continuous emissions monitor Articles

  • Monitoring - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Emissions analyser helps manage power station

    A multiparameter emissions monitor at Thetford power station is being used to demonstrate to the Environment Agency that the plant is performing within the conditions of its environmental permit. However, the data from the analyser, which was supplied by Milton Keynes based Quantitech, also performs a vitally important role in helping to manage the plant. “Individual gas readings are ...


    By Quantitech Ltd

  • Gas Detection and Monitoring Systems

    In greenhouse applications, the accurate measurement of a number of environmental parameters such as carbon dioxide concentration, temperature, light intensity, water, humidity, pH and nutrient levels using sophisticated sensors is used to create a controlled environment for optimising plant growth rates while minimising energy usage. Carbon dioxide concentration is also one of the best ...


    By Edinburgh Sensors Ltd

  • Planning for a Gas Monitoring System

    Do you need a gas monitoring system? Then you already know which gases you want to monitor, you probably have an idea of measurement ranges and accuracy requirements, and perhaps you have a budget for the system. But which other aspects have to be considered, and how do you actually design the system? Whether it is about air quality monitoring, continuous emissions monitoring or process control, ...


    By Opsis AB

  • Understanding and Monitoring Hydrocarbons in Water

    Untitled Document 1. Introduction Oil contamination continues to be a very hot topic, due largely in part to recent catastrophic events with shipping ...


    By Arjay Engineering Ltd.

  • RSD technology for MBTA bus fleet emissions

    Exhaust emissions from transit buses have long been a concern for air quality officials. Agencies have been investing millions of dollars in advanced and clean fuel technologies to reduce emissions from their bus fleets. Generally, the only information available about the emission characteristics of these vehicles comes from expensive engine- and chassis-dynomometer tests. Relatively little is ...

  • Why monitor dust in the workplace?

    Almost any place of employment can present a potential threat to health and safety from airborne particulates and aerosols. It is important to note, however, that dust hazards are not necessarily visible to the human eye and that the finest particles can represent the greatest threat because of their ability to travel deepest into the lungs. Effective monitoring is therefore key to the ...


    By Ashtead Technology Ltd

  • Greenhouse Gas Emission Trends and Projections in Europe

    Untitled Document Abstract The actual and projected progress (by 2010) of the EU and candidate countries towards reaching their targets under the Kyoto ...

  • Planning for a Gas Monitoring System

    Do you need a gas monitoring system? Then you already know which gases you want to monitor, you probably have an idea of measurement ranges and accuracy requirements, and perhaps you have a budget for the system. But which other aspects have to be considered, and how do you actually design the system? ...


    By Opsis AB

  • FTIR becomes best option for multi-gas emissions

    Globally, the number of industrial processes and emissions being monitored with Gasmet’s FTIR multi-gas technology has increased enormously in recent years as process managers exploit the benefits of being able to monitor a wide range of gases simultaneously and with minimal maintenance and calibration requirements. Gasmet CEMS (continuous emissions monitoring systems) are used for ...


    By Gasmet Technologies Oy

  • Mercury Emissions From The Disposal of Fluorescent Lamps

    The Environmental Protection Agency (EPA) is making available to the public a study containing information relating to its Proposed Rule addressing the management of mercury-containing lamps under the Resource Conservation and Recovery Act Subtitle C hazardous waste management system published in the Federal Register on July 27, 1994, 59 FR 39288. The study consists of an electronic model and ...

  • HF Emission from Dubal`s Electrolysis Cell

    Abstract The overall goal for this paper is to gain better understanding of the environmental aspect of the aluminium smelting cell. It encompasses a study of the relative contributions of operational practices, duct flow, alumina feeding and ambient conditions to the overall HF generation and the different categories of emission distribution between the recycle system, the pot room roof and the ...


    By Boreal Laser Inc.

  • Gas turbine compliance emissions test case study

    CKwas retained by Lake Road Generating Company, LP (Lake Road) to conduct a compliance emissions test program on three combustion turbine and heat recovery steam generators (CT/HRSG). The purpose of this program is to demonstrate that emissions from the CT/HRSGs are within the emission limits specified in the operating permit issued by the Connecticut Department of Environmental Protection ...


    By CK Environmental, Inc.

  • Tekran instruments—monitoring around the world

    Tekran provides trace-level mercury analytical and monitoring technology for a variety of applications including laboratory-based sample analysis, continuous point-source emissions and ambient air monitoring. This article focuses on and highlights the results of an application of Tekran’s Ambient Air Mercury Speciation System. In contrast to most other heavy metals, mercury (Hg) and mercury ...

  • Proposed boiler MACT sets aggressive emission limits

    On June 4, 2010, U.S. EPA proposed National Emission Standards for Hazardous Air Pollutants (NESHAP) for industrial, commercial, and institutional boilers and process heaters at both major and area sources of hazardous air pollutants (HAP) emissions.  EPA proposed separate rules for units at major sources of HAP emissions (greater than 10 tons per year [tpy] of any single HAP and/or greater ...


    By Trinity Consultants

  • Application of the Emissions Trading Directive by EU Member States

    Member States shall report annually on the application of the Emissions Trading Directive, according to Article 21 of the Directive. The reporting obligation will allow the Commission to continuously follow the implementation of the Directive and provide information for the Commission's review report (under Article 30 of the Directive). This is particularly important for the first set of reports. ...

  • FTIR gas monitor for diverse applications

    QUANTITECH, a leading supplier of environmental monitoring instrumentation, has recently supplied EURO Environmental Services in Ireland with a transportable Gasmet FTIR multiparameter gas analyser which EURO Environmental's Managing Director Geoff Fitzpatrick says, “is proving invaluable in many varied applications across a broad selection of industries.” With headquarters in Drogheda in Ireland ...


    By Quantitech Ltd

  • Wireless monitoring for a safe indoor environment

    This article discusses the benefits of wireless technology for continously monitoring the indoor environment. In striving for the construction of energy efficient and cost-effective buildings, the imperative issue of the buildings Indoor Air Quality (IAQ) is often overlooked. This can often lead to a unhealthy indoor environment and even to conditions such as Sick Building Syndrome (SBS) or other ...


    By PPM Technology

  • The Flexibility & Versatility of a Portable Emissions Analyzer - Case study

    Issue Fixed CEMS (Continuous Emissions Monitors) Measure at One Location CEMS are fixed units that typically only measure from one sample location which is usually on a main centralized stack. This main stack is often fed by several separate emissions sources throughout the plant such as boilers, heaters, engines, ovens, and furnaces. If the CEM ...

  • The need for motorcycle emission control program and safety laws in Liberia

    Since the end of the civil war, the Liberians demand for a sustainable future and economic growth seem to be optimistic and promising in that many of them have embarked on a path to self sustainability by exploring new ideas and taking on opportunities that have the potential to provide some sort of income that tend to lift their self esteem. The introduction of motorcycles into the Liberian ...


    By IWA Publishing

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you