flow metering system Articles

  • Portable Hydrant Flow Meters

    Leading the way for hydrant verification flow and pressure measurement Langham Industrial Controls strive to provide the most innovative market leading hydrant verification instrumentation. The Horizontal Standpipe Flow Meter provides unrivalled accuracy of ± 0.5% within a wide flow range. The swan neck design ensures that the AquaMasters electromagnetic sensor is always full and as the ...

  • Senix Water Level Sensors Drive Irrigation Automation Project

    Australia’s Water Crisis Irrigation management is serious business in Australia especially within the Murray-Darling Basin, a 1,000,000 square kilometer watershed that is home to Australia’s most productive agricultural land. The basin’s 23 rivers have ...


    By Senix Corporation

  • Netherlands’ Mobile Emergency Pumps Provide Rapid Flood Response

    The Western European nation has 20 mobile diesel-driven pumps on standby, ready to assist in national and international emergencies. One of the smallest and most densely populated countries in Western Europe, the Netherlands has nearly 10 million residents who live and work below sea level. Without active water management and primary flood defenses, ...


    By BBA Pumps

  • BBA Mobile Emergency Pumps Provide Rapid Response for Floods

    Netherlands’ Mobile Emergency Pumps Provide Rapid Flood Response In its latest edition, the North American PUMPS & SYSTEMS magazine publishes an in-depth article featuring the history and current usage of emergency mobile pumps. The Western European ...


    By BBA Pumps

  • 100 Simple Ways To Save Water

    To improve water conservation install a rain sensor, it turns off your irrigation when it rains. Use a weather-based controller. The use of smart controllers can reduce water usage 24% a year on average. Learn about available rebate programs ...


    By Jain Irrigation, Inc

  • The evolution of thermal mass flow meters

    Who were some of the pioneers in thermal mass flow technology? A. Thermo-Systems, Inc. (TSI) began in its founder’s basement in 1959, with a cooled-film anemometer designed for transient measurements in high temperature fluid flows. This led to TSI’s hot-film and hot-wire anemometers, the first commercial products of this type. These immersion-type devices were used mainly as ...


    By Sierra Instruments, Inc.

  • Permanent Multipath Clamp-On Transit Time Flow Meter

    For many years now, ultrasonic flow measurements with "wetted" sensors have been a well established procedure to measure discharge in big pipes in the field of hydro power plants. A lot of research studies show that very precise measuring results can be achieved, under the provision of correct application and consideration of diverse ancillary conditions. Depending on the flow conditions and the ...


    By HydroVision GmbH

  • Development of a self-rechargeable digital water flow meter

    The objective of this paper is to present the feasibility of a self-rechargeable digital water flow meter (SRDFM) system for water pipes using the latest data processing and wireless communication technologies while causing negligible water pressure drop (head loss). The system uses a Pelton turbine generator to power the electronic circuit, which processes and transmits the signals generated by ...


    By IWA Publishing

  • Implementation of an on-line artificial intelligence district meter area flow meter data analysis system for abnormality detection: a case study

    Faster detection of bursts saves water, minimises the inconvenience of interruption to customers and decreases the damaging consequences to infrastructure. Flow monitoring techniques are used by water service providers to monitor leakage, generally through offline application of mass balance type calculations and manual observations of change in night line values. This paper presents the ...


    By IWA Publishing

  • Valve actuation at the world’s largest flow metering calibration facility

    Currently nearing completion, EuroLoop will be the world’s largest test site for industrial flow meters. Two separate circuits are available, for testing both gas meters and liquid meters. Both circuits are fully automated, making extensive use of electric and pneumatic actuators with sophisticated control systems. Situated by the New Meuse River in Rotterdam, EuroLoop will be the ...


    By Rotork

  • AVFM 5.0 area-velocity flow meter monitors sewage lagoon discharge flow

    The Township of South Glengarry in Eastern Ontario discharges continuously from their 72,000 m3 sewage lagoon. But they ran into flow measurement problems when their magnetic flowmeter was unable to detect seasonal low flow rates. Operations Manager, Shawn Killoran selected a Greyline AVFM 5.0 Area-Velocity Flow Monitor because it was simple to install in a horizontal discharge pipe from the ...


