flue gas cleaning system Articles

  • Wet Flue Gas Desulfurization System

    Installing the optimum wet flue gas desulfurization technology, B&V Energy is bringing superior multi-pollutant removal technology to the North American utility marketplace. To help make a positive impact on the global environment and to comply with the Clean Air Interstate and Clean Air Mercury Rules, Dayton Power & Light needed to remain in compliance as more stringent air quality ...


    By Black & Veatch Corporation

  • The Influence of PVC on the Quantity and Hazardousness of Flue Gas Cleaning Residues from Incineration

    The study estimates the influence of PVC on the quantity and hazardousness of flue gas residues from incineration. The analysis has been carried out on both theoretical and practical terms. A distinction between dry, semi-dry and wet gas treatment systems has been made. The influence of PVC has been assessed on the combustion steps and therefore on the distribution of chlorine and other ...

  • TurboScrubber® & TurboStripper® ‘TURBOCC’ Technology, for Flue Gas Cleaning & Carbon Capture System for Enhanced Plant Growth

    The plant would be supplied in a number of preassembled skid mounted packages for installation and connection on site. Typically these packages would comprise:  TurboScrubber®, water sump, recirculation pumps (run & standby