elemental analysis Articles

  • Elemental analysis

    This article describes the benefits of the MiniPal QC for characterizing coal at-line. The MiniPal QC is a benchtop energy dispersive X-ray fluorescence system designed to fulfill the needs for rapid and reliable elemental analysis at line. ...


    By PANalytical

  • Elemental Analysis - Automation Without Limits

    Fully automated carbon, sulfur, chlorine, and nitrogen analysis in liquid and solid samples is possible! Thanks to the multi-matrix sampler you have the security of being able to meet the most varied analytical challenges in next to no time with one single system - the multi EA® 5000. Its intelligent construction facilitates the highest sample throughput ever in organic elemental analysis. ...


    By Analytik Jena AG

  • Monitoring of typical pumps and aerator in a water treatment plant

    The wireless vibration network of Wi-care system consists of the communication between three components; the transmitter, the range extender and the receiver. The transmitter is fixed on the machine and transmits the vibration and the temperature data at the measurement point. The second element of the Wi-care wireless network is the range extender, its function is to transmit vibration and ...


    By Wi-Care

  • Content Analysis of Toxic Elements in Soil by Simultaneous ICP

    Contaminated soil not only leads to contamination of untreated drinking water through permeation into river water and rainwater, it adversely affects health when the soil itself is directly ingested as a child puts the ground into a stoma into a play etc. Therefore, assessment of soil toxicity using a defined method is required. I In Japan, the Soil ...

  • EDXRF Analysis of Sulfur and Other Elements in Oil

    The concentrations of sulfur substances in fuel oil, which greatly contribute to air pollution and acid rain, are regulated by law in many countries, and these regulations are becoming stricter with the growing concern about their impact on the environment and the consequences for society. Here, using the easy-to-operate EDX-720 energy dispersive X-ray fluorescence spectrometer, we determined the ...

  • ICP Analysis of Multiple Elements in Drinking Water

    The amount of water typically consumed by an adult is said to be about two liters per day, and nearly all of this is tap water or mineral water, generally referred to as "drinking water." Conducting safety inspections are the responsibility of each country according to their respective regulations. Typically, there are many target elements included in the test, such as sodium (Na), calcium ...

  • Finite element analysis of turbine generator rotor winding shorted turns

    Abstract Online magnetic flux monitoring via permanently installed air-gap flux probes is a well- established technology to determine the presence of shorted turns in a turbine generator rotor winding. Flux measurements are normally performed using flux probes installed in the machine air gap (on a stator wedge) and connected to portable or permanently installed instruments. In this ...

  • Finite element analysis of slip damping in riveted built–up beams

    Damping in built–up structures is produced by the energy dissipation due to micro–slip along the frictional interfaces. A finite element model of the linear elastic system has been formulated using the Euler–Bernoulli beam theory to investigate the damping phenomena in riveted connections. The discrete element system having two degrees of freedom per node representing ν and ∂v/∂x has been used ...


    By Inderscience Publishers

  • Finite element analysis of buried continuous pipeline subjected to fault motion

    Pipeline generally extends over long distances traversing through wide variety of different soils, geological conditions and regions with different seismicity. Most analytical models developed in the past for pipeline fault crossing are of limited usage as models developed were useful only for strike slip fault. Incorporating the large geometric changes in analytical study is a tricky task; ...


    By Inderscience Publishers

  • Determination of Trace Elements in Lead for Battery Applications using Atomic Absorption Analysis

    Sample and Standard Preparation procedures for Trace Elements in Lead [1] Preparation of Lead (Pb) Samples: Drill Pb metal to make small pieces. Weigh 2.0 grams of these pieces on a balance. Place the sample in a 400ml Pyrex breaker and add 10ml H2O, 2.5 grams of tartaric acid and 7ml HNO3. Warm on a hot-plate until the sample dissolves. Dilute to 100ml in a volumetric flask with water (H2O). ...