    By Greyline Instruments Inc.

  • Sewer-Flow Survey Project

    Environmontel Ltd Supply of HydroLog4 time-series database and flow data processing system for sewer-flow survey projects Environmontel Ltd, an established flow-survey company based in Worcester, selected HydroLog4 as their sewer-flow survey information system for use by survey teams on short-term drainage-area surveys and other longer-term monitoring projects. The ...

  • Replacement Fill Control Valves with Electronic Flow and Metering Improve Pressure, Stop Leakage and Prevent Valve Failures

    The City of Modesto, California is situated 90 miles east of San Francisco and has approximately 200,000 residents relying on 200,000 of gallons of water a day. The City needed to upgrade three water storage tanks that hold approximately 750,000 gallons each. After years of using motor operated valves to fill water storage tanks, the city recognized that there were just too many problems. ...


    By Singer Valve Inc.

  • Performance monitoring & troubleshooting with a new individual condenser tube circulating water flow and fouling (ClA/FF) meter - case study

    Introduction Midwest Generation Joliet Station in Illinois has two coal-fired units, Unit 7 and Unit 8. Roth 550 MW units are located on the Des Plaines River and have been in operation since 1963-1964. The circulating water system is a once-through system comprised of a bar rack, traveling screens, circulating water pumps and reversible condensers. The original condenser tubes on Unit ...


    By Intek, Inc.

  • Wastewater Plant Relies on Thermal Flow Meter for Co-Gen Power Gas Blending Process

    The Rahway Valley Sewerage Authority (RVSA), which operates a large wastewater treatment plant in New Jersey, embarked on a green co-generation waste-to-energy project to power a portion of its operations. The plant performs primary, secondary, tertiary and sludge treatment processes in serving over 250,000 residential customers and 3000 industrial and commercial customers in a 40-plus square ...


    By Modern Pumping Today

  • New Developments in Thermal Dispersion Mass Flow Meters: In-The-Field Compensation for Changes in Natural Gas Composition

    Introduction The flow of natural gas in pipelines is often complicated by changes in the composition of the gas. The method described in this paper solves the problem of variable composition via a new four-temperature mass flow sensor. The new (low sensor feeds its measurements into the algorithms of an advanced mathematical model that includes gas properties in its calculations. The method ...


    By Sierra Instruments, Inc.

  • Non-contacting solution for Plugged off flow meters in the oil patch - Case Study

    For years Petrobakken Energy Ltd. used inline turbine flow meters to track the flow rate of oil recycled to treaters. But with a high concentration of wax and sand in the oil, the turbine meters were quickly plugging off. The line had to be shut down at least once a day and the turbine flowmeters disassembled for cleaning. This was troublesome and expensive. Petrobakken knew there had to be a ...


    By Greyline Instruments Inc.

  • Optimal meter placement for pipe burst detection in water distribution systems

    Pipe bursts in water distribution systems (WDS) must be rapidly detected to minimize the loss of system functionality and recovery time. Pipe burst is the most common failure in WDS. It results in water loss out of the system, increased head losses, and low pressure at the customers' taps. Therefore, effective and efficient detection of pipe bursts can improve system resilience. To this end, ...


    By IWA Publishing

  • Analytical model for uni–directional flow passive soil vapour extraction system

    An analytical one–dimensional model has been developed to examine the uni–directional barometric pumping in passive Soil Vapour Extraction (SVE) system. The model is applicable to a special case in which a radial flow field is insignificant. The system considered contains two unsaturated zone layers, an upper contaminated low permeability layer and a lower high permeability layer contains a well ...


    By Inderscience Publishers

  • Leakage fault detection in district metered areas of water distribution systems

    Fault tolerance and security in drinking water distribution operations are important issues that have received increased attention in the last few years. In this work the problem of leakage detection is formulated within a systems engineering framework, and a solution methodology to detect leakages in a class of distribution systems is proposed. Specifically, the case where water utilities use ...


    By IWA Publishing

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you