containment product Articles

  • Revolutionary advances in safer tube and pipe machinery can be a direct result of the evolutionary nature of product development.

    It’s remarkable how fast changes occur in devices we utilize in our everyday lives. Living in an era of seemingly boundless innovation, new products are introduced and then continuously refined by driving forces such as competition, regulation, improved technology, liability, labor, material costs, and consumer demand. Amazingly, many life-defining inventions can progress from a creative ...


    By Tri Tool Inc.

  • Confirming Natural Attenuation Processes at a Coastal Site - Case Study

    Past waste disposal practices at a California coastal site resulted in a groundwater plume containing CVOCs (mainly chlorinated ethenes [CEs] and 1,1-dichloroethane) migrating offshore towards a marine harbor. CVOCs are present in the sediment porewater adjacent to the shoreline, but concentrations decreased significantly between 2000 and 2015, and NA in the marine sediments was suspected. To ...


    By SIREM

  • Applications of a Portable Gas Spectrometer

    In the realm of natural gas processing, enterprises don’t always find it economical to send products back to the lab and wait for test results. Being able to perform on-the-spot, highly accurate compositional analysis with gas chromatography equipment can reduce operational costs and help companies determine on-the-spot accurate gas levels in a natural gas stream. ...


    By Envent Engineering Ltd

  • Oil Recycling - Case Study

    The problem: Waste oil recycling contributes very much to climate protection through (CO2) energy saving. Compared to the production of base oil the re-refining of waste oil uses 34 % less resources. In the sixties the German government was subsidising the re-refining of waste oil. Because of that the use of waste oil as a fuel was neglected. The used oil re-refining is the ...


    By Dirk European Holdings LTD

  • RTO upgrade sees significant benefits - Case Study

    A project this year to upgrade an existing RTO has been successfully completed in four areas: Increasing thermal efficiency by adding additional layers of ceramic honeycomb media into the RTO this has the benefits of energy reduction from lower gas consumption both during production & on standby. De-commissioning an old inefficient recuperative oxidiser which was attached to a single ...


    By AirProtekt Limited

  • From a 1m3 cubitainer to 50mm chips, using a two-shaft shredder? With SatrindTec, “Sí, es posible!”

    A Spanish manufacturer of HPDE cubitainers and containers based in Cataluña has chosen SatrindTech to implement its recycling line of defective cubitainers. The request received by our Sales Department was to replace an existing SatrindTech twin-shaft shredder, in use since the mid-1990s, to now be able to ensure a regular size of the shredded material. ...


    By SatrindTech Srl

  • Do you know the two most important words required to understand oil spill booming?

    Much has been written (incorrectly) about how to deploy boom in order to protect, deflect or contain oil. We have long promoted using math and science when deploying spill countermeasures not only because it works, but because it’s faster, safer, more effective and it saves time, money and impact. What we’ll focus on in this article is the where of ...


    By Elastec

  • Invention of the Tire Shredder

    The process of vulcanizing rubber was discovered by Charles Goodyear (yes, you read that right) in 1839, and the development of rubber tires followed not long after (Source: Continental Truck). From there, it didn’t take long for worn-out tires to start piling up, and finding good ways to ...


    By ECO Green Equipment

  • A history of chemically resistant membranes

    The use of polymeric membranes for filtration of non-aqueous solutions started around 1960 and has been developed significantly since then [1]. Today, non-aqueous membrane filtration applications in chemical and pharmaceutical processing account for more than 25% of the global total polymeric membrane market [2]. ...


    By Sterlitech Corporation

  • Corrosion In Perishables Containers

    The presence of corrosive gases inside containers used for transporting perishables can quickly cause chemical reactions within the metals, producing corrosion - even at very low concentrations (ppm). The main corrosive gases involved are acid ...


    By Bioconservacion SA

  • Cost Containment: Beyond the Obvious

    Utilities today can implement a number of different initiatives to help them contain costs and maximize profits. Some of those, such as switching to a more efficient fuel source if possible, can produce obvious results that are relatively easy to calculate. But there are other initiatives, though less obvious, that can produce significant results at the bottom line. One such cost-containment ...

  • Modelling and simulation of containment retention factor for can-type containment

    Severe accidents cause the failure of fission product barriers and allow the fission products to escape into the environment. The containment is the last barrier for fission products. Thus, containment spray system, heat removal system, recirculation filtration system, Containment Filtered Venting System (CFVS) and containment exhaust filtration system are installed in the containment to ...


    By Inderscience Publishers

  • EPS Food Containers Can be Recycled

    EPS food containers can be recycled. In our daily life, we can see vast majority of EPS food-service products are used in commercial districts. However, there is no collection of EPS for recycling, as EPS food containers are typically not “clean” enough to be recycled. Plus, the high costs of collecting, sorting, and transporting this big volume EPS make the ...


    By Harden Industries Ltd.

  • How To Avoid Penalties For Not Containing Spills

    "Chemical spills can cost your company millions of dollars not to mention the bad publicity that results from suffering a spill. Every business wants to avoid the possibility of an uncontained hazardous material spill if at all possible. To do this you need a spill containment system designed for the type of hazardous materials that your handle. Safe Drain ...

  • Contain Oil Vapor for Better Reliability

    In a boiler feed pump, an air breather is used to vent the enclosed air space on the bearing housings. With increasing heat and thermal expansion, oil vapors form in the bearing housings and migrate through the air vents. The vapor then condenses in the air filter media saturating the filter with oil. The air breather becomes ineffective, which affects mechanical seals and the overall ...


    By JLM Systems Ltd

  • Spill Containment, Industrial & Environmental Solutions

    ULTRA-EVER DRY is a superhydrophobic (water) and oleophobic (hydrocarbons) coating that will completely repel almost any liquid. Ultratech EverDry uses proprietary nanotechnology to coat an object and create a barrier of air on its surface. This barrier repels water, oil and other liquids unlike any coating seen before. Technical Information:  ...


    By Interstate Products Inc

  • Production Line Efficiency with Specialty Products

    Everyone should aim to have higher product line efficiency regardless of their trade. Competing with automation and ensuring you make the most per hour is vital for the stability and growth of business. It’s reasoning like this that specialty products are made the help speed up production. YBDCO has the ideal products that can help you with faster production, ...


    By Youngstown Barrel & Drum Co.

  • Exergy analysis of the process of wet-process phosphoric acid production with full utilisation of sulphur contained in the waste phosphogypsum

    The wet-process phosphoric acid is produced by decomposition of phosphate raw materials with sulphuric acid. This gives a large amount of waste product-phosphogypsum. The thermochemical decomposition of phosphogypsum gives a gas rich in SO2. This gas is processed to obtain sulphuric acid, which is fed back into phosphoric acid production. The aim of this paper is to perform exergy analysis of the ...


    By Inderscience Publishers

  • Smurfit-Stone Container Corporation - Hopewell, VA

    Smurfit-Stone Container Corporation is one of the world’s largest manufacturers of packaging products ranging from consumer goods, printed displays and container board. The Hopewell, Virginia facility is dedicated to providing linerboard for corrugated container end products. Project DescriptionHPD was chosen to replace the existing three evaporator trains that were currently in ...

  • Case study - PCB Containment - ICA of Jacksonville

    Location: Jacksonville, FL System Applied: JBT 303 Substrate / Area: PCB Containment, 38,000 sq.ft. Date Completed: November 2005 Quality Control: Dudley Primeaux II, Primeaux Associates, LLC Project Description The building was scheduled for demolition, but the existing slab was impacted with PCB. It was ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you