fid hydrocarbons analyzer Articles

  • Analyzing for Trace CO and CO2 using a Total Hydrocarbon Analyzer

    Untitled Document The purity of Specialty Gases is determined by the measurement of various contaminants including Total Hydrocarbons. Low level measurements of carbon ...


    By MOCON, Inc. - Baseline

  • Real Time TOC Analysis in Steam and Condensate

    Executive Summary Steam in petro/chemical plants could be contaminated with hydrocarbons (TOC = Total Organic Carbons) from various sources. In any case this is a sign for defects in the process, whether it they occur in the heat exchanger, the blow down vessel, the condensate recovery or other parts of the system. Conventional solutions to monitor such contaminations use TOC- ...


    By JCT Analysentechnik GmbH

  • Analysis of Natural Gas Products by GC / TCD / FID

    The complex mixture of condensible hydrocarbons and permanent gases in a natural gas product has historically been separated on gas chromatographs equipped with dual columns and a switching valve. The light gases are separated from heavier compounds on a molecular sieve column, which is then backflushed onto a suitable column to separating the rest of the mixture. The Buck Scientific Model 910 ...


    By Buck Scientific Inc

  • Determination of Total Petroleum Hydrocarbons in Soil, Sediment, and Waste Samples using the SpeedExtractor E-916

    Total petroleum hydrocarbons (TPH) are a family of several hundred chemical compounds made from crude oil. TPH are found in soils and water. Exposure to TPH can affect human health and, therefore many laboratories around the world are analyzing TPH levels in the environment. This application note describes the extraction of TPH from soil, sediment, and waste samples using the SpeedExtractor ...


    By BÜCHI Labortechnik AG

  • Analysis of trace hydrocarbon impurities in 1,3-Butadiene using optimized RT-Alumina BOND/MAPD plot columns

    Abstract Identifying and quantifying trace impurities in 1,3-butadiene is critical in producing high quality synthetic rubber products. Standard analytical methods employ alumina PLOT columns which yield good resolution for low molecular weight hydrocarbons, but suffer from irreproducibility and poor sensitivity for polar hydrocarbons. In this study, Rt-Alumina BOND/MAPD PLOT columns were ...


    By Restek Corporation

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Case study - Texas crude oil in soil sites

    Sunset Well Service, Inc. is an environmental contractor located in the Midland/Odessa area of Texas. They use their UVF-3100D analyzer to help excavate and remediate soils contaminated by produced water and crude oil. Laboratories in Texas test TPH using the TX 1005 GC-FID Method. This method is similar to U.S. EPA Method 8015M, but reports the GRO, DRO and ORO fractions separately. Soils from ...


    By Sitelab Corporation

  • Case study - EPH in soil with diesel and home heating oils

    Sitelab’s UVF-3100 analyzer is a popular tool when excavating soils contaminated by fuel oils from underground storage tanks (USTs). These studies show the accuracy testing samples for Extractable Petroleum Hydrocarbons, EPH C11- C22 aromatic hydrocarbons. Samples are extracted in solvent using test kits and measured on the UVF analyzer’s EPH optics, calibrated to Sitelab’s PAH ...


    By Sitelab Corporation

  • TVOC measurement for LEED/green building evaluation

    Total Volatile Organic Compounds (TVOC) may be evaluated when building designers/managers are pursuing the Leadership in Energy and Environmental Design Green Building Rating System for New Construction (LEED-NC) EQ Credit 3.2. The latest LEED-NC guidance document specifies that the maximum allowed concentration of TVOC measured in a building (post construction, pre-occupancy) is 500 µg/m3; the ...


  • Energy Savings on Process Heating Units Case History

    The Customer This specialty chemical company is a leading supplier of performance polymers. Their products are used in a wide range of applications including adhesives, coatings, consumer and personal care products, sealants, lubricants, medical, packaging, automotive, paving, roofing and footwear products. The Project The company was increasing the ...

  • Triad expedites brownfields redevelopment in Fairbanks

    The Fairbanks North Star Borough (FNSB) used Triad in 2006-2007 to assess environmental conditions at a municipal property along the Chena River in Fairbanks, AK. FNSB accelerated the site investigation as part of a brownfields assessment grant received from the U.S. EPA in 2005. Low-level contamination had been identified onsite in past investigations, but its extent and impact on future ...

  • A Chemical Dynamics Model for CAH Remediation with Polylactate Esters.

    ABSTRACT: The polylactate esters of sorbitol, xylitol and glycerol are a class of new chemical compounds that slowly release lactic acid into groundwater. The lactic acid is biotransformed into pyruvic acid and subsequently into acetic acid releasing hydrogen in both steps. The hydrogen is used by naturally occurring dechlorinating bacteria to reduce PCE to ethene by way of TCE, DCE and VC. A ...


    By REGENESIS

  • Designing and Implementing Perimeter Air Monitoring Programs

    Perimeter or fenceline ambient air quality and meteorological monitoring programs have become increasingly valuable at hazardous waste, landfill, dredging, ports, and MGP remediation sites. Air quality monitoring programs protect public health and reduce owner liability ...


    By AECOM

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you