direct oil heater Articles

  • Biomass fired thermal oil heater case study

    This 12 MWth output Biomass Power Plant is one of the turnkey products of Biomass Power. The plant was fully commissioned in December 2006. The system has a capacity of 12 MW thermal output producing up to 10MWth of 300°C 10 Barg pressure hot oil, up to 10 tonnes per hour of steam and 2 MWth of 200°C hot air. This is all achieved from one grate heating three separate heat exchanges. The ...


    By Biomass Power Limited (BPL)

  • Client - Oil Refinery, Eastern Europe

    Project - Heavy Oil Pre-Heater As part of an overall facility upgrade this major oil refinery decided to seek ways of reducing its heavy oil pre-heating costs. A proposal was submitted that would enable waste heat from the refinery to be used as the source to safely pre-heat the stored heavy oil. The solution proposed the use of a gas to water recovery unit coupled to two heat pipe ...


    By Econotherm UK Ltd

  • Oil refinery vapour gas case study

    1.0 Evaluation of Refinery Gases Various refinery gases are generated in the process of oil refining. These vary, depending upon the type of crude oil being distilled, such as Reduced Crude distillation, or Naphtha cracker. For the purposes of this case study the description and range of refinery gases are those gases produced from refining Crude Oil and Reduced Crude only. Crude ...

  • Steam injection heating of biosolids & sludge for Anaerobic Digestion

    The article focuses on the integration of Direct Steam Injection (DSI) heating as a method for heating of Municapal, Industrial, Food, & Agricultural wastewater streams. Common applications are anerobic digestion, biogas production, waste de-activation, and FOG (Fats-Oils-Grease) heating. Topics covered include how DSI works, how to select a DSI heater suitable for viscous & difficult to ...


    By ProSonix

  • Carbon Monoxide, Carbon Dioxide and Indoor Air Quality

    Chances are that unless you are hot or cold – or if you smell something funny – you probably never think about indoor air quality. However, scientists know that gases in the air that you cannot see or smell can still affect your health. Carbon Monoxide The most dangerous gas most of us will ever face is carbon monoxide (CO). Not normally occurring in nature, this ...


    By Air Concern Limited (ACL)

  • Skimming Oily Wastewater

    As large generators of oily wastewater tighten effluent controls, the U.S. Environmental Protection Agency (EPA) is targeting smaller generators. Some of the firms receiving their attention are smaller manufacturing plants, automotive garages, mobile equipment service shops and truck farms. Many of these firms do not have access to a sanitary sewer system that will accept oily wastewater. Because ...


    By Abanaki Corporation

  • Petroleum Refining Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • From Solar Rays to Electricity

    Solar energyrefers to solar radiation energy. Since the formation of the earth, organism relies on the light and heat provide by the sun to survive.Solar energyis a kind of renewable energy. The biggest advantage ofsolar energyis that it is inexhaustible on earth. And it is the basic source of many other kinds of energy, such aswind energy,chemical energy, thewater energyand so on. It is called ...


    By Greenshine New Energy LLC

  • NOx in Non-Utility Industries - Part I NOx in Non-Utility Industries - Part I - Air emission origins, best control solutions and monitoring methodology for nitrogen oxides

     Problems with reducing nitrogen oxides (NOx) are widespread in the general process industries. These industries, together with medium size utility and power generators contribute about 15 percent of global NOx emissions. The emission sources addressed include various heaters employed in chemical and petrochemical plants, nitric and sulfuric acid plants, glass furnaces, iron and steel mills, ...


  • Strategic Standardization

    An Interview with John Walter, CEO of the Standards Council of Canada SCC leader John Walter discusses the strategic value of standardization, his organization’s priorities and harmonizing Canadian and U.S. standards. How is the Standards Council of Canada approaching the upcoming revision to the Canadian Standards Strategy? The Standards ...


    By ASTM International

  • Case study - Amine tail gas treatment

    COVERING YOUR TAIL GAS The discovery of new shale formations throughout the world and the development of new drilling technologies have increased natural gas production and prompted government agencies to instigate tighter air-pollutioncontrol regulations on processing operations. Unfortunately, meeting environmental regulations is not a profit-generating endeavor. Simply put, the time ...

  • Efficient steam production in paper mills

    The paper and pulp industry is an energy and emission intensive industry. Steam is an essential part of the paper making process with steam boilers, steam distribution systems and other processes accounting for a large percentage of a paper mill’s energy costs. Useful energy is often lost from boilers and process equipment such as heat exchangers, dryers, evaporators etc, as well as from ...

  • UAE’s MISP center accelerates pre-commercial tech development

    Almost three years after launching the Middle East’s first CSP plant, Masdar joined with Masdar Institute to launch late last year the region’s first CSP research and demonstration centre. Masdar Institute Solar Platform (MISP) builds around a set of unique facilities including a 100kW beam-down concentrating tower and its solar field, a hot-oil loop and thermal energy system (TES), ...


    By FCBI Energy

  • Renewable energy progress report

    What is the Renewable energy progress report and what is its purpose? The Renewable Energy Directive states that a progress report should be issued every two years. The purpose of this progress report is to assess Member States' progress in the promotion and use of renewable energy in line with the 2020 targets. In addition, it contains sections on ...


    By Europa Press Room

  • Preparing for EPA’s mandatory reporting of greenhouse gases rule

    Recent action by the US EPA to finalize the Mandatory Reporting of Greenhouse Gases (GHG) Rule means that environmental managers must now seriously examine whether they are fully prepared to address the imminent requirements. This article provides some assistance by summarizing key points regarding the final versus proposed rule, providing clarification on key questions that have arisen since the ...


    By Trinity Consultants

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you