floor decontamination Articles

  • Surface Decontamination of Iodine (Potassium Iodide (KI)) by DeconGel®

    OBJECTIVE: Determine the surface decontamination efficacy of DeconGel® 1101 on stainless steel, carbon steel, floor tile, and concrete surfaces contaminated with potassium iodide (KI) using ICP-OES (Inductively Coupled Plasma-Optical Emission Spectroscopy) following ...


    By METIS Scientific

  • R1-348 decontamination @ Ontario power generation

    RP checked and after several masslins left area and posted 5,000 cpm loose Extensive Decontam in this area attempted due to > 10,000 cpm loose, masslins and wet mopping Applying Decon Gel Gel applied 3” up the wall Lesson –tape edge and ensure adequate thickness Drain covered with tape  Peeling up ...


    By METIS Scientific

  • Surface Decontamination of Iodine Compounds (Potassium Iodide (KI)) by DeconGel 1101

    Abstract Surface decontamination efficacy determination of DeconGel™ 1101 on stainless steel, carbon steel, floor tile, and concrete surfaces contaminated with potassium iodide (Kl) was performed with ICP-OES (Inductively Coupled Plasma-Optical Emission Spectroscopy) according to Environmental Protection Agency (EPA) SW-846 Methods: 3005A (sampling) and 6010C (analysis). ...


    By METIS Scientific

  • Surface Decontamination of Halogenated Solvents (Tetrachloroethylene) by DeconGel 1101 and 1102

    Abstract Surface decontamination efficacy determination of DeconGelTM 1101 and 1102 on stainless steel, floor tile, and concrete surfaces contaminated with halogenated solvents (tetrachloroethylene (TCE)) was performed with LC/MS (Liquid Chromatography/Mass Spectrometry) according to Environmental Protection Agency (EPA) SW-846 Methods: 3500C (sampling) and 8321B (analysis). ...


    By METIS Scientific

  • Surface Decontamination of Aromatic Liquids (Toluene) by DeconGel 1101 and 1102

    Abstract Surface decontamination efficacy determination of DeconGelTM 1101 and 1102 on stainless steel, floor tile, and concrete surfaces contaminated with aromatic liquids (toluene) was performed using LC/MS (Liquid Chromatography/Mass Spectrometry) according to Environmental Protection Agency (EPA) SW-846 Methods: 3500C (sampling) and 8321B (analysis). Hazardous ...


    By METIS Scientific

  • Demonstration of DeconGel at Oak Ridge National Laboratory building 2026

    Challenge In 2003 an area behind the hot cells in Building 2026 at the Oak Ridge National Laboratory (ORNL) was flooded with highly contaminated liquids when a liquid low level waste pipe became clogged. The main contaminants of concern are uranium and plutonium. Transferrable contamination levels are in the 1,000,000 disintegrations per minute range. The area is posted as an airborne ...


    By METIS Scientific

  • Environmental incident response, North-East England

    Project Remediation Strategies were requested to attend a manufacturing facility in North-East England following an overnight fire at the site. Fire-fighting operations and the site sprinkler system had created a large volume of contaminated run-off together with widespread flooding across the shop floor area of the manufacturing facility. Productivity was stopped across the ...


    By Remediation Strategies Ltd.

  • The Clean-Up of a Tragedy

    There's been a violent crime, a serious accident, or a suicide has occurred. The police, investigators, and paramedics have left the scene. The remains of this terrible tragedy are still there. You assume the local police, fire department, or the city has someone to take care of this, however, you are told it is up to you. You are the victim, part of the family, the property owner, or local ...

  • Suggested Practice for Remediation of Highly Infectious Biological Agent Contamination in Indoor Environments

    Untitled Document PURPOSE This suggested practice describes those basic procedures to be followed, and precautions ...

  • Asbestos Awareness: Preventing a Hazardous Workplace

    Many on-the-job hazards are obvious... leaking machinery... dangerous chemicals... slippery floors. However, other hazards aren't so obvious. There may be no visible signals that they are present at all. That's why Asbestos is often known as 'the silent killer.' While you often can't see, taste or smell it..., prolonged periods of exposure to Asbestos can cause lung disease, cancer... even death. ...


  • United States Virgin Islands

    Our firm was privileged to perform an indoor air quality related abatement that also had a historical context. This involved an adverse exposure to the Governor of the USVI at the Governor's residence in Catharineberg, St. Thomas. We determined that Stachybotrys and other toxigenic fungi were present in the residence as a result of water leaks from the roof and indirect effects from air ...


    By Indoor Air Solutions, Inc

  • Cleaning and maintenance management march 2002

    While the health risks associated with fluid waste have been known for decades, it wasn’t until the introduction of AIDS into our society that infection control practices and an awareness of the vulnerability to healthcare workers, including custodians, to exposure of bloodborne pathogens, including Heptatities B, became a major concern. Today, a myriad of regulations govern workers’ ...


  • Bioremediating Explosives Contaminated Soil

    From the beginning of World War II until the 1970s, the site that is now the Naval Surface Warfare Center in Crane, Indiana (NSWC-Crane) was the home of a major bomb manufacturing operation. Explosive compounds such as TNT, Royal Demolition Explosives (RDX) and Her Majesty’s Explosive (HMX) were handled loose and drifted through air vents. Often, the material settled on the roofs of buildings, ...


    By BioCycle Magazine

  • Assessment of Environmental ‘Hot Spots’ in Iraq

    Untitled Document Executive summary Introduction In July 2004, the United Nations Environment Programme (UNEP) was awarded a ...


  • FTIR analyser improves anaesthetic gas detection at Torbay Hospital

    A unique gas measurement technology has enabled South Devon Healthcare’s Pharmacy Manufacturing Unit (PMU) at Torbay Hospital to conduct highly effective and detailed analysis of anaesthetic gases in a variety of hospital locations. The primary function of the PMU’s quality control department is to check active ingredient levels and sterility in manufactured pharmaceutical ...


    By Gasmet Technologies Oy

  • Purpose and value of safety and health audits

    Untitled Document Purpose and value of safety and health audits Introduction/Overview The word 'audit' puts many ...


  • Portable lead analyzer to locate source of lead

    OBJECTIVE: To investigate the sources of lead in the environment in children with elevated blood, with the help of a Field Portable X-Ray ...

  • Hazardous Waste Disposal

    Untitled Document Overview We're all aware of the importance of following safety precautions when we work with hazardous chemicals. ...


Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you