detection tube pump Articles

  • A Guide to Gas Detector Tubes. Your Questions Answered

    Gas detector tubes are easy to use, are low cost, and the method is intrinsically safe, allowing it to be deployed in all industries. Because detector tubes don’t require calibration, users see the benefits of this technology over electronic gas detectors due to their ease of ...


    By a1-cbiss

  • Detection of chlorpyrifos in air using low volume polyurethane foam (PUF) sampling with immunoassay

    MATRIX: Air samples ANALYTE: Chlorpyrifos RANGE OF DETECTION: 0.088 to 1.200 mg/m3 MATERIALS: Chlorpyrifos RaPID AssayÒ Kit and Sample Diluent. Reagents: methanol (pesticide grade). Equipment: 40 mL glass vials with Teflon lined caps, 13 x 100 mm glass test tubes, 5 mL and 20 mL serological pipets, micropipet ...


  • The Alternative to Pump and Treat

    Sometimes, an important technological advance begins with a small step – back! Such is the case with remediation of hydrocarbons from groundwater utilizing existing recovery and monitoring wells. For the past few years, state government has based decisions on the amount of clean up that they require by the risk posed to the environment. Risk Based Corrective Action, commonly called 'Rebecca' ...


    By Abanaki Corporation

  • Watson-Marlow OEM pumps help meet rising demand for chlorine monitors

    A specialist manufacturer of water quality measurement and monitoring systems is using peristaltic pump technology from Watson-Marlow Fluid Technology Group for use in chlorine monitoring equipment after similar pumps were found less reliable. With customers that include water, industrial and pharmaceutical companies, Analytical Technology Inc (ATI) designs and manufactures its products in ...

  • Blue-White’s “Flex-Pro” Peristaltic Pumps in Partnership to “Save Water and Protect the Environment”

    Over the years, the Environmental Protection Agency (EPA) has offered voluntary partnership programs to address a wide variety of environmental issues by working collaboratively with companies, organizations, and communities.  There are now more than 13,000 firms and other organizations participating in EPA Partnership Programs according to the EPA website.   One of the more highly ...


  • EPA Compliant Letter

    APPENDIX I (Continued) B. Air Monitoring Equipment There are different methods available for air monitoring. These include colorimetric detector tubes (e.g., National Draeger, Sensidyne, Matheson-Kitagawa, MSA) and realtime remote sensing monitors (e.g., PureAire Monitoring Systems). NOTE: These air monitoring methods apply to enclosed areas, including greenhouse soil ...

  • TVOC measurement for LEED/green building evaluation

    Total Volatile Organic Compounds (TVOC) may be evaluated when building designers/managers are pursuing the Leadership in Energy and Environmental Design Green Building Rating System for New Construction (LEED-NC) EQ Credit 3.2. The latest LEED-NC guidance document specifies that the maximum allowed concentration of TVOC measured in a building (post construction, pre-occupancy) is 500 µg/m3; the ...


  • Residential Vapor Intrusion Evaluation: Long Duration Passive Sampling v. Short Duration Active Sampling

    Abstract Sampling indoor air for potential vapor intrusion impacts using current standard 24-hour sample collection methods may not adequately account for temporal variability and detect contamination best represented by long-term sampling periods. Mr. Henry Schuver of the U.S. Environmental Protection Agency (EPA) Office of Solid Waste staled at the September 2007 Air & Waste Management ...

  • Selecting and Placing Gas Detectors for Maximum Application Protection

    Many industrial processes involve dangerous gases and vapors: flammable, toxic, or both. With the different sensing technologies available, and the wide range of industrial applications that exist, selecting the best sensor and locating them properly for the job at hand can be a challenge. To ensure a high level of safety, know the latest sensing technologies, which technology is best for the ...

  • Is your Plant as tight as you think? Leak Detector for extremely toxic Gases, a Field Test Report

    Leak detection of commodity gases in chemical plants is a day-to-day practice. The sensor technology available for this application is field proven and reliable. No question about it, existing sensors will do the job. However, in plants manufacturing or handling extremely toxic substances, the picture is different. For example, take phosgene. The existing sensor technology for leak detection ...

  • Achieving

    Introduction The leak repair requirements, under Title VI Section 608 of the Clean Air Act Amendments of 1990, require that when an owner or operator of an appliance that normally contains a refrigerant charge of more than 50 pounds discovers that refrigerant is leaking at a rate that would exceed the applicable trigger rate during a 12-month period, the owner or operator must take corrective ...


  • Gas Monitoring for Ventilation Control and Energy Management

    The growing demand for underground and enclosed parking and maintenance garages (resulting from limitations on land availability) has increased the awareness and need for proper ventilation and control systems. In addition, increased health and safety programs have only added to the concerns of toxic and combustible gases in confined or enclosed spaces. Historically, ventilation and make-up air ...


    By Arjay Engineering Ltd.

  • Refrigerant leak creates environmental problems for businesses

    A great concern for companies is a refrigerant leak in their refrigeration and air-conditioning (RAC) system or heating, ventilation and air conditioning (HVAC) system. That’s because gases that escape during a refrigerant leak pollute and damage the environment. To better monitor and maintain the operation of these business assets, many companies utilize a refrigerant management program.There ...


    By Verisae

  • C18 extraction of atrazine for increased sensitivity in the RaPID Assay

    Performance of an increased sensitivity method utilizing an extraction and concentration step to increase analyte concentration of the assayed sample is presented. Recently, Shepard and Carr (1992) reported a method for increased detection of atrazine by gas chromatography using C18 solid-phase extraction (SPE) with a 10 mL water sample. An application with BakerbondÒ C18 SPE columns for ...


  • EPA studies identify techniques for critical leak testing prior to soil-vapor sampling

    Researchers at EPA’s National Risk Management Research Laboratory (NRMRL) in Ada, OK, are developing quality assurance (QA) measures for soil-gas and sub-slab sampling methods that help differentiate contaminant vapors due to vapor intrusion from background sources. Recent research focused on measures to identify leakage of ambient air into conventional vapor probes, which can significantly ...

  • How Can TO-15 Help You Solve Your Next IAQ Problem?

    Untitled Document Have you ever been asked to investigate unpleasant odors in a home or at the workplace? Are occupants developing headaches or a feeling of nausea? ...


    By EMSL Analytical, Inc.

  • Discrete or Continuous Flow Analysis – which is better?

    A wide variety of factors affect the choice of analytical instrument. These include target workload (samples/hour), variety of chemistries, methods required, bench space, staff availability etc. In the following article Lalicia Potter, Technical Sales & Support Director at SEAL Analytical, examines one of the common decisions facing laboratory managers. As the manufacturer of an ...

  • Read about Confined Space in Construction and Atmospheric Testing Right Here!

    In 1993, 29 CFR 1910.146 went into effect as the first federal legislation governing entry into permit-required confined spaces in general industry. Because some industries, such as the construction industry, were covered by specific Occupational Safety and Health Administration (OSHA) safety regulations, they were exempt from the confined space entry requirements of the general industry rule. ...


    By Argus-Hazco

  • Air Monitoring for the Gulf Oil Spill

    Ambient air monitoring is a priority in the ongoing efforts to contain and manage the oil spill from the Deepwater Horizon in the Gulf of Mexico. The following provides information about the kinds of airborne contaminants that are currently being monitored in the Gulf, how they are collected and how they are analyzed. For a given project, a suitable sampling plan – developed by ...


Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you