flame detection instrument Articles

  • Two Detector Solution to Analyzing Sulfur

    Sulfur compounds are reactive, corrosive to pipes, and destructive to catalysts in petroleum refineries. Sulfur emission are strictly regulated globally. When released into the atmosphere sulfur dioxide converts to sulfuric acid resulting in adverse effects on human health and the environment. Sulfur detection is found useful in many other industries; therefore, detection of sulfur compounds in ...


    By Restek Corporation

  • Benefits of HART Communication-Enabled Gas and Flame Detectors

    Catastrophic results can occur when a fire or a flammable/toxic gas release goes undetected in any petrochemical facility. For early warning and prompt hazard mitigation, flame detectors and gas detectors are essential tools. Clear, usable, diagnostic information from these detection instruments is extremely valuable in ensuring the devices are properly maintained, tested, and poised to protect ...

  • Fire and Gas Protection Systems as Part of Safety Instrumented Systems and Risk Management

    Garth Watkins, Director Europe, Middle East, Africa, Detector Electronics Corporation, Presented at HazardEx International Conference 2008 Process-systems operators today face increasing demands for lower costs and higher safety standards in an increasingly regulated environment. In addition, companies desire to provide a working environment that is as safe as possible. As a result, plant owners ...

  • Texas Instruments - A Novel Separation Technique for the Analysis of Trace Levels of Atmospheric Contaminants in Inert Semiconductor Process Gases

    A NOVEL SEPARATION TECHNIQUE FOR THE ANALYSIS OF TRACELEVELS OF ATMOSPHERIC CONTAMINANTS IN INERTSEMICONDUCTOR PROCESS GASES J. Scott McWilliams, Alan Johnson, Charlene Long, Jeremiah D. Hogan*Texas Instruments, Inc.Dallas, TX 75265 Low ppb detection limits for contamination in cylinder gases have been achieved with gas chromatography using a modified gas ...


    By Environics, Inc.

  • Stack gas VOC monitoring

    POLLUTION S.r.l. manufactures POLARIS FID analyzer, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Screening of organic contaminants in urban snow

    Snowmelt is known to cause peak concentrations of pollutants, which may adversely affect receiving water quality. High concentrations of metals and suspended solids in snow have been reported, whereas studies on organic pollutants are rare. This study aims at investigating the occurrence of anthropogenic organic compounds in urban snow in Gothenburg (Sweden). The most frequently detected organic ...


    By IWA Publishing

  • The Portable FID for Stack Emissions: lightweight, compact, ergonomic, safe

    POLLUTION S.r.l. manufactures POLARIS FID analyser, a cutting-edge technology for the measurement of total hydrocarbons in ambient air and stack emission monitoring in accordance with EN 13526 and EN 12619. This analyser is based on Flame Ionization Detection (FID), a reference method technique to measure total hydrocarbons (THC, VOC, TOC). Polaris FID is a very handy instrument because it allows ...


    By Pollution Srl

  • Building on a legacy of PID development

    Summary From the 1970s to the present day, photo-ionisation detectors (PIDs) have been at the front line of efforts to detect volatile organic compounds. As industrial hygiene has become ever more important and exposure limits for VOCs have reduced, PID technology has continued to develop, providing reliable detection under challenging environmental conditions at concentrations right down to ...


    By Ion Science

  • TVOC measurement for LEED/green building evaluation

    Total Volatile Organic Compounds (TVOC) may be evaluated when building designers/managers are pursuing the Leadership in Energy and Environmental Design Green Building Rating System for New Construction (LEED-NC) EQ Credit 3.2. The latest LEED-NC guidance document specifies that the maximum allowed concentration of TVOC measured in a building (post construction, pre-occupancy) is 500 µg/m3; the ...


  • Analyzing for Trace CO and CO2 using a Total Hydrocarbon Analyzer

    Untitled Document The purity of Specialty Gases is determined by the measurement of various contaminants including Total Hydrocarbons. Low level measurements of carbon ...


