dust monitoring system Articles

  • Why monitor dust in the workplace?

    Almost any place of employment can present a potential threat to health and safety from airborne particulates and aerosols. It is important to note, however, that dust hazards are not necessarily visible to the human eye and that the finest particles can represent the greatest threat because of their ability to travel deepest into the lungs. Effective monitoring is therefore key to the ...


    By Ashtead Technology Ltd

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By SIGRIST - PHOTOMETER AG

  • Retrofit Intelligent Dust Extraction System

    Western Air Ducts Retrofits Intelligent LEV Solution at City of Oxford College The proffesionally equiped woodworking workshop at the Rycotewood Furniture Centre, at the City of Oxford College city centre campus, is a key resource for the many students of furniture design and ...


    By Western Air Ducts (UK) Ltd.

  • The invisible fine dust

    Air is lifeblood. Daily we inhale approximately 15.000 liter. Still, the air contains invisible pollutants, which vary in its composition and concentration depending on the location. Especially the respirable particles with a diameter of less than 2.5 µm (PM 2.5) were considered to be particularly dangerous. According to a current study conducted by the Max Planck Society, ...

  • TSI dust monitors and Lufft weather sensors make a great team

    Both aerosols and wind speed and direction influence air quality significantly. This is why TSI Incorporated, a world leader in particle measurements, cooperates with Lufft USA in order to provide complete systems to measure PM2.5 (fine dust), PM10 (particles with a maximum diameter of 10 μm) as well as total PM levels. TSI Incorporated offers a variety of aerosol ...

  • Controlling Dust and Bioaerosols at a Biosolids Composting Faclity

    Studies at enclosed Longmont, Colorado project evaluate exposure level of employees. Operational changes reduce dust, endotoxin and A. Fumigatus by 90 percent. WHEN dealing with public health issues and composting, attention has been predominantly focused on potential exposure from the release of Aspergillus fumigatus (A. fumigatus) from composting facilities. Numerous studies were conducted to ...


  • Monitoring Environmental Quality

    ' In order to determine the effectiveness of actions to improve environmental quality it is necessary to be able to measure relevant environmental parameters at a level of detail which is accurate enough to distinguish the anticipated changes. However, the establishment and maintenance of monitoring systems is time-consuming and expensive and therefore the scale of such systems needs to be kept ...


    By The World Bank

  • How to Monitor Mercury Emissions

    In recent years, mercury levels in the environment and in the food chain have risen substantially mainly due to human activities. As a long-range pollutant it can affect areas located thousands of kilometers away from its original source of emission. It’s no wonder then that the regulatory pressure to monitor mercury emissions grows stronger.  Before diving ...


    By Gasmet Technologies Oy

  • NEO Monitors conquers the Quasi-impossible

    China is a world factory powered by its abundant coal resource. China is facing a huge environmental challenge brought together with the fossil-fired power plants. China has therefore been conducting technical retrofit to the engines of its economy, by introducing emission control facilities. Selective Catalytic Reduction (SCR) technology is one of the most widely applied emission control ...


    By NEO Monitors AS

  • The ‘ins and outs’ of air quality monitoring

    The National Institute for Health and Care Excellence (NICE) recently issued draft guidance on ‘Air pollution - outdoor air quality and health.’ In the following article Jim Mills, Managing Director of Air Monitors Ltd, explains why there will need to be more funding for monitoring if the mitigation measures mentioned in the guidance are to be implemented effectively. Jim also ...


    By Air Monitors Ltd.

  • Casella BOUNDARY Guardian helps to control noise and dust on major London construction project - Case Study

    Casella‘s BOUNDARY Guardian is helping to ensure noise compliance and control of air quality at BSkyB’s campus redevelopment site, bringing peace of mind to site operators, the client and the local community. The BOUNDARY Guardian is a system for web-based remote monitoring of noise and/or dust emissions that ensures compliance ...


    By Casella

  • ‘New for old’ dust analyser deal brings 96.66% data capture rates to NE Lincs

    With the UK’s largest port and the industrial town of Grimsby in its jurisdiction, air quality monitoring is a primary concern for North East Lincolnshire Borough Council. When DEFRA reported that the TEOM dust analysers the council relied on weren’t up to standard, rapid action was required and Enviro Technology (ET) stepped in with its BAM 1020s. North East Lincolnshire is the ...

  • Air Pressure Monitoring for a Chemical Fume Hood

    CAS DataLoggers recently provided the pressure and temperature datalogging solution to a manufacturer using a chemical fume hood to protect workers by containing vapors, dusts, gases, and fumes, and then expelling them as air flowed into the hood from the front (open) side of the cabinet and then out via the ducted hood exhaust system. Designed for 2 operators, the fume hood had a Fiberglas ...


    By CAS DATALOGGERS

  • Workplace Monitoring: Who, What, When, Why, How?

    In my previous articles in this series for SHP readers, I have focussed on the need for current attitudes to general health and safety processes to change and emphasised the importance of regular monitoring. The best way to combat those ‘hidden killers’ and protect our workforces is to increase awareness of the benefits of regular monitoring and detection.  Employees then need to ...


    By Casella

  • Compliance to standards in continuous emissions monitoring case study

    Customer: Glass Manufacturer Application: Continuous Emissions Monitoring Service (CEMS) for Glass Manufacturing Background: A glass factory is required to ...


    By Ecotech Pty Ltd

  • Continuous Mercury Monitoring Benefits Cement Plants

    Antti Heikkilä from Gasmet Technologies highlights the challenges faced by mercury monitoring in cement kilns, and explains how a new continuous mercury monitoring system addresses these issues and provides process operators with an opportunity to improve environmental performance and demonstrate compliance with forthcoming legislation. Background The production of cement ...


    By Gasmet Technologies Oy

  • Silver Membranes in Monitoring Respirable Crystalline Silica

    Crystalline silica, most commonly found in the form of quartz, is a basic component of the earth; it’s found in soil, sand granite, and other minerals. During many industrial processes, crystalline silica is released as particles that are 100 times smaller than beach sand.1 Due to their size, these mineral particles cannot easily be cleared by human lungs. Instead, they persist in the ...


    By Sterlitech Corporation

  • Technical Challenges of Continuous Mercury Emissions Monitoring

    Many pollutants such as CO2, NOx and SO2 have been monitored continuously already for decades. In the last years the awareness for the need to measure mercury has also grown, and continuous mercury monitoring is becoming more and more relevant. Especially industries burning coal, oil or waste, share the responsibility to monitor their mercury emissions. All measuring techniques need to be able to ...


    By Gasmet Technologies Oy

  • Air Separation Plants and the Use of Oxygen Monitors

    Air separation plants are critical for many different industries, from clean energy to manufacturing. Nowadays, cryogenic is the most common type of distillation used to separate air into its component gases - nitrogen, oxygen, and inert gases including helium and argon. If your industry relies on air separation for product development or manufacturing, then knowing how the process works is ...

  • Designing and Implementing Perimeter Air Monitoring Programs

    Perimeter or fenceline ambient air quality and meteorological monitoring programs have become increasingly valuable at hazardous waste, landfill, dredging, ports, and MGP remediation sites. Air quality monitoring programs protect public health and reduce owner liability ...


    By AECOM

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you