electronic scrap Articles

  • Pre-shredders from Erdwich reduce efficient Electronic-scrap

    The handling of electrical appliances has changed drastically over the past 20 years: Nowadays, a defect appliance is replaced rather than repaired. According to United Nations' estimates, 40 million tonnes of electrical and electronic scrap is produced per year worldwide, which will be doubled by 2025. Valuable resources such as steel, nonferrous metals, plastic materials etc. can be recovered ...

  • Guide to greener and safer electronics

    With expanded and tougher criteria on toxic chemicals, electronic waste and new criteria on climate change only Sony and Sony Ericsson score more than 5/10 in our latest Guide to Greener Electronics. Nintendo and Microsoft remain rooted to the bottom of the Guide. Ranking criteria explained: As of the 8th edition of the Guide to Greener Electronics, Greenpeace scores electronics brands on a ...


    By Greenpeace International

  • E-scrap regulations: calls for stronger enforcement

    Demands for an enhanced producer responsibility system and on-going adaptation of the Directive on Waste Electrical and Electronic Equipment (WEEE) by EU member states provided the two main areas of discussion at the 2008 International Electronics Recycling Congress (IERC) in Salzburg, Austria. The congress was marked by a call for greater enforcement of regulations, increased collection rates ...


    By Recycling International

  • Pre-shredders from Erdwich reduce up to eight tonnes of electrical and electronic scrap per hour using two drives, each with a power of 40,000 Nm

    The handling of electrical appliances has changed drastically over the past 20 years: Nowadays, a defect appliance is replaced rather than repaired. According to United Nations' estimates, 40 million tonnes of electrical and electronic scrap is produced per year worldwide, which will be doubled by 2025. Valuable resources such as steel, nonferrous metals, plastic materials etc. can be recovered ...

  • E-scrap: metals too precious to ignore

    Increased recovery of waste electrical and electronic equipment (WEEE) is providing the global recycling industry with fresh challenges. Researchers from Berlin’s University of Technology have been taking a close look at the material flowing into and out of the recycling process, paying special attention to the precious metals content. Their main conclusion is that conventional sorting ...


    By Recycling International

  • Car and e-scrap recycling: the Chinese experience

    In late November, more than 220 delegates met in China for the World Recycling - Shanghai congress organised by Switzerland-based ICM. Among other issues, the focus fell on latest trends in car and electronics scrap recycling within China itself. Several speakers emphasised that much remains to be done to bring the country into line with standards adopted in other parts of the world. Tighter ...


    By Recycling International

  • Electronic waste recycling plant In Eindhoven

    Sector: Electronic scrap Brown goods, grey goods, white goods – as much as 60,000 metric tons of electronic waste are processed each year at Sims Group’s state-ofthe-art plant in Eindhoven. Analysis Combining this high throughput with a high purity degree of reclaimed raw materials is the constant goal of Paul Verhappen, Senior Process Engineer ...


    By TOMRA Sorting (TITECH)

  • Planning models for the dismantling of electrical and electronic equipment under consideration of uncertainties

    In this paper, an approach is presented for short-term dismantling planning, including process-induced uncertainty modelled with fuzzy techniques. Weak data resulting from uncertain dismantling time parameters are modelled as fuzzy sets and integrated into a scheduling model that allows the derivation of optimal dismantling procedures. A case study from electronic scrap recycling shows the ...


    By Inderscience Publishers

  • BlueOak - Precious metal recovery from electronics waste - Case Study

    The Challenge In the US, consumers alone dispose of some 3.2 million tonnes of e-waste annually; more than 80% of this ends up as waste, contributing >70% of all toxic metals in U.S. landfills. In a bid to tackle this wastage, BlueOak Resources. USA announced in July 2014 that they had selected Tetronics' technology for their national project to sustainably recover precious ...

  • International electronics recyclers featured on Powersoure Online (Largest US B2B Network)

    Are you looking to learn more about electronic waste commonly referred to as “e-waste”? Are you looking to meet directlywith buyers and sellers of electronic scrap and surplus electronics? Do you want to meet to network with and listen toleading experts from the electronic waste management industry, Government policy makers and environmental organizations? Do you want to be a part of the ...

