emission control system Articles

  • Overview of Emission Control Technologies

    Chapter 8. Emission Control Technology 8.4 Thermal Oxidation 8.4.1 INTRODUCTION The objective of this section is to present various VOC thermal oxidation technologies, their strength and weaknesses and the elements required to determine what is the preferred technology for a given application. In 1970 the environmental authorities started to identify various industries which had ...

  • Greenhouse Gas Emissions Control

    Most of the time, people think about Greenhouse Gas (GHG) emissions with carbon dioxide, which is the most common of the GHGs. While fairly typical, carbon dioxide isn’t the only GHG U.S. Environmental Protection Agency (EPA) regulates.  Since EPA has begun regulating GHG emissions under its Clean Air Act authority, sources of emissions from others may require add-on air pollution ...

  • Effective control of fugitive emissions

    Are you Building a brand new process and want to get through the permit process quickly? Looking for ways to further reduce emissions? Under an order from U.S. Environmental Protection Agency (EPA) to further reduce emissions? With EPA continually pressuring industry to reduce emissions, control of fugitives is increasingly important to your overall emissions ...

  • Metal Coating Emission Control

    The use of regenerative thermal oxidizers is expanding into applications where they wouldn’t have been considered years ago, says Mike Scholz As the first generation of oxidizer systems in the industry nears the end of their service life, many canmaking plants face repair or replacement of their existing air pollution control systems. Like many others in the industry, a Silgan canmaking ...

  • Innovative Dryer and Emission Control System at a Particleboard Installation

    In 1989, Bohemia Corporation installed a new primary drying system and also air pollution control equipment at their particleboard plant in Eugene, Oregon. The drying system was composed of a Westec America triple-pass rotary drum dryer fired by a Coen sanderdust burner. The primary and secondary particulate collectors installed were also of a Westec America design. The tertiary air pollution ...


    By Lundberg, LLC

  • EPA Increases Ammonia Emissions Control

    Concern about ammonia emissions in the air and the water continues to grow, both officially and unofficially. As U.S. Environmental Protection Agency (EPA) moves to further reduce ammonia concentrations in surface waters, common water treatment methods transform what had been a water pollution problem into an air pollution issue. Earlier this year, EPA released its draft Integrated Risk ...

  • Carbon Fiber Emission Control Strategies

    Problem Carbon fiber (fibre) and graphite reinforced polymers are materials that have, and will continue to revolutionize the products we use everyday by making them stronger, lighter and more durable. However, the manufacturing process can have serious environmental ramifications and immediate danger to human health if careful consideration is not given to emission control at the ...

  • Put energy into emission control projects

    Many companies feel pressured to spend the least amount possible to meet environmental regulations, primarily because compliance isn’t a profit generating endeavor. What some environmental and compliance managers fail to realize is that emission control equipment can quickly become a profit decreasing endeavor with this penny wise-pound foolish approach. With mandatory greenhouse gas (GHG) ...

  • Hydrocarbon evaporative emissions & control for automotives

    Even the cleanest and most efficient vehicle on the market today still pollutes the air and otherwise damages the environment. Motor vehicles emit several noxious pollutants which vehicle emissions standards are designed to regulate. Vehicles generally emit Hydrocarbons (HC), Carbon monoxide (CO), Nitrogen oxides (NOx) and Fine airborne particulate matter (PM) as pollutants that require control. ...

  • Sale of by-Product HCl Covers Cost of Emission Control System

    Problem: Some of the specialty chemical processes at a major chemical manufacturer's plant result in considerable HCl loading in the off-gas. The HCl must be removed before the off-gas can be discharged to the atmosphere. Production of saleable by-product HCl solution was an important goal when looking for a high-efficiency HCl removal system. The company wanted to achieve a very low ...