    By Buck Scientific Inc

  • Optimal finite element modelling for modal analysis of liquid storage circular tanks

    Model analysis of liquid storage vertical tanks is a complex task due to fluid–structure–soil interaction. Analysis of tanks subjected to earthquake excitations using finite element modelling (FEM) has become a preferred technique. The FEM is validated by comparing its results with experimental and theoretical results in the literature. However, most finite element studies in literature do not ...


    By Inderscience Publishers

  • Group-IV and V ion implantation into nanomaterials and elemental analysis on the nanometre scale

    Novel group-IV and V nanomaterials are produced by newly set-up low energy ion implantation and electron beam annealing (EBA) systems at GNS Science. This review paper introduces the community to GNS's new nanotechnology systems. Three representative examples on the use of the systems for nanotechnology research and development are given for (a) subsurface lead ion implantation into Si resulting ...


    By Inderscience Publishers

  • Firmness evaluation of melon using its vibration characteristic and finite element analysis

    Analysis of the vibration responses of a fruit has been suggested as a non-destructive measure of its elastic properties (firmness). In this study, 'Huang gua' melons were excited using three types of balls (wooden, steel and rubber) and the vibration was detected by an accelerometer. The modulus of elasticity of the inner, middle and outer portions of melon flesh were determined using flat plate ...


    By Inderscience Publishers

  • Theoretical analysis and finite element modelling of composite ferrocement–concrete beams

    Composite ferrocement–concrete beams have been introduced in the literature as a viable alternative for the conventional reinforced concrete beams. This paper presents a proposed theoretical and a three–dimensional non–linear finite element models for simulating and analysis of composite ferrocement–concrete system. The theoretical and the finite element models were used to analyse ten composite ...


    By Inderscience Publishers

  • Thermal Response to Fire of Insulated Cylindrical Steel Elements

    Standard calculation methods are used in current design practice in the United States to determine the fire resistance rating of structural steel elements protected with spray-applied fire resistive materials (SFRMs). These calculation methods are based on simplified analysis of heat transfer through the SFRM material to the steel substrate. This analysis assumes one-dimensional heat transfer in ...


    By SAGE Publications

  • Element patterns for particulate matter in stormwater effluent

    Particulate matter in stormwater deteriorates the quality of receiving water and sediment. Characterization of stormwater particulate matter by means of its particle-associated element pattern provides an aid to determining its impact on receiving surface waters. During a 6 month measurement campaign, we determined particle-associated concentrations of major pollutants and rare earths for three ...


    By IWA Publishing

  • Application of set pair analysis based on the improved five-element connectivity in the evaluation of groundwater quality in XuChang, Henan Province, China

    The evaluation of groundwater quality plays an important part in the evaluation of groundwater resources. It analyses the temporal and spatial distributions and utilisation of underground water according to the main components and corresponding water quality standards for underground water. Thereby, it can provide a scientific basis for the development, utilisation, planning, and management of ...


    By IWA Publishing

  • Fuzzy finite element analysis of multi–group neutron diffusion equation with imprecise parameters

    In this paper, multi–group neutron diffusion equation with imprecise parameters has been solved using proposed fuzzy finite element method. The proposed method is demonstrated by investigating the neutron fluxes viz. thermal and fast group fluxes of a benchmark problem ANL–BSS–6–A2. Various parameters such as thermal conductivity, diffusion, group fission and neutron interaction constants are ...


    By Inderscience Publishers

  • Faults detection by finite element analysis of a multi cracked beam using vibration signatures

    In this paper, analysis for fault identification in a cracked beam has been carried out. Theoretical, finite element and experimental analyses for identification of the crack depths and their positions in a beam containing multiple transverse cracks are carried out. It has been established that a crack in a beam has an important effect on its dynamic behaviour. The strain energy density function ...


    By Inderscience Publishers

  • On-site elemental analysis of drywall with the Thermo Scientific Niton XL3t series XRF analyzer

    Application Reports of headaches, nosebleeds, central nervous system disorders, and other serious health effects have been reported from those exposed to compounds emitted from Chinese drywall (CDW). Additionally, surface corrosion of metal objects, including jewelry, decorative plumbing fixtures, HVAC coils, and electrical wires have resulted in cosmetic and mechanical damages. These ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you