continuous ground-gas monitor Articles

  • The latest ground Gas monitoring innovations

    The latest Ground Gas monitoring innovations   The traditional methodology for ground gas monitoring has been ‘spot monitoring’ – taking event readings at various set times to predict the sub surface gas regime on both on Brownfield and Landfill sites.     This methodology is in general current practice under both the EU Landfill Directive ...


    By Shawcity Limited

  • New White Paper on FTIR multigas analysis

    Quantitech has announced the publication of a free White Paper on the simultaneous measurement of multiple gases in a wide variety of applications using FTIR (Fourier Transform InfraRed) technology. With the ability to measure almost any gas, FTIR monitoring technology is employed in an enormous variety of applications including Continuous Emissions Monitoring, Stack Testing, Process Control, ...


    By Quantitech Ltd

  • Nitrogen Demand Increases for Semiconductor: How Safe Are You?

    As users demand ever-smaller smartphones and better televisions, semiconductor manufacturing plants are tasked with developing new products faster and using new materials. Key to the continued success of the semiconductor industry are inert gases, which include nitrogen and argon. When used safely, both nitrogen and argon play a number of important roles within the semiconductor ...

  • The productive environmental laboratory: BSK Labs boosts efficiency with Metrohm IC

    BSK Labs runs a number of environmental laboratories and service centers along the west coast of the US. A total of 70 employees – including microbiologists, chemists, lab technicians, and support staff – make sure that the 200 to 350 samples that come in every week are analyzed. BSK Labs specializes in potable water chemistry, ground water monitoring, storm water runoff, solid waste ...


    By Metrohm AG

  • Continuous monitoring of moisture present inside a process chamber

    Problem Statement Moisture inside a process chamber is a big silent killer during wafer production. When production yield goes down, it is hard to pinpoint the source of the problem. Most of the time wafers need to be sent to labs for analysis, while production is stopped. If the problem is related to a high level of moisture inside the reactor, there are several factors that can cause ...


    By CIC Photonics, Inc.

  • In-situ continuous emissions monitoring & regulatory compliance

    As environmental scrutiny has risen and regulation has tightened in recent years, the importance of having accurate information on the environmental performance of your power plant has increased. After all, if you want to manage something, you need to be able to measure it. The analogy is obvious; you wouldn't start a diet without first investing in a set of scales. So it is with Continuous ...

  • Continuous Mercury Monitoring Benefits Cement Plants

    Antti Heikkilä from Gasmet Technologies highlights the challenges faced by mercury monitoring in cement kilns, and explains how a new continuous mercury monitoring system addresses these issues and provides process operators with an opportunity to improve environmental performance and demonstrate compliance with forthcoming legislation. Background The production of cement ...


    By Gasmet Technologies Oy

  • Compliance to standards in continuous emissions monitoring case study

    Customer: Glass Manufacturer Application: Continuous Emissions Monitoring Service (CEMS) for Glass Manufacturing Background: A glass factory is required to ...


    By Ecotech Pty Ltd

  • Continuous biogas monitoring with AEMS in South Korea

    Application Biogas research projects Equipment AEMS biogas analyser Location South Korea Customer KEPCO Research Institute Requirement The customer ...


    By Geotech

  • Continuous AD monitoring for McCain`s CHP case study

    Application Anaerobic digestion Equipment AEMS Location Whittlesey, United Kingdom Customer McCain Foods Requirement McCain Foods corporate affairs director, Bill Bartlett said, “The Geotech static gas analyser is here to analyse gas quality as it is ...


    By Geotech

  • Hydrogen Sulfide Continuous Emission Monitoring of Odor Control Systems

    ABSTRACT This paper discusses the use of the Sycamore Continuous Emissions Monitor (CEM) for monitoring Hydrogen Sulfide Gas concentrations within odor control systems. The CEM is configurable as a single, two or three point system and can measure from 5 ppb to 2 PPM, 0.1 – 20 PPM, and 0 – 200 PPM and is designed for monitoring of scrubbers, carbon adsorbers, biofilters and biotrickling ...

  • Continuous on-line monitoring of dissolved oxygen in the activated sludge of a sewage treatment plant

    Dissolved oxygen is traditionally measured using a Clark cell, which relies upon a gas-permeable membrane for its opera-tion. Such sensors are subject to fouling with subsequent loss of accuracy, making frequent maintenance and calibration necessary. The objective of this development was to take advantage of specific properties of microelectrode arrays, such as low flow-dependence, insensitivity ...


  • Fast, simultaneous and continuous monitoring of NOx and NH3 in DeNOx applications

    In DeNOx systems using urea injection with ammonia (NH3) as a reducing agent, the flow rate and control of NH3 must be continuously adjusted and controlled to prevent excess NH3 emissions (slip), to reduce environmental impact and cost of reagents. To optimize this process, it is essential to use an emissions analysis system for simultaneous and continuous monitoring of NOx and NH3. For preparing ...


    By Environnement S.A

  • Veolia EAU - Continuous monitoring of odor and target gas emissions at a WWTP, with the RQ Box solution case study

    The site Wastewater treatment plant Aquapôle, located in Isère, France Operated by Société Dauphinoise d’Assainissement (SDA) Capacity of 500 000 population equivalent ISO 14001 approach Challenges To define a zero point for the odor footprint of the site in order to ...


    By Alpha MOS Environment

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Biofuels Gas Monitoring

    The Customer The Company is one of the world’s leading developers and producers of advanced fuels and green chemicals. The Process The Company uses a gasification process that breaks down wood chips, waste and other feedstock using plasma technology. The process produces a uniform synthetic gas (syngas) that is used to power their turbine engines. ...

  • Gas Detection and Monitoring Systems

    In greenhouse applications, the accurate measurement of a number of environmental parameters such as carbon dioxide concentration, temperature, light intensity, water, humidity, pH and nutrient levels using sophisticated sensors is used to create a controlled environment for optimising plant growth rates while minimising energy usage. Carbon dioxide concentration is also one of the best ...


    By Edinburgh Instruments Ltd

  • Field Method Comparison between Passive Air Samplers and Continuous Monitors for VOCs and NO2 in El Paso, Texas

    This study evaluates the performance of Model 3300 Ogawa Passive Nitrogen Dioxide (NO2) Samplers and 3M 3520 Organic Vapor Monitors (OVMs) by comparing integrated passive sampling concentrations to averaged hourly NO2 and volatile organic compound (VOC) measurements at two sites in El Paso, TX. Sampling periods were three time intervals (3-day weekend, 4-day weekday, and 7-day weekly) for three ...


    By Ogawa & Company, USA, Inc.

  • Bioremediation/natural attenuation continues after ISCO treatment

    Scientists and engineers from the private sector and EPA are evaluating the potential for in situ bioremediation and/or natural attenuation to successfully treat residual soil and ground-water contamination after source-area in situ chemical oxidation (ISCO) treatment. The studies were prompted by concerns that the two treatment technologies may be incompatible due to detrimental impacts on ...

  • Monitoring flammable gas in boiler houses

    The most common fuels in use for space and water heating are Oil, Natural Gas and Liquid Petroleum Gas (LPG). By far the most popular, clean and cost effective solutions are utilising Natural Gas or LPG. The traditional safety measure derived from the time of oil fired boiler houses is the use of a fusible link placed above the each boiler. The fusible link is intended to melt if it becomes ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you