocarbon in Water Monitors using Fluorescence are capable of detecting hydrocarbons as low as 5 Parts per Billion and as high as 10,000 Parts per Million depending on the application.  Because only the target hydrocarbons will fluoresce, these monitors have no significant affect due to water turbidity (rust, dirt, gas bubbles, soot, etc.).  Fluorescence monitors provide a measurement ...

  • Greenstars portable monitoring for CHP and flares

    Greenstar’s award-winning KTK landfill site in Kilcullen, Co. Kildare, is unusual in Ireland in that it has three gas engines feeding electricity to the grid and two flares. In Ireland, while flaring is common, engines are not. The flares are run in tandem with engines so that if an engine is ramped down for repair or service, the flare ramps up automatically. All are supplied by 122 ...


    By Geotech

  • Efficient monitoring of glucose level case study

    MonoScan provides an efficient monitoring of glucose level in as leading jam manufacturers. The manufacturing is based on grapes to produce jams, confiture and related products for the food industry. The company sought an ultrasonic level measurement solution that will improve monitoring over the glucose level in the storage tanks and reduce costs throughout the plant. The ...

  • In-situ continuous emissions monitoring & regulatory compliance

    As environmental scrutiny has risen and regulation has tightened in recent years, the importance of having accurate information on the environmental performance of your power plant has increased. After all, if you want to manage something, you need to be able to measure it. The analogy is obvious; you wouldn't start a diet without first investing in a set of scales. So it is with Continuous ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you