corrosion control coating Articles

  • Protective Coatings

    Coatings An industrial coatings is a paint or coating defined by its protective, rather than its aesthetic ...


    By Ultimate Linings

  • Impact of Corrosion on Electronic Equipment

    Corrosion is the destruction of metals through reaction with compounds in their environment. It is a natural process because compounds such as oxides, sulphides and chlorides are formed and these are stabler than pure metals. Electronic circuits and components are omnipresent in our environment. Until recently, the thousands of soldered joints that an electronic circuit contains were ...


    By Bioconservacion SA

  • Coil Coating Case History

    The Customer The Company manufactures metal roofing and gutter systems for the commercial and residential housing industry. The Process Bare coils of recycled steel and aluminum are uncoiled from a roll. The metal is chemically cleaned, treated and rinsed to prepare the surface for optimum coating adhesion and corrosion protection. The coil then enters a ...

  • Corrosive free compost facility for Waste Options Nantucket

    Veldeman’s daughter company, Universal Fabric Structures was appointed by Nantucket Waste Options to construct their aeration and biofilter structures. More then 5.500m² of TFS structures in a custom layout meet the island wind loads and provide a corrosive free environment while solving waste disposal on the island. The biofilter will store the compost and odor control media for 2-3 years ...


    By Veldeman Structure Solutions

  • Case study - Corrosion protection in a pulp and paper industry

    It is widely accepted that corrosion has an important economic impact at an industrial scale. As an example, results of a study carried out in the US showed that the total annual estimated direct cost of corrosion in the country was $276 billion, which was approximately 3.1% of the nation’s Gross Domestic Product (GDP). Thus, within the last few decades, an important effort has been made to ...


    By Bioconservacion SA

  • Humid, corrosive and malodorous waste gases - Case Study

    Example: Production of bio-ethanol Similar tasks: Dryers, Fibre board industry The production of bio-ethanol - fermentation, distillation, pelleting and drying - generates odorous and humid waste gas. Upstream lamellar demisters reduce both drop formation - causing lower VOC destruction efficiency - and solid matters. The regenerative thermal oxidiser (RTO) ...

  • Phosphate Pre-Treatment of Steel: Always Powder Coating

     Always Powder Coating have replaced the conventional iron phosphate pre-treatment system with an organic process that operates at room temperature. The savings from reduced energy, labour and waste disposal costs amount to $60,000 per annum. Background Always Powder Coating (APC) operates a powder coating facility in Melbourne's eastern suburbs and specialises in ...


  • Combating Corrosion - Committee G01 Standards Fight Nature’s Destructive Tendencies

    The evening news may leave many of us feeling war-weary, but one ASTM International technical committee has been successful in conflict of a different sort. It’s a commonplace but epic struggle between the natural and civilized worlds — the fight against metal corrosion. For the past half-century, the weapon of choice of ASTM Committee ...


    By ASTM International

  • M-Coating – drain & sewer spraylining the economical solution to manhole shaft renovation

    M-Coating – Procedure for renovating a manhole shaft using ERGELIT Kombina KS M-Coating is a new, innovative renovation technique for both round and rectangular drainage shafts from 500mm to 1200mm. It is based on over 15 years of the Hermes company’s experience. Using this centrifuge spray technique, walls of shafts up to 10 metres deep can be coated to a realistic thickness. ...


    By HERMES Technologie Ltd.

  • Steel coating mill saves $450k. with fluid purification program

    The Problem: A leading manufacturer of electro-galvanized and aluminized steel coil products, used as body panels in the automotive industry, was experiencing quality defect issues due to residual surface oil left on the parts after cleaning operation. In order to meet the surface finish specifications of the finished sheet, the mill requires all incoming steel coil stock to be pickled and oiled ...

  • Inhibition effect of phosphorus-based chemicals on corrosion of carbon steel in secondary-treated municipal wastewater

    Secondary-treated municipal wastewater (MWW) could supply a viable alternative water resource for cooling water systems. Inorganic salts in the concentrated cooling water pose a great challenge to corrosion control chemicals. In this study, the inhibition effect of 1-hydroxy ethylidene-1,1-diphosphonic acid (HEDP), trimethylene phosphonic acid (ATMP) and 2-phosphonobutane-1,2,4-tricarboxylic ...


