exhaust gas analyzer Articles

  • Case study - Engine cell exhaust: Catalytic oxidizer

    Overview Endurance testing of outboard motors for boats has typically been done in lakes and sometimes on barges. This testing was time consuming, presented logistic problems and removed the testing from the R & D department and the factory. When a company in Oklahoma decided to build their own endurance test cell area, the Environmental Protection Agency required them to control the ...

  • Vapor intrusion mitigated through solar-powered exhaust systems

    EPA Region 6 undertook a Superfund removal action earlier this year at the Delfasco Forge site in Grand Prairie, TX, to address trichloroethene (TCE) vapor migrating from a groundwater plume. Region 6 and the State had determined after extensive site investigations that technologies such as soil vapor extraction or natural attenuation would require several years to remove or reduce the plume ...

  • Catalytic Exhaust Emission Control of Small Internal Combustion Engines

    ABSTRACT Gaseous emissions present in the engine exhaust of on-road motor vehicles are subject to stringent exhaust emission 2ontrol standards for carbon monoxide (CO), hydrocarbons, and ...


    By DCL International Inc.

  • Hydrogen Chloride Analyzer (HCl, H2O)

    LGR's Hydrogen Chloride Analyzer (HCl, H2O) provides sensitive measurements of HCl in ambient air or in industrial process flows (e.g., coal and cement exhaust streams) with extremely high precision and sensitivity. No longer do you have to spend a lot of money or wait a long time to measure HCl with extremely high sensitivity – LGR's HCl Analyzer provides measurements every second with ...

  • Sulfur Compounds Analyzer MEXA-1170SX

    The MEXA-1170SX is a continuous gas analyzer for sulfur compounds existing in engine emissions. It can measure SO2 concentration and the amount of total reduced sulfur compounds (TRS), such as H2S, separately. It can also measure the total sulfur compounds (TS) that contains both gaseous compounds and liquid compounds in PM, such as SO3. By utilizing ultra-violet fluorescence (UVF) method and ...


    By HORIBA Europe GmbH

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Wastewater Treatment Plant Monitors Greenhouse Gas Emissions

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

  • Selecting and Placing Gas Detectors for Maximum Application Protection

    Many industrial processes involve dangerous gases and vapors: flammable, toxic, or both. With the different sensing technologies available, and the wide range of industrial applications that exist, selecting the best sensor and locating them properly for the job at hand can be a challenge. To ensure a high level of safety, know the latest sensing technologies, which technology is best for the ...

  • Low-mass PM analyzer MEXA-1370PM — Improvement of the Performance for PM Composition Analysis —

    Particulate matter (PM) emitted from engines is currently measured by the filter weight method. The filter weight method passes diluted emission gases through a filter collecting the PM, and post test weighs the mass of the collected PM on a precision balance. However, this method is time consuming, and with decreasing PM emission volumes, improvements in accuracy were needed. So the MEXA-1370PM ...


    By HORIBA Europe GmbH

  • Comparing TGA, FTIR and fixed filter infrared analyzers for measuring soot levels in in-service lubricants

    Measuring soot in diesel engine oil has become more important as soot levels get higher due to exhaust gas recirculation. As soot isone of the key indicators for the condition of the oil, diesel engine maintenance programs performing regular soot checks can realize cost savings by extending drain periods and reducing used oil disposal. TGA (Thermal Gravimetric Analysis) is the traditional method ...


    By Spectro Scientific

  • New Approach allows Subscribers to Reach the Summit of the Mountain of Information on Gas Turbine and Reciprocating Engine Technology

    The available information on combustion, flow control, treatment and environmental compliance for gas turbines and reciprocating engines is doubling every few years. It is now more challenging than climbing Mt. Everest to find the most current and relevant information. Rapid developments include zero liquid discharge (ZLD) technologies, repairable valves, high efficiency air inlet filters, ...


    By The McIlvaine Company

  • Thank You All for the Success of MEXA-7000

    The MEXA-ONE, our new Motor Exhaust Gas Analyzer launched in 2012, has become our core product superseding the MEXA-7000 with a surge in the number of shipments since the beginning of 2014. The MEXA-7000 had evolved continually over the nineteen years since its introduction in 1995 to respond to the significant changes that took place in emission regulations, types of fuel and new technology in ...


    By HORIBA Europe GmbH

  • Detecting Gases: What You Can`t Smell Can Hurt You

    Walking through a drill-site area, a worker smells rotten eggs and stops tor a minute or two to assess where a gas leak might exist. Rubbing his itchv eves as he investigates further, he notices that he no longer smells the tell¬tale hydrogen sulphide odour. He does not realize that the gas has deadened his olfactory senses and unless he leaves the area within seconds, he could lose ...

  • New technology for municipal scale compost operations

    There is a new facility located in Ontario, Canada that accepts construction and demolition waste (C&D) and 100,000 TPY of source separated organics (SSO) waste. The owners chose a new non-thermal plasma (NTP) system to control the odor in its 120,000 cubic feet of air per minute (CFM) air emissions. This NTP system is very compact, fits easily on a platform, is configured as a number of ...

  • In-situ investigation of the cathode catalysts for PEM fuel cells using differential electrochemical mass spectrometry

    Differential electrochemical mass spectrometry (DEMS) involves applying a potential across an electrochemical cell and measuring the resulting current while concurrently analyzing gas products with a mass spectrometer. We used DEMS to investigate the mechanism of carbon support corrosion (CSC) in-situ at the cathode of proton exchange membrane fuel cell (PEMFC). The cathode exhaust gases were ...


    By Hiden Analytical

  • A cost-effective method for controlling compost air emissions

    In October 2007, ECS began conducting trials at California State University Fresno (CSUF) to explore using the new patent pending AC Composter (ACC) covered aerated static pile system to manage dairy manure solids and comply with airquality standards. A two-zone portable pilot system was delivered by ECS and installed at the CSUF research dairy. This research is being conducted under a Phase I ...


    By Engineered Compost Systems

  • Nitrogen Oxides Reactions in Diesel Oxidation Catalyst

    ABSTRACT Two catalyst formulations were tested OII a diesel engine. A Fourier Transform Infrared (FTIR) analyzer was used to measure concentrations of nitric oxide ...


    By DCL International Inc.

  • Air Pollution Control in the Printing and Web Coating Industries

    For many U.S. companies in the printing and web coating business, the use of an Air Pollution Control System (APCS) to control harmful air pollutants is not new.  In these industries, depending upon their location, companies have been installing APCS since the early 1970's.  However, for some companies the clock is still ticking regarding their compliance with local, state and federal ...


    By The CMM Group, LLC

  • CIRAS-2 User Recalibration of CO2 and H2O

    The CIRAS-2 CO2/H2O analyzer is an inherently stable instrument and does NOT require frequent calibration. The AutoZero function corrects for nearly all changes that result in calibration drifts. The most common causes of drifts in CIRAS-2 readings are i) incorrect Zeros due to exhausted chemicals or ii) leaks on the desiccant columns from rolled or damaged o-rings and iii) incorrect Diff Bal, ...


    By PP Systems

  • Thermal Desorption-GC/MS Analysis of polycyclic aromatic hydrocarbons on fine particulates in air

    Polycyclic aromatic hydrocarbons (PAHs) are commonly found throughout the environment in soil, water and adsorbed to fine particulate matter in air. Of the 16 common PAHs, 7 have been classified as animal carcinogens by the International Agency for Research on Cancer (IARC). Resulting from this classification, PAHs are monitored and regulated in the environment. Analysis of PAHs in soil and water ...


    By PerkinElmer, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you