denox process control Articles

  • Fast, simultaneous and continuous monitoring of NOx and NH3 in DeNOx applications

    In DeNOx systems using urea injection with ammonia (NH3) as a reducing agent, the flow rate and control of NH3 must be continuously adjusted and controlled to prevent excess NH3 emissions (slip), to reduce environmental impact and cost of reagents. To optimize this process, it is essential to use an emissions analysis system for simultaneous and continuous monitoring of NOx and NH3. For preparing ...


    By Environnement S.A

  • NOx in Non-Utility Industries - Part II - Control options and monitoring methodology

     This the second in a two-part series. Part I, which appeared in our June 2001 issue focuses on air emission origins of nitrogen oxides (NOx) in non-utility industries. Choice of the NOx control technology is dependent on many factors, including regulatory requirements, technical feasibility, cost and public perception. Figure 1, compiled based on publications [1-5], presents a summary of ...


  • NOx in Non-Utility Industries - Part I NOx in Non-Utility Industries - Part I - Air emission origins, best control solutions and monitoring methodology for nitrogen oxides

     Problems with reducing nitrogen oxides (NOx) are widespread in the general process industries. These industries, together with medium size utility and power generators contribute about 15 percent of global NOx emissions. The emission sources addressed include various heaters employed in chemical and petrochemical plants, nitric and sulfuric acid plants, glass furnaces, iron and steel mills, ...


  • ENEL power, italy – fusina project – ZLD plant for FGD wastewater treatment

    The Facility The Fusina Power Plant is equipped with four coal-fired units with a total capacity of 975 MW capacity (1 x 165 MW + 1 x 170 MW + 2 x 320 MW). The Environmental Refurbishment (Flue Gas Desulpharization, (FGD)) project includes a new DeSOx system for common for units #1 & 2; two DeNOx systems, one each for unit #1 & 2. Units #3 & 4 are already equipped with DeSOx ...

  • ENEL power, italy – sulcis project – ZLD plant for FGD wastewater treatment

    The Facility The Sulcis Power Plant is equipped with 1 x 345 MW fluidized bed boiler and 1 x 240 MW conventional boiler. This coal-fired power plant is located in Sardinia Island and has a total of 585 Mwe capacity. The units normally fire imported coal with < 1% Sulphur. The flue gases are treated sequentially by SCR-DeNOx with ammonia as the reagent. This is followed by a high ...

  • ENEL power, italy – torrevaldaliga project – ZLD plant for FGD wastewater treatment

    The Facility The Torrevaldaliga Nord Power Plant is being converted (torn down and rebuilt) to three coalfired units each of 660 Mwe capacity. The plant is equipped with fabric filters for flue gas dust removal, DeNOx system (for flue gas denitrification), FGD systems for sulphur oxides removal. The FGD system is equipped with a common wet limestone milling, three limestonegypsum forced ...

  • Enel power, italy – brindisi project – ZLD plant for FGD wastewater treatment

    The Facility The Brindisi Sud Power Plant is equipped with four coalfired units each of 660 Mwe capacities. These units normally fire imported coal with < 1% Sulphur. The flue gases are treated sequentially by SCR-DeNOx with ammonia as reagent, High efficiency ESP to remove fly ash and wet limestone gypsum forced oxidation DeSOx. Each unit is equipped with a 2 x 50% DeSOx lines each ...

  • A STIEFEL project UTO Uvrier case study

    The waste incineration plant UTO Uvrier is situated in the south western part of Switzerland. The Association which controls the plant was established in 1969 and treats waste from 44 municipalities with a combined population of 170,000 inhabitants. The principal task of UTO Uvrier is the thermal heat recovery from urban and industrial waste. Apart from this, UTO also treats other types of waste ...


    By Jakob Stiefel GmbH

  • Laser Gas Detector LGD F200

    Laser gas detection with innovative, easy-to-integrate OEM modules Diode Laser based gas detection gains increased interest in the industry as it offers significant benefits in terms of selectivity, stability and low maintenance. Axetris provides innovative gas detector modules as basis for extractive process control systems and for continuous emission monitoring systems (CEMS). The ...


    By Axetris Ag

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you