continuous emissions testing Articles

  • Emission Testing and Monitoring

    Presented in Track B4: EMISSION TESTING & MONITORING at EUEC 2011, January 31 Phoenix, Arizona B4.1  | Update on PM2.5 and Condensable Particulate Matter Emissions Measurement Methods Larry Hottenstein |  Partner, Environmental Resources Management Following the promulgation of the PM2.5 ...

  • Continuous Emissions Monitoring Equipment – Guidance & Selection

    There has never been such a wide range of analysers and systems available for continuous emissions monitoring as there is today. In the UK there are over 12 manufacturers and distributors offering CEMS (continuous emissions monitoring systems) using a variety of technologies including UV and IR absorption, FTIR, DOAS, chemiluminescence and photoacoustic spectroscopy (PAS). The majority of CEMS ...

  • In-situ continuous emissions monitoring & regulatory compliance

    As environmental scrutiny has risen and regulation has tightened in recent years, the importance of having accurate information on the environmental performance of your power plant has increased. After all, if you want to manage something, you need to be able to measure it. The analogy is obvious; you wouldn't start a diet without first investing in a set of scales. So it is with Continuous ...

  • X-Ray Fluorescence-Based Multi-Metal Continuous Emission Monitor

    ABSTRACT: Army demilitarization incinerators will need to comply with the Hazardous Waste Combustor National Emission Standard for Hazardous Air Pollutants that will regulate metals and metal compounds listed under the Clean Air Act Amendments. A large problem for these incinerator operations is limited knowledge of the type and quantity of emitted metals, so that compliance may be determined ...

  • Performance specification YY: Specifications and test procedures for Xray fluorescence based multi-metals continuous emission monitoring systems at stationary sources case study

    Performance Specification YY details the performance requirements for a multi-metals continuous emissions monitor that utilizes x-ray fluorescence (XRF) as an analytical technique. Each XRF based multi-metals CEMS must meet the criteria for accuracy, stability, and instrumental response laid out in this document. In addition, every XRF multimetals CEMS must meet the installation requirements in ...

  • Gas turbine compliance emissions test case study

    CKwas retained by Lake Road Generating Company, LP (Lake Road) to conduct a compliance emissions test program on three combustion turbine and heat recovery steam generators (CT/HRSG). The purpose of this program is to demonstrate that emissions from the CT/HRSGs are within the emission limits specified in the operating permit issued by the Connecticut Department of Environmental Protection ...


    By CK Environmental, Inc.

  • Mobile Stationary Source Emissions Testing, Coming to a Facility Near You?

    Last week, Antea Group had the unique opportunity to perform a RATA (relative accuracy test audit) of the emissions from a thermal oxidizer at an ethanol production facility located in Minnesota using a state-of-the-art mobile testing laboratory. During this RATA audit, actual stack emissions levels (including NOx, SOx, CO2, CO, O2, flow rate, temperature, velocity and pressure) from the ...


    By Antea Group - USA

  • Continous Emission Monitoring (CEMs)

    Presented in Track B1: CEMs at EUEC 2011,January 31 Phoenix, Arizona   B1.1  | Particulate CEM for wet FGD plant William Averdieck |  Managing ...

  • Reducing Odor and VOC Emissions

    The Montgomery County Regional Composting Facility (MCRCF) in Silver Spring, Maryland is designed to process 400 wet tons/day of lime amended biosolids from the Blue Plains Wastewater Treatment Plant (WWTP) in Washington, D.C. Recently, political pressures forced operations to cease at the MCRCF. Although the aerated static pile composting plant’s fate has not been completely decided, its owner, ...


    By BioCycle Magazine

  • A cure for Environmental Emissions case study

    Disposing of nearly 1 million pounds of medical waste a month is no easy task. The wet electrostatic precipitator, installed at Rochester, MN-based Mayo Clinic, seems to be just what the doctor ordered. While the medical waste incinerator at Mayo Clinic in Rochester, MN, consistently met state and federal emission requirements, facility leadership recognized that installing a wet electrostatic ...


    By Bionomic Industries Inc.

  • Minimizing Refrigerant Emissions in HVAC Systems

    Managing the operation and maintenance of a facility's air conditioning equipment has always been a major responsibility, as chillers often represent the single largest electrical load in a facility. Since the annual cost of operating chillers is a major ...


    By IHS Markit

  • Introduction of Automotive Testing Department

    Strongly linked with the automotive industry, the history of automotive testing business by HORIBA Group has developed itself along with innovative automotive technologies. Since the first emission measurement system developed in 1964 following the launch of automobile emission control, HORIBA Group has continued strengthening emission control and advancing the emission reduction technologies as ...


    By HORIBA Europe GmbH

  • Siemens analyzers provide the accuracy needed for critical engine emissions testing – Case Study

    Challenge A company in the Western USA provides industrial gas turbines for both on- and offshore electrical power generation. The company offers low-emissions products and was looking for an analyzer to use in their continuous emissions monitoring (CEM) system that could accurately and continuously monitor and verify the CO emissions from their turbine’s gas engines. ...

  • Solutions for Automotive Testing

    In recent years, the field of research, development and testing of vehicles has created a need for integrated testing systems which cover the entire vehicle including engine and driveline. These systems also need to be capable of being deployed globally in a supportive structure. As a means of responding to these market requirements, building on our strengths in vehicle emissions measurement ...


    By HORIBA Europe GmbH

  • RSD technology for MBTA bus fleet emissions

    Exhaust emissions from transit buses have long been a concern for air quality officials. Agencies have been investing millions of dollars in advanced and clean fuel technologies to reduce emissions from their bus fleets. Generally, the only information available about the emission characteristics of these vehicles comes from expensive engine- and chassis-dynomometer tests. Relatively little is ...

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By SIGRIST - PHOTOMETER AG

  • Modelling emissions of perfluorinated chemicals to the Danube River Basin

    The emissions of two perfluoroalkyl acids (PFAAs) into the Danube River Basin have been estimated in a test of four different hypotheses regarding the factors affecting those emissions. The results were used to simulate water concentrations for comparison with measured data. The researchers found that incorporating wastewater treatment information and wealth distribution alongside population data ...

  • Fast, simultaneous and continuous monitoring of NOx and NH3 in DeNOx applications

    In DeNOx systems using urea injection with ammonia (NH3) as a reducing agent, the flow rate and control of NH3 must be continuously adjusted and controlled to prevent excess NH3 emissions (slip), to reduce environmental impact and cost of reagents. To optimize this process, it is essential to use an emissions analysis system for simultaneous and continuous monitoring of NOx and NH3. For preparing ...


    By Environnement S.A

  • Proposed boiler MACT sets aggressive emission limits

    On June 4, 2010, U.S. EPA proposed National Emission Standards for Hazardous Air Pollutants (NESHAP) for industrial, commercial, and institutional boilers and process heaters at both major and area sources of hazardous air pollutants (HAP) emissions.  EPA proposed separate rules for units at major sources of HAP emissions (greater than 10 tons per year [tpy] of any single HAP and/or greater ...


    By Trinity Consultants

  • Can Composting BMPS Reduce Air Emissions?

    Imagine a scenario where all yard trimmings collected for recycling have to be received, processed and composted under the cover of a building. It would be tough for most yard trimmings composting facilities to survive the expense. Yet this situation could have occurred in Southern California. At one point, the South Coast ...


    By BioCycle Magazine

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you