corrosion protection enclosure Articles

  • Six Factors to Consider Prior to Choosing an Electronic Enclosure

    Choosing the right enclosure maybe as important as selecting the right product. An electronic enclosure, also known as housing, helps protect the circuit board allowing it to function properly. Elements (e.g. water, wind, dust, dirt, heat, cold, humidity, and chemicals) in the surrounding environment could damage or deteriorate the product. For example, large temperature variations between the ...

  • Advantages of Corrosion Resistant Lighting in Offshore Helidecks

    Advantages of Corrosion Resistant Lighting in Offshore Helidecks Corrosion resistant lighting must be installed in offshore helidecks due to the extreme nature of the hazardous location. The use of such luminaries can extend the lifespan of the location’s lighting system and provide safety for aircraft pilots and workers on the site. ...


    By Larson Electronics LLC

  • Selecting and Placing Gas Detectors for Maximum Application Protection

    Many industrial processes involve dangerous gases and vapors: flammable, toxic, or both. With the different sensing technologies available, and the wide range of industrial applications that exist, selecting the best sensor and locating them properly for the job at hand can be a challenge. To ensure a high level of safety, know the latest sensing technologies, which technology is best for the ...

  • Human Error Threatens Safety in Hazardous Areas

    The top 5 problems identified in hazardous areas are Poor or no maintenance on flameproof (Ex d) enclosures. Due to corrosion—especially when equipment is installed outdoors—the Ex d protection is gone 2-3 years after installation. Incorrectly installed Ex d cable glands. Even if the combination of cable and gland is chosen correctly, the instructions on how to ...


    By Mettler - Toledo Int. Inc

  • Detecting Gases: What You Can`t Smell Can Hurt You

    Walking through a drill-site area, a worker smells rotten eggs and stops tor a minute or two to assess where a gas leak might exist. Rubbing his itchv eves as he investigates further, he notices that he no longer smells the tell¬tale hydrogen sulphide odour. He does not realize that the gas has deadened his olfactory senses and unless he leaves the area within seconds, he could lose ...

  • Skimming Oily Wastewater

    As large generators of oily wastewater tighten effluent controls, the U.S. Environmental Protection Agency (EPA) is targeting smaller generators. Some of the firms receiving their attention are smaller manufacturing plants, automotive garages, mobile equipment service shops and truck farms. Many of these firms do not have access to a sanitary sewer system that will accept oily wastewater. Because ...


    By Abanaki Corporation

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you