    By MOCON, Inc. - Baseline

  • Are your field soil screening procedures providing you with practical and accurate information?

    Untitled Document Environmental consulting activities frequently require that on-the-spot decisions be made in the field concerning the ...


    By Enviro-Equipment, Inc.

  • Meeting Safety Requirements: “Certified SIL Capable”

    Life-saving safety equipment is becoming increasingly important in a wider cross-section of companies. So, at the same time, there is a growing trend to adopt best practices for the management of safety systems. Now industrial clients are looking for new design or upgrades to a plant to be in line with the Safety Instrumented System (SIS) standards of IEC61508* in addition to fire and gas system ...

  • The determination of major and minor elements in air filters and urine for hazard assessment, using a new CCD DUAL-VIEWED ICP optical emission spectrometer

    This article describes the application of a new type of CCD-based, dualviewed ICP optical emission spectrometer for the analyses of industrial hygiene types of samples. Several trace elements in air filter media are determined by ICP-OES. Urinary electrolytes and trace elements are determined in a single dilution automatically in both the axial and radial plasma viewing orientations. Results of ...


    By PerkinElmer, Inc.

  • Identifying Leaks from Natural Gas Pipelines at a Safe Distance

    The use of natural gas, of which methane is the principle component, is increasing worldwide. According to the American Petroleum Institute methane meets 24% of U.S. energy demand and heats over 50% of all U.S. households. It also has many industrial uses, such as the manufacture of chemicals like ammonia, methanol, butane, ethane, propane and acetic acid; it is also an ingredient in products as ...

  • Gas Safety in Confined Spaces

    Introduction A confined space is any space large enough for someone to enter and perform assigned work, which has limited means of entry or exit, and which is not designed for continuous worker occupancy. This covers just about every industry, including utilities, construction, hydrocarbon exploration and processing, petrochemicals, marine, agriculture, food processing and brewing, as ...

  • Gas safety in confined spaces

    A confined space is any space large enough for someone to enter and perform assigned work, which has limited means of entry or exit, and which is not designed for continuous worker occupancy. This covers just about every industry, including utilities, construction, hydrocarbon exploration and processing, petrochemicals, marine, agriculture, food processing and ...

  • Smart LDAR — more cost-effective?

    On December 19, 2008, EPA issued a final rule establishing a voluntary Alternative Work Practice (AWP) to detect leaks of volatile organic compounds (VOC) and hazardous air pollutants (HAP) from process equipment (FR Vol. 73, Number 246), thereby providing the regulated community additional flexibility in complying with leak detection and repair (LDAR) requirements. The AWP allows owners or ...


    By Trinity Consultants

  • Solar Panels

    The Customer The Company is a worldwide developer, manufacturer, and distributor of solar electricity panels. The Process The Company uses a multiple zone conventional printing dryer for thin-film deposition onto solar cells. A special foil substrate is passed through rollers that transfer a proprietary ink formulation and epoxy adhesive ...

  • Detailed characterisation of essential oils by flow-modulated GC×GC and Tandem Ionisation mass spectrometry

    Volatile oils of plants, also known as essential oils, have been used for many years for their flavour, fragrance and medicinal properties. However, their extreme complexity and diversity presents analysts with a significant challenge when it comes to quality control. They are generally composed of monoterpenes and sesquiterpenes, as well as their oxygenated derivatives, such as aliphatic ...


    By SepSolve Analytical

  • Upgrading from Pellistor Gas Sensors to Infrared Technology

    In this article Andy Avenell, Crowcon’s Fixed Systems Product Manager, considers the shift towards infrared (IR) gas sensor technology in the oil and gas industry. Abstract Flammable gases and vapours can present considerable dangers in many industrial applications, none more so than the processes involved in extracting, transporting and processing oil and gas. Fast and reliable ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you