  • MERC - Metropolitan Electronics Recycling Center, South Korea - Case Study

    A better value product by replacing DMS by sensor-based sorting – Separating WEEE in South Korea Overview of Korea's Metropolitan Electronics Recycling Center The client was the Korea Electronics Recycling Cooperative – the body acting as Korea's WEEE (Waste Electrical and Electronic Equipment) association. They had direct responsibility for ...


    By TOMRA Sorting (TITECH)

  • Simulation research on the influence of stress relaxation on plastic IC delamination during scrapped PCB disassembly

    Functional reuse of Integrated Circuits (IC) is effective to recover electronic utilities. Interfacial delamination may occur when the ICs are disassembled from scrapped Printed Circuit Board (PCB) and reduce reusability. In delamination analysis, viscoelasticity of moulding compound is a non-ignorable property as it reduces the stress. It is the purpose of this research to analyse the effect of ...


    By Inderscience Publishers

  • What to consider: Selecting the right electronics recycling & asset management vendor

    As the sales executive with an R2 & ISO-14001 certified electronics recycling, scrap purchasing, and asset management corporation, I could write all day about why I think Dynamic Recycling should be your e-recycling vendor. I would rather provide you with the appropriate information to conduct your own evaluation/analysis of what to look for in choosing a recycler that is the right fit for ...


    By Dynamic Recycling

  • Europe ‘s E-waste Failure – Only a Third of Electronic Waste Managed Correctly

    Mismanagement of discarded electronics within Europe involves a volume 10 times that of e-waste shipped to foreign shores in undocumented exports, according to a comprehensive 2-year investigation into the functioning of the used and waste electronics market. The European Union-funded project, Countering WEEE (waste electrical and electronic equipment) Illegal Trade (CWIT), was undertaken by ...


    By GLOBE Foundation

  • GEEP’s guide to e-cycling success

    The recent Electronics & Battery Recycling congress in Toronto featured a personal view on global e-cycling solutions from Alfred Hambsch of Ontario-based Global Electric Electronic Processing - a company involved in the operation of e-scrap plants across three ...


    By Recycling International

  • Overview of the Whole Copper Recycling Chain

    Copper is of good characteristics. It is easily stretched, molded, and shaped; is resistant to corrosion; conducts heat and electricity easily. Therefore, copper is widely used in construction, power generation and transmission, electronic products manufacturing, and the production of industrial machinery and transportation vehicles. At the same time, as a non-renewable resource, copper is also ...

  • Sorting Equipment Focus: Keeping Time

    (From Recycling Today Magazine) In with the new, out with the old. A reversal of an old adage is perhaps the best way to describe the increased demand for America’s scrap metals. The world’s hunger for new cars, appliances and buildings was a boon for steel makers in 2004.  Global steel production exceeded 1 billion tons last year, a record amount. And as the need for “new” steel products ...

  • Pioneers within WEEE recycling

    In a scrap yard in Switzerland right in the middle of the beautiful Alps you can find one of Eldan Recycling’s most cherished and faithful customers – Cablofer Recycling SA. Cablofer was actually one of the first companies within the WEEE-recycling industry. Cablofer Recycling SA is a scrap metal processor dealing with ferrous and non-ferrous scrap on a 40'000 m2 plot in Switzerland. ...


    By Eldan Recycling A/S

  • Indirect Determination of Gold Purity by Measurement of Impurities with Flame Atomic Absorption Spectroscopy

    The determination of the purity of scrap and refined gold is a very important procedure for the financial markets, the jewelry business and the electronics industry. Over the years, the classical fire assay technique has been used for gold determination but this is a very labor-intensive procedure, and prone to many operator errors. Hundreds of books have been written with special steps and ...


    By Buck Scientific Inc

  • Neue Herbold - Hammermills

    Neue Herbold HM series hammer mills offer flexibility in their application range. Through the installation of material oriented rotor milling hammers tools various types of brittle plastics such as electronic scrap, wood scrap, and organic insulation material (glass-wool, stone-wool,...) Advantages - flexibility in their application   range ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you