    By IWA Publishing

  • Air Pollution Control: Ready for the 21st Century

    The textile industry is plagued by air pollution problems which must be resolved. In particular, smoke and odor arising in the process require abatement. Air pollution control technology is available today which will serve the textile industry well into the 21st century. The nature of the problem The major air pollution problem in the textile industry occurs during the finishing stages, ...


  • Case History - Air Pollution Control in the Textile Industry: a Technology for the 21st Century

    The textile industry is plagued by air pollution problems which must be resolved. In particular, smoke and odor arising in the process require abatement. Air pollution control technology is available today which will serve the textile industry well into the 21st century. The nature of the problem The major air pollution problem in the textile industry occurs during the finishing stages, ...


  • Chemical Industry: HCL System Exceeds Current Regulations Emission control meets requirements while recovering by-product for sale Case Study

    Chemron manufactures high-quality specialty chemicals and surfactants for personal care products, industrial, institutional, oil field, mining, coatings, lubricants and water treatment. Some of the operations result in the creation of hydrochloric acid with high variable rates. As expressed by Bill Frost, of Chemron: “Chemron maintains a strong environmental commitment, which views ...


    By CR Clean Air Group, LLC

  • Textile Industry: Air Pollution Control Through Wet Scrubbers, High Energy Venturi Scrubbers, Packed Bed Scrubbers and Other Technologies

    Wet Scrubbers, High Energy Venturi Scrubbers, Packed Bed Scrubbers are an excellent solution for air pollution in the textile industry. The textile industry is plagued by air pollution problems which must be resolved. In particular, smoke and odor arising in the process require abatement. Air pollution control technology is available today which will serve the textile industry well ...


    By CR Clean Air Group, LLC

  • Engelhard Corporation (formerly Mearl Corp.) - pigment plant, Crisafulli automated flump system-case study

    Customer: Engelhard Corporation (formerly Mearl Corp.) Contact: Paul Ellington. Type of Facility: Pigment plant. Location: North Charleston, SC. Date of install: 1996 February 1996. Mearl Corporation owns and operates an Automated FLUMP™ System manufactured by SRS ...


    By SRS Crisafulli, Inc.

  • The hidden threat

    Many decisions that are made at the design stage of engineering can have a major impact on safety and cost during the operational stages. This is especially true of pipe supports. Corrosion under pipe supports (CUPS) is a growing problem and a particular threat to pipework integrity, as Laza Krstin, Principal Consultant at ABB Consulting, explains. For many operating companies, extending the ...


    By Energy Institute (EI)

  • The way to Cease Roofing Leaking

     Roofing leakages can happen to acquire a quantity of factors. These people usually start out smaller than average grow over amount of in time so that you can larger difficulties. Nevertheless, a good tiny roofing spill could cause main injury to your home. Besides building wet spot locations by yourself accomplished ceilings, best leaking might lead to mold and mildew growth in addition to ...


    By Ultimate Linings

  • Cost effective ultrasonic level measurement of Sulfuric acid case study

    Cost effective level measurement solution provided by MicroScan in one of Luxembourg Industries' Sulfuric acid tank. Luxembourg Industries, located in Israel, manufacture diverse list of products to customers in the agricultural, biotechnology, chemical, pharmaceutical and other industries. Among their products are branded crop protection products, diverse crop protection chemicals, industrial ...

  • Fly Ash Concrete design for Chicago’s 100-Year road structure case study

    After years of heavy use, Wacker Drive, a major two-level viaduct in downtown Chicago, Illinois needed to be rebuilt. The Chicago Department of Transportation (CDOT) set ambitious goals for the $200 million concrete structure because of its central location and importance to downtown traffic flow. The end result is a more durable roadway with a service life of 75 to 100 years. Originally built ...


    By Headwaters, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you