electric oxidizer Articles

  • Maintenance Tips: Thermocouples

    Keeping air pollution control equipment properly maintained is essential for meeting regulatory requirements and efficient operation. Here on the CPI blog, we regularly share tips on maintaining your systems, which requires replacing components on a yearly basis. Today we're taking a closer look at the importance of replacing ...

  • Expert Installation Services Soar to New Heights

    Along with providing equipment to solve customer’s complex VOC, NOx, and Odor pollution challenges, we also provide installation services. I was on site for the recent “lift” of a new QUADRANT SR-35,000 Thermal Oxidizer (TO). Capital equipment, like a Thermal Oxidizer, is designed to operate for many years; however wear and tear eventually may require the equipment to be ...

  • Oxides heterostructures for nanoelectronics

    We summarise in this paper the work of two groups focusing on the synthesis and characterisation of functional oxide for nanoelectronic applications. In the first section, we discuss the growth by liquid-injection MOCVD of oxides heterostructures. Interface engineering for the minimisation of silicate formation during the growth of polycrystalline SrTiO3 on Si is first presented. It is realised ...


    By Inderscience Publishers

  • Ethylene oxide – useful but dangerous?

    We’re proud of the fact that Analox Sensor Technology can help you monitor a wide range of gases, from carbon dioxide and carbon monoxide, to oxygen and helium. One of the more unusual gases we offer monitoring solutions for is ethylene oxide, or C2H4O as it is often known. Many people do not know what ethylene oxide is, and we have seen a lot of Google searches where people ...


    By Analox Sensor Technology

  • Rto & recuperative oxidizer pros & cons - Regenerative thermal oxidizer technology

    RTO technology has been developed for large volumes and low VOC concentration air pollution applications. The best example is spray booth exhaust where the volume of exhaust is high and VOC concentration is very low. Regenerative Thermal Oxidizer technology is based on using ceramic media as heat exchangers and switching values. Advantages High thermal efficiency ...


    By Epcon Industrial Systems, LP

  • Oxidation Catalysts for Co-Generation Plant

    Description Manuli Film, Naples, Italy, with three (3) Rolls Royce KVGS-18G2, lean burn, natural gas engines, each 3030 kW electrical. Thermal power is utilized both from exhaust gas and cooling water for plastic film production. Challenge Required to meet emission standard of 400 mg/Nm3 @ 5% O2 for carbon monoxide and 150 mg/Nm3 @ 5% O2 non-methane hydrocarbons. Solution ...


    By DCL International Inc.

  • Diesel Oxidation Catalyst for Marine Vessel

    Description Eight MTU 16V4000 (1800 kW) diesel engines powering two electric motors for the yacht Octopus, owned by Microsoft billionaire Paul Allen. At the time of launch in 2003 it was the largest private luxury yacht in the world, costing over US$200 million and with a permanent crew of 60. Challenge Design specifications called for the use of advanced exhaust after-treatment for ...


    By DCL International Inc.

  • Case study - Oxidizer system optimization

    OXIDIZER SERVICE SERIES: PART 4 As promised, this is the fourth installment of Anguil's Oxidizer Service Series. If you have read through the first three parts, this can be seen as a capstone of those efforts. Having a strong oxidizer service plan, backed up with recommended spare parts and all of the proper documentation will not only improve your system performance but also allow you to focus ...

  • Case study - Increasing oxidizer capacity by 80,000 SCFM

    Overview A recreational products company bought a three year-old manufacturing facility with an existing regenerative thermal oxidizer (RTO) for the production of their outboard engine. They required emission control equipment to manage the volatile organic compounds (VOCs) emitted by the solvents used in the engine painting processes. The company wanted to minimize overall costs by using ...

  • Retention behaviour of graphene oxide resistive switching memory

    Graphene oxide (GO) has recently been proposed as one of the potential resistive switching materials for future nonvolatile memory applications. In this work, we present a flexible resistive memory device with the structure of aluminium (Al)/GO/indium tin oxide (ITO) fabricated at room temperature. The Al/GO/ITO devices show unipolar resistive switching behaviour with resistance ratio to over 30, ...


