data acquisition Articles
-
Design of an advanced intelligent instrument with waveform recognition based on the ITMS platform
Searching for similar behaviours in previous data plays a key role in fusion research, but it can be quite challenging to implement from a practical point of view. This paper describes the design of an intelligent measurement instrument that uses Similar Waveform Recognition Systems (SWRS) to extract knowledge from the signals it acquires. The system is perceived as an ethernet measurement ...
-
Brake test testbed - Case Study
Introduction The customer, a Chinese vehicle manufacturer, is in the process of developing a new type of vehicle. They want to make some tests for their new brake system in the brake test bed. They want to measure the brake line pressure values of four wheels when they brake at different speeds. Measurement setup DATA ACQUISITION SYSTEM DEWE-43A data acquisition system SENSORS ...
By DEWESoft
-
Choosing the correct Data Acquisition step for GPR
efore GPR surveying we have to set step of acquisition in Synchro program settings: We got different GPR profiles with different values of Step of acquisition. See the results below: Pipe3.sgpr GPR profile: Step of acquisition is 26,03 mm. Initial proportionality: one pixel is equal to one sample Pipe2.sgpr GPR profile: Step of acquisition is 156,18 mm. Initial proportionality: one ...
-
Aspen Collaborative Experiment - Case study
The demonstration project was conducted at the Garner Valley Downhole Array, Southern California. The experiment had over 100 channels of data at 200 sps streaming via wire and wireless comm. links into the Data Center where the Antelope data acquisition system ...
-
Autonomous data acquisition system for Paks NPP process noise signals
A prototype of a new concept noise diagnostics data acquisition system has been developed recently to renew the aged present system. This new system is capable of collecting the whole available noise signal set simultaneously. Signal plugging and data acquisition are performed by autonomous systems (installed at each reactor unit) that are controlled through the standard plant network from a ...
-
Instrumentation for a Weigh In Motion System Using Pavement Strain
A line of vertical strain transducers installed at a depth of 500 mm in a dense sand subgrade across one wheel path of the left hand lane of a busy highway was used to measure vehicle weights. The strain transducers, the custom-made LVDTs they incorporate, the method of installation, and the data acquisition system are ...
-
Data Logger vs DAQ
Key Differences Between Data Logging and Data Acquisition What is the difference between a Data Logger vs DAQ System? A data logger is a type of data acquisition system, but a data acquisition system is not necessarily a datalogger. There are several key functional differences in how the market understands these two classes of instruments. While the differences between these two types of ...
-
Method for irrigation scheduling based on soil moisture data acquisition
The water requirements of crops are dependent on evapotranspiration (ET), soil chemistry, and the crop’s maximum allowable depletion (MAD). Direct measurements of root zone soil moisture, water application along with published ET values and soil textures, can be used in a soil water balance model that can significantly optimize irrigation efficiency. Over the past five years, advancements in ...
-
Development of a Combination Inclinometer-Deflectometer and ADAAS
A newly developed transverse deformation gage, called the combination inclinometer-deflectometer, and special features of its automated data acquisition and analysis system (ADAAS) are described. The hybrid, two-in-one instrument and the ADAAS contribute to the enhancement of accuracy, reliability, and precision of ground movement ...
-
All New Datalogic 3000 Data Collection Platform Offers Robust Communication, Processing
Working hard to help our customers efficiently meet their growing data acquisition, management and control demands, we are proud to introduce the Stevens DL3000 (Stevens DataLogic 3000) data collection platform. The Steven’s DL3000 is a powerful, versatile and scalable data logger. Adopting state-of-the-art data processing technology, the DL3000 is ready to meet your data acquisition, processing, ...
-
Improving field testing
Abstract This application note shows how Dewesoft products provide an effective solution for multi-physics validation of farm tractors. The mobile measurement instruments and easy-to-setup software are used for online field monitoring and multi-physics data acquisition with more than 200 channels. Introduction The client, a large tractor manufacturer, is in the business of developing and ...
By DEWESoft
-
Project - Yanbu Refinery - Oil and Gas
Capacity: 400,000 Barrels per day A major oil and gas operator in KSA contracted CMC to deliver and certify 4 PEMS for compliance on their refinery stacks. A SmartCEMS PEMS was started-up to record the operating and emission data in June of 2013 for all of the units. The data acquisition system consisted of a data historian integrated with the DCS. The system utilizes the signal from the gas flow ...
-
Servo-Controlled Cuboidal Shear Device
A servo-controlled cuboidal shear device with automatic data acquisition system is described. Provisions are made for pore-pressure measurements with specially designed “needle” piezometers. Complete stress-strain curves can be obtained with strains up to 20%. The application of servo-control in Ko consolidation and strain controlled loading is illustrated with flow charts and experimental ...
-
Taxonomy of SCADA systems security testbeds
Considerable research has focused on developing simulation environments to study the effects of cyber–attacks on supervisory control and data acquisition (SCADA) systems although a methodology to develop a SCADA security testbed is not yet available. This paper attempts to address the issue by presenting a reference model taken from the literature and classifying specific contributions on the ...
-
YTL AMI data acquisition system!
YTL AMI data acquisition system!YTL AMI data acquisition system! In the smart grid, AMI is an infrastructure that can be designed and configured as required. Not a single technology, but a multi-technology complex that enables intelligent communication between power companies and users. It can provide users with the information needed to make decisions, the ability to execute decisions, and some ...
-
AEB test - Case Study
Introduction Our customer, a new manufacturer of Electric Vehicles, needs to validate the performance of ADAS functions of their products. AEB test was performed according to the GB/T 33577-2017 standard. We did the tests below due to time and test field. Record the AEB’s commands via CAN & video and display them live during testing Constantly measure the distance between subject ...
By DEWESoft
-
How to Securely Record Measurement Data: PC-Based or Stand-alone?
How to Securely Record Measurement Data is a very common question asked when deciding a PC-Based or Stand-alone DAQ System. Continuous, secure data acquisition system is possible both with a PC-based system or a stand-alone independent system. Which system you choose depends not only on your application but also on your infrastructure and available budget. In some applications, data ...
-
Locating subverted processes using random packet comparison in SCADA systems
A supervisory control and data acquisition (SCADA) system may be subject to integrity attacks. Anomalies in sensor measurements may be used to detect these attacks, but such techniques do not permit us to locate attacking nodes. We propose a novel technique to enable this. Each participating network node probabilistically copies packets and marks them with routing information, before encrypting ...
-
MadgeTech Raising the Bar on Data Acquisition with Advancements to the Titan S8
You asked, we listened. MadgeTech’s 8-channel, touchscreen data acquisition logger, the Titan S8, is now equipped with wireless capabilities! All you need is a Wi-Fi network or Ethernet to transform this powerful device into a streamlined monitoring solution. Originally designed to simultaneously measure current, voltage, temperature and pulse for real-time monitoring, the Titan S8 ...
-
eDAS 4.0 can monitor all of your environmental data
Technical Director Gary Thursfield blogs about eDAS 4.0®, EMS’s environmental data acquisition system. eDAS 4.0® collects all of your environmental data in one place, making it simple to visualise, control, record and report. Our environmental data acquisition system, eDAS 4.0®, has evolved to offer industry users the most adaptable and hands-on approach to their environmental ...
Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you