flammable safety Articles

  • Flammable Hazards

    Flammable Hazards The difference between a gas and a vapor is that vapors arise from liquids, whereas gases are normally in a gaseous state. Flammable vapors present additional sampling concerns (for example, we must prevent vapors from returning to the liquid state during sampling). The 3 Elements of Fire Three elements must be present for a flammable ...

  • Monitoring flammable gas in boiler houses

    The most common fuels in use for space and water heating are Oil, Natural Gas and Liquid Petroleum Gas (LPG). By far the most popular, clean and cost effective solutions are utilising Natural Gas or LPG. The traditional safety measure derived from the time of oil fired boiler houses is the use of a fusible link placed above the each boiler. The fusible link is intended to melt if it becomes ...

  • Reduce accident and fire risk with flammable storage safety cans

    Flammable or combustible liquids are used in almost every industry and place of business. Gasoline, chemicals, solvents and a variety of other hazardous liquids are found in varying amounts and locations in industrial, commercial and residential settings. Since many of these liquids are relatively common, it is important to understand the dangers they present and the special storage and handling ...


    By Interstate Products Inc

  • Shredding of highly flammable hazardous waste

    Satrind S.p.A. has a consolidated experience in engineering plants with nitrogen blanketing protection system for shredding of highly explosive hazardous waste in previously sealed into proper containers (such as metal or plastic drums, IBC tanks, etc.) and sludge material. During treatment of hazardous wastes, vapors or flammable gases are released with dangerous emissions which are highly ...


    By SatrindTech Srl

  • Who Says Sorbents Cannot Eliminate Flammability ?

    This presentation aims to show the basis for the explosion-hazard elimination action of this microporous zeolitic sorbent. This absorbent spill cleanup-up product is intended for application to flammable liquid spills in order to reduce the flammability hazard and to generate a product that may be disposed of as waste with no flammability hazard.  In order to achieve an appropriate reduction ...


    By Safety DImensions (SDI)

  • Compressed Gas Safety Guide

    Use and storage of any compressed gas under high pressure can be extremely dangerous if proper gas handling procedures are not observed. Moreover, chemical characteristics of specialty gases themselves can pose serious health hazards if containment is not tightly controlled. Paying close attention to a compressed gas product’s technical and safety information is invaluable for maintaining a safe, ...

  • What is Intrinsic safety and ATEX?

    What is intrinsic safety? Intrinsic safety (IS) is a low energy signalling technique that ensures the safe operation of electrical equipment in hazardous areas by limiting the energy – both electrical and thermal – available for ignition. ...


    By Hansford Sensors

  • Purpose and value of safety and health audits

    Untitled Document Purpose and value of safety and health audits Introduction/Overview The word 'audit' puts many ...


  • Potential of biofiltration for VOCs emission control and safety aspects

    Directive 99/13/EC on the emission of Volatile Organic Compounds (VOCs) is impacting on several industries in Italy, as well in other EU countries. Many small enterprises have to invest in new control systems and need to be helped to choose an appropriate and safe technology. As VOCs are highly flammable compounds, high concentrations in emission flows can pose a fire and explosion hazard if ...


    By Inderscience Publishers

  • Carbon Monoxide (CO) and Carbon Dioxide (CO2) Safety

    Know the Gases, Know the Dangers and Protect Yourself Do you know the differences between carbon monoxide (CO) and carbon dioxide (CO2)? If you don’t then there are no guarantees your safety measures will be adequate. These two different gases are often mixed up with people becoming confused over which they need to protect against, when and how. ...


    By SHEilds Ltd

  • Pt. 1 - IN the MIX - Construction Safety and Gas Detection

    This is part one in a 4 part series to be posted over the next 4 weeks. "Pointers for Construction Safety & Health compliance" Rob Sant Technical Products Manager, Certified Air Safety, Vancouver Washington Threats to our workers health and safety are numerous; an often overlooked hazard is the quality of the air they breathe. Whether simple nuisance odors like ...


  • FTIR gas analysis improves container safety

    Introduction Entry to freight containers represents a significant hazard to staff responsible for inspection, stuffing or destuffing because of the large number of airborne chemicals that can be present. Research in Germany and the Netherlands found hazardous levels of gases and vapours in around 20% of all containers and this level of contamination is now accepted as commonplace. It ...


    By Gasmet Technologies Oy

  • A Leap in the Dark – Safety Precautions in Confined Spaces

    Considering the Risks, Preparation and Appropriate PPE Mentioning ‘confined spaces’ probably conjures up some fairly potent claustrophobic – and not entirely pleasant – images in the mind for most. However, do you really know what to look out for and how to address the inherent dangers of entering these spaces? Work within a confined space is likely to be ...


    By SHEilds Ltd

  • 40th anniversary of the Health and Safety at Work Act 1974

    31st July 2014 marked the 40th anniversary of the Health and Safety at Work Act. Also referred to as HSWA or the HSW Act, the Health and Safety at Work Act is the primary legislation covering occupational health and safety in the United Kingdom. Take a look at what exactly this monumental Act involves and what impact it has had on employee health and safety during the last 40 years. ...


    By Pulsar Instruments plc

  • Why instrument hire makes occupational safety sense

    Background Decisions concerning the acquisition of occupational safety monitoring instrumentation are often made by operational staff that may not have visibility of the full financial implications of their choices. The following article will examine the factors affecting these decisions and explain why a strategic decision to hire instrumentation can deliver substantial and wide-ranging ...


    By Ashtead Technology Ltd

  • Process safety and risk management audits for a ceramics manufacturing facility – Case Study

    Challenge Antea Group was contracted by a large, advanced materials organization to provide a Process Safety Management and Risk Management Program compliance audit of a specialty ceramics manufacturing facility in New Hampshire. Processing at the facility is related to the crystalline growth of materials used in the semiconductor manufacturing industry. Processing at the facility ...


    By Antea Group - USA

  • Safety Systems Depend on Reliable Field Sensors (Emphasis on Fire and Gas Detectors)

    Abstract Because not all hazards are the same, identifying and quantifying the hazard is the starting point in choosing sensing technology. Not all detectors are the same, and they should be selected according to their ability to detect the hazard. This paper gives a broad summary of technologies that provide users reliable responses to hazardous conditions, that minimise false ...

  • Auotclaves and Nitrogen. Why an Oxygen Monitor may be Required for Safety

    In many industries, including aerospace, autoclaves play an important role in the manufacturing process. Key components of aerospace systems need to be put under an intense pressure and temperature during their formation; at present, an autoclave offers the best and safest way to do this. However, the manufacturing process usually uses nitrogen to create high levels of pressure in the system and ...

  • Fire and Gas Protection Systems as Part of Safety Instrumented Systems and Risk Management

    Garth Watkins, Director Europe, Middle East, Africa, Detector Electronics Corporation, Presented at HazardEx International Conference 2008 Process-systems operators today face increasing demands for lower costs and higher safety standards in an increasingly regulated environment. In addition, companies desire to provide a working environment that is as safe as possible. As a result, plant owners ...

  • Occupational health and safety - right to know Vs right to understand

    On the heels of yet another federal investigation attributing chemical-related deaths and injuries to defective hazard communications systems in the workplace, few would question that a public health crisis is afoot. More than 30 million American workers are exposed each day to hazardous chemicals at the workplace, with upwards of a halfmillion chemicals being stored and used in today's ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you