    By Inderscience Publishers

  • Mixed Oxidant Replaces “Cocktail” of Chemicals in Power Plan

    Cooling Tower Water Systes Synopsis In 2010 NIPSCO installed two MIOX RIO Mixed Oxidant Solution (MOS) chlorine generator systems on two of the four cooling towers at R.M. Schahfer Generating Station.  After switching to MIOX for cooling tower water treatment, the two towers experienced minimized algae growth, better biocontrol and lower Legionella counts, ...

  • Regenerative Thermal Oxidizers…What You Should Know.

    Within industry today, the use of an Air Pollution Control System (APCS) to control harmful air pollutants is not new.  In response to Congressional guidelines passed in the 1970’s, a number of companies with VOC emissions have been operating air pollution control systems of one type or another for 25 years or more.  These guidelines have been revised and added to as the years ...


    By The CMM Group, LLC

  • Oxidation System for Sanitary Landfills & Recycling Centers

    The Broward County, Florida, Central Sanitary Landfill & Recycling Center operates the country’s largest landfill gas turbine-to-energy plant. Approximately 9 MMSCFD of landfill gas is collected from 300 wells and converted into electricity. During the cleanup after hurricane Andrew, large amounts of construction and demolition debris were brought into the landfill for disposal. Over a very short ...


    By Merichem Company

  • DO control maximizes oxidation ditch treatment efficiency

    Process control is key to maximizing wastewater treatment efficiency while minimizing operating costs. Implement- ing the right process control system in conjunction with the right equipment can save money on electrical costs and equip- ment maintenance. The wastewater plant for the city of Dawson, MN, uses a Tri-Oval® oxidation ditch from Aeradon Industries for primary treatment of its ...

  • Laundry Oxidation System Saves Money & Time for Hotel

    A recent trial at a local San Antonio hotel using the Ecotex Laundry Oxidation System, has yielded results proving the company's claim that significant savings can be realized in water, natural gas, chemical use, and labor. For this 120 room hotel, a savings of over 250,000 gallons of water per year will be realized, while improving the quality and cleanliness of the laundry being processed. The ...

  • Case study - Oxidizer energy recovery options

    Overview The mainstream media today is full of allusions to energy awareness and conservation. Just as visible these days are media references to astronomical dollar figures that can boggle the mind. This article does not seek to break out of that mold, but rather to conform to it – as Oxidizer Stack Heat Recovery offers a tremendous opportunity for both energy conservation and ...

  • Catalytic Oxidizers…What You Should Know.

    Within the U.S., depending upon specific plant operations, geographic locations, etc.,  many companies concerned with controlling VOC emissions have been operating air pollution control systems for years.  However, due to business expansion, plant modifications or recent changes in EPA guidelines, an increasing number of companies are now finding it necessary to install new emission control ...


    By The CMM Group, LLC

  • Case study - Crafting your oxidizer maintenance plan

    OXIDIZER SERVICE SERIES: PART 2 Many will come to this article hoping for a one-size-fits-all checklist for maintaining an oxidizer system. As a company that offers service on any oxidizer regardless of style or original manufacturer, we at Anguil have long wanted the same. A set recipe for success would certainly make life easier. For those in need of a quick answer or a starting point from ...

  • Removal of pharmaceuticals using combination of UV/H2O2/O3 advanced oxidation process

    Water and wastewater effluents contain a vast range of pharmaceutical chemicals. The present study aims to determine the potential of the advanced oxidation technology UV/H2O2/O3 and its sub-processes (i.e. UV, UV/H2O2, UV/O3, O3 and H2O2/O3) for the degradation of the antibiotics ciprofloxacin (CIP) and trimethoprim (TMP), and the antineoplastic drug cyclophosphamide (CPD) from water. Creating ...


    By IWA Publishing

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you