  • Plant reduces utility expenses with new emission control system - Case Study

    The steadily increasing natural gas prices near the end of 2004 were becoming a substantial operating cost burden on a facility producing automolive painl and coatings and developing coating products. The major consumers of natural gas at this facility were the main system of boilers which supplied steam energy throughout ihe facility and two Regenerative Thermal Oxidizers (RTOs) which controlled ...

  • Wastewater Treatment Plant Installs Covers & Scrubber System to Control Odor Emissions

    Twenty-five miles west of Dayton, Ohio is the county seat for Preble county - Eaton, Ohio, population 8,000. As the only city in this largely rural county, Eaton finds itself the focus of residential and commercial development transforming it into a bedroom community for Dayton as well as Cincinnati 50 miles to the south. Participating in this transformation is the Eaton Wastewater Treatment ...


  • Hydrogen Sulfide Continuous Emission Monitoring of Odor Control Systems

    ABSTRACT This paper discusses the use of the Sycamore Continuous Emissions Monitor (CEM) for monitoring Hydrogen Sulfide Gas concentrations within odor control systems. The CEM is configurable as a single, two or three point system and can measure from 5 ppb to 2 PPM, 0.1 – 20 PPM, and 0 – 200 PPM and is designed for monitoring of scrubbers, carbon adsorbers, biofilters and biotrickling ...

  • Potential of biofiltration for VOCs emission control and safety aspects

    Directive 99/13/EC on the emission of Volatile Organic Compounds (VOCs) is impacting on several industries in Italy, as well in other EU countries. Many small enterprises have to invest in new control systems and need to be helped to choose an appropriate and safe technology. As VOCs are highly flammable compounds, high concentrations in emission flows can pose a fire and explosion hazard if ...


    By Inderscience Publishers

  • Bionomic Boiler MACT Emission Control Technologies

    Introduction Bionomic Industries' extensive line of field-proven, cost effective wet and dry scrubber and electrostatic technology choices can easily and economically help you achieve compliance with EPA Boiler MACT regulations for hydrochloric acid, particulate or mercury control. Bionomics' wide range of equipment enables selection of the best control technology to remove a specific or ...


    By Bionomic Industries Inc.

  • Case study - Reactor vent emission control

    OVERVIEW Many chemical and petroleum companies use batch reactors to make their products.  These reactors typically have vents which are opened and closed during emptying, filling, mixing, heating or cooling and other steps of the production process.  The gases coming from these vents must be controlled under most government regulations.  Generally speaking, the ...

  • Monitoring and control of CO emissions in parking structures

    Until recent years most parking garage owners and managers did not realize the detrimental effects that carbon monoxide emissions from motor vehicles have on the air quality inside parking garages. With increasing awareness of indoor air quality, astute parking garage owners and managers place great importance on the reduction of CO in parking garages. Ventilation systems are a must for today's ...


    By Conspec Controls Limited

  • Controlling Stack Emissions in the Wood Products Industry

    Electrostatic precipitation has been a reliable technology since the early 1900's. Originally developed to abate serious smoke nuisances, the manufacturers of zinc, copper, and lead quickly found electric gas cleaning a cost efficient way to recover valuable product carried out of the stacks from furnace operations. Today electrostatic precipitators are found mainly on large power plants, cement ...


  • Case study - Kiln emission control technologies

    Overview A specialty ceramic material manufacturer in the United States operates several custom-built furnaces in their manufacturing process.  Sometimes referred to as kilns, these high-temperature process devices are generally a major source of air pollutants and require an abatement technology to meet environmental regulations with the state or federal agencies.  As is the ...

  • Boise Plants Benefit from Innovative Emissions Control Systems

    Fulfilling a U.S. Environmental Protection Agency (EPA) abatement agreement, Boise Building Solutions has successfully installed and implemented two innovative emissions control systems at its Elgin, Ore. plywood plant and LaGrande, Ore. particleboard plant, thanks to an alliance group that includes Pro-Environmental, M-E-C, TurboSonic and Prototech. ARTICLE REPRINTED FROM PANEL WORLD MAY 2004. ...


Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you