corrosion protection coating Articles

  • Protective Coatings

    Coatings An industrial coatings is a paint or coating defined by its protective, rather than its aesthetic ...


    By Ultimate Linings

  • Ultimate Linings Best| Industrial Coatings| Protective Coatings

    Industrial coatings are generally used to diminish the effects of corrosion thus preventing the metal from being tarnished or damaged. Industrial protective coating enhances the finesse of the metal or material which in turn improves the quality. The ...


    By Ultimate Linings

  • Case study - Corrosion protection in a pulp and paper industry

    It is widely accepted that corrosion has an important economic impact at an industrial scale. As an example, results of a study carried out in the US showed that the total annual estimated direct cost of corrosion in the country was $276 billion, which was approximately 3.1% of the nation’s Gross Domestic Product (GDP). Thus, within the last few decades, an important effort has been made to ...


    By Bioconservacion SA

  • Corrosion protection with synergistic LBL/Ormosil nanostructured thin films

    Stratified systems comprising an inhibitor-doped layer-by-layer (LBL) clay-polyelectrolyte overcoated with a dense organically-modified silicate (Ormosil) are investigated as corrosion protectors for aluminium. As separate coatings, neither the LBL nor Ormosil films were found to provide adequate corrosion protection of the underlying metal. A combination of the two coating methods was found to ...


    By Inderscience Publishers

  • Synthesis and characterisation of nano silica-based coatings for protection of antique articles

    Antique articles are endangered by environmental effects such as humidity, UV and variation of temperature. Improved physical surface resistance is in an increasing demand in protection of cultural heritage. One possible way is their protection by suitable hydrophobic coatings. In this work, the experimentation of protective treatments on the soda glass, mud brick and copper, characteristic ...


    By Inderscience Publishers

  • Coil Coating Case History

    The Customer The Company manufactures metal roofing and gutter systems for the commercial and residential housing industry. The Process Bare coils of recycled steel and aluminum are uncoiled from a roll. The metal is chemically cleaned, treated and rinsed to prepare the surface for optimum coating adhesion and corrosion protection. The coil then enters a ...

  • Humid, corrosive and malodorous waste gases - Case Study

    Example: Production of bio-ethanol Similar tasks: Dryers, Fibre board industry The production of bio-ethanol - fermentation, distillation, pelleting and drying - generates odorous and humid waste gas. Upstream lamellar demisters reduce both drop formation - causing lower VOC destruction efficiency - and solid matters. The regenerative thermal oxidiser (RTO) ...

  • BTC coatings for trouble-free Boiler Operation

    In April 2014, the CastoLab® Division of Eutectic Canada performed an on-site coating contract for a Steel Mill. The work was performed on a critical section of the Fume Extraction Ducting: a series of water cooled tubes which remove heat from the exhaust fumes exiting the drop box. Conveyed within the ducting is hot ash debris which is corrosive and very abrasive. In this particular job, the ...


    By Castolin Eutectic

  • Maximize the coating life-cycle in severe wastewater environments

    In 2005, the American Society of Civil Engineers awarded a grade of D- to the nation’s wastewater systems based largely on the deterioration of sewage collection systems. That same year, the Bossier City Public Utilities Department in Louisiana restored a 5,000 square foot lift station using a 100 percent solids epoxy mortar system specifically designed to protect concrete in severe wastewater ...


    By Tnemec Company, Inc.

  • Coating of Automotive Components: Trico Pty Ltd

     Trico Pty Ltd has implemented two major cleaner production initiatives at its production facility. The replacement of electrostatic spray guns with plastic electrostatic rotary bells in its coating operations has significantly reduced reject rates and resulted in annual savings of $59,000 per annum. The replacement of a conventional hot caustic paint stripping process with a sand furnace ...


  • Combating Corrosion - Committee G01 Standards Fight Nature’s Destructive Tendencies

    The evening news may leave many of us feeling war-weary, but one ASTM International technical committee has been successful in conflict of a different sort. It’s a commonplace but epic struggle between the natural and civilized worlds — the fight against metal corrosion. For the past half-century, the weapon of choice of ASTM Committee ...


