emissions testing service Articles

  • Emission Testing and Monitoring

    Presented in Track B4: EMISSION TESTING & MONITORING at EUEC 2011, January 31 Phoenix, Arizona B4.1  | Update on PM2.5 and Condensable Particulate Matter Emissions Measurement Methods Larry Hottenstein |  Partner, Environmental Resources Management Following the promulgation of the PM2.5 ...

  • Gas turbine compliance emissions test case study

    CKwas retained by Lake Road Generating Company, LP (Lake Road) to conduct a compliance emissions test program on three combustion turbine and heat recovery steam generators (CT/HRSG). The purpose of this program is to demonstrate that emissions from the CT/HRSGs are within the emission limits specified in the operating permit issued by the Connecticut Department of Environmental Protection ...


    By CK Environmental, Inc.

  • Mobile Stationary Source Emissions Testing, Coming to a Facility Near You?

    Last week, Antea Group had the unique opportunity to perform a RATA (relative accuracy test audit) of the emissions from a thermal oxidizer at an ethanol production facility located in Minnesota using a state-of-the-art mobile testing laboratory. During this RATA audit, actual stack emissions levels (including NOx, SOx, CO2, CO, O2, flow rate, temperature, velocity and pressure) from the ...


    By Antea Group - USA

  • Forklift Emissions Analyzers

    Forklifts are commonly used in warehouses of various size and capacity for the movement and shipping of goods; however, the unoptimized engines can produce excess quantities of silent and deadly CO gas that can risk the health and safety of the workers. When forklifts are brought in for service usually the CO gas isn't measured. If the CO gas isn't measured and the engine properly optimized then ...

  • Continous Emission Monitoring (CEMs)

    Presented in Track B1: CEMs at EUEC 2011,January 31 Phoenix, Arizona   B1.1  | Particulate CEM for wet FGD plant William Averdieck |  Managing ...

  • Modeling emissions from offshore drilling

    To regulate drilling activities proposed by oil and gas companies in the oil-rich Gulf of Mexico (GOM), governing agencies require the submittal and approval of certain plan documents before drilling activities can be initiated. For drilling activities in the Western GOM, these plans typically consist of one of the following: EP, or Exploration Plan – required to conduct ...


    By Trinity Consultants

  • Reduced Emissions for Landfill Gas Installations

    The use of landfill gas as a source of renewable energy is increasing. For environmental and safety reasons, the owners of the waste storage sites have to strictly monitor and control the construction, operations, and emissions generated. Sulzer offers solutions to control these emissions within the limits given by the government. Landfill gas is similar to natural gas, but it is created by ...


    By Sulzer

  • Minimizing Refrigerant Emissions in HVAC Systems

    Managing the operation and maintenance of a facility's air conditioning equipment has always been a major responsibility, as chillers often represent the single largest electrical load in a facility. Since the annual cost of operating chillers is a major ...


    By IHS

  • A cure for Environmental Emissions case study

    Disposing of nearly 1 million pounds of medical waste a month is no easy task. The wet electrostatic precipitator, installed at Rochester, MN-based Mayo Clinic, seems to be just what the doctor ordered. While the medical waste incinerator at Mayo Clinic in Rochester, MN, consistently met state and federal emission requirements, facility leadership recognized that installing a wet electrostatic ...


    By Bionomic Industries Inc.

  • Reduce Emissions and Odors with Shand & Jurs’ Expanda-Seal

    With reducing emissions having an increased importance, Shand & Jurs offers Expanda-Seal™ technology. Expanda-Seal™ is a patented seal on pressure relief devices that will significantly reduce emissions and odors in every process environment imaginable while also saving valuable product.  While industry standards have a tested leakage rate of 1 SCFH at 90% of ...

  • Continuous Emissions Monitoring Equipment – Guidance & Selection

    There has never been such a wide range of analysers and systems available for continuous emissions monitoring as there is today. In the UK there are over 12 manufacturers and distributors offering CEMS (continuous emissions monitoring systems) using a variety of technologies including UV and IR absorption, FTIR, DOAS, chemiluminescence and photoacoustic spectroscopy (PAS). The majority of CEMS ...

  • Performance specification YY: Specifications and test procedures for Xray fluorescence based multi-metals continuous emission monitoring systems at stationary sources case study

    Performance Specification YY details the performance requirements for a multi-metals continuous emissions monitor that utilizes x-ray fluorescence (XRF) as an analytical technique. Each XRF based multi-metals CEMS must meet the criteria for accuracy, stability, and instrumental response laid out in this document. In addition, every XRF multimetals CEMS must meet the installation requirements in ...

  • Sensitivity of AERMOD in Modeling Fugitive Dust Emission Sources

    Dispersion modelers have long faced challenges estimating ambient pollutant concentrations caused by releases from “fugitive” sources of particulate matter, such as paved and unpaved roadways, raw material storage piles, outdoor material processing operations, agricultural activities, or windblown dust in general. Fugitive emissions are commonly defined as those that could not ...

  • Wastewater Treatment Plant Monitors Greenhouse Gas Emissions

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

  • RSD technology for MBTA bus fleet emissions

    Exhaust emissions from transit buses have long been a concern for air quality officials. Agencies have been investing millions of dollars in advanced and clean fuel technologies to reduce emissions from their bus fleets. Generally, the only information available about the emission characteristics of these vehicles comes from expensive engine- and chassis-dynomometer tests. Relatively little is ...

  • Mayo finds technical fix to reduce incinerator emissions

    While the medical waste incinerator at Mayo Clinic in Rochester, Minn., consistently met state and federal emission requirements, facility leaders wanted to find a way to go beyond these standards. Mayo Clinic’s medical waste incinerator serves Mayo Clinic, Saint Marys Hospital and Rochester Methodist Hospital, which form the largest group medical practice in the world, and processes 2,000 ...


    By Bionomic Industries Inc.

  • In-situ continuous emissions monitoring & regulatory compliance

    As environmental scrutiny has risen and regulation has tightened in recent years, the importance of having accurate information on the environmental performance of your power plant has increased. After all, if you want to manage something, you need to be able to measure it. The analogy is obvious; you wouldn't start a diet without first investing in a set of scales. So it is with Continuous ...

  • `Impacts of Signal Synchronization on Vehicular Emissions,` presented at the 2006 A&WMA annual conference

    Abstract Nearly 56% of nitrogen oxides (NOx) emissions, an important ozone precursor, are produced by mobile sources in the United States. Transportation and air quality managers at the state and regional levels have the responsibility of developing and evaluating Transportation Control Measures (TCMs) to improve regional air quality. Signal synchronization is considered to be an effective ...


    By Trinity Consultants

  • Vibration monitoring and analysis in aircraft engine test cells

    Snecma, part of the SAFRAN group, is dedicated to the production of engines for both air and space. Working alone or in partnership, Snecma designs, develops and produces engines for civil and military aircraft, launch vehicles and satellites. The company is organised in three divisions: Commercial Engines – Snecma and GE Transportation team up to produce the bestselling family of CFM56 ...

  • Black carbon emissions of individual cars measured under real conditions

    Measurements of individual vehicle emissions are usually made in laboratory tests. In this study, researchers followed cars driving in real conditions to measure emissions of air pollutants, including black carbon and nitrogen oxides. The study shows that diesel cars contribute disproportionately to air pollution, and highlights the value of on-road measurements. Vehicle traffic is a major source ...


    By European Commission

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you