    By ASTM International

  • ERGELIT tape - impact protection for pipes

    The ERGELIT tape – a safe protection for steel, cast iron, cement and plastic pipes! Processing: Put the tape into water, surplus water express and put the tape around the piping immediately. Render the withdrawing ERGELIT mortar. A further subsequent treatment is not necessary any longer. After approx. 1 hour a sufficient strength is achieved. Due to the ...


    By HERMES Technologie Ltd.

  • M-Coating – drain & sewer spraylining the economical solution to manhole shaft renovation

    M-Coating – Procedure for renovating a manhole shaft using ERGELIT Kombina KS M-Coating is a new, innovative renovation technique for both round and rectangular drainage shafts from 500mm to 1200mm. It is based on over 15 years of the Hermes company’s experience. Using this centrifuge spray technique, walls of shafts up to 10 metres deep can be coated to a realistic thickness. ...


    By HERMES Technologie Ltd.

  • Severe wastewater testing program for rapid evaluation of coatings and linings

    High-performance protective coatings are often failing in the severe headspace environments of domestic wastewater collection and treatment systems. These failures are attributed to many factors including low permeability properties to resist H2S and other corrosive gases present within this environment. Although the chemical and physical properties of coating systems can be determined in the ...


    By Tnemec Company, Inc.

  • Inhibition effect of phosphorus-based chemicals on corrosion of carbon steel in secondary-treated municipal wastewater

    Secondary-treated municipal wastewater (MWW) could supply a viable alternative water resource for cooling water systems. Inorganic salts in the concentrated cooling water pose a great challenge to corrosion control chemicals. In this study, the inhibition effect of 1-hydroxy ethylidene-1,1-diphosphonic acid (HEDP), trimethylene phosphonic acid (ATMP) and 2-phosphonobutane-1,2,4-tricarboxylic ...


    By IWA Publishing

  • Chromium Phosphate Market Analysis By Application (Architectural Coatings) is Expected to Reach USD 96.65 Million by 2020

    The global market for Chromium Phosphate is expected to reach USD 96.65 million by 2020, according to a new study by Grand View Research, Inc. Key application markets for chromium phosphate include architectural coatings, corrosion inhibitor coatings, medical applications, and others such as catalyst applications. Strong demand from architectural coatings and corrosion inhibitor coatings are ...


  • Spill Containment, Industrial & Environmental Solutions

    ULTRA-EVER DRY is a superhydrophobic (water) and oleophobic (hydrocarbons) coating that will completely repel almost any liquid. Ultratech EverDry uses proprietary nanotechnology to coat an object and create a barrier of air on its surface. This barrier repels water, oil and other liquids unlike any coating seen before. Technical Information:  ...


    By Interstate Products Inc

  • Case Study: 48 Hour Tank Lining Repair

    GUEST BLOG: 48-hour tank lining corrosion repair, thanks to SPI’s fast curing Polyshield HT-100F UB In this post, we focus on a tank lining corrosion repair that’s recently been completed by our 2015 Global Distributor of the Year, SPI Performance Coatings Ltd, of Wiltshire UK. This particular project involved a ...

  • Two stainless steel rotomite applications - dredging caustic and abrasive materials in South Korea and Venezuela

    Customer: Zinc mining & processing facility, South Korea. Problem: How  to remove 200,000m3 of 325 mesh goethite (pH 2.2 - 2.5 range; sulfuric acid) from a lined pond with dimensions of 120m x 253m. Since the material had settled and was resting on the pond bottom, dredging was selected as the appropriate removal method. No standard acid-resistant dredge was in ...


    By SRS Crisafulli, Inc.

  • The Evans high performance mini catalog

    Evans Designed Coolant Pumps What makes an Evans coolant pump different? Increased coolant flow. All Evans coolant pumps use either an Evans designed casting or an OEM housing specially engineered by Evans to include ball-roller bearing, ceramic seals, plugged weep-holes, air bleeds and plugged bypasses. The Evans EP Performance Series coolant pumps are designed for serious competition and ...


    By Evans Cooling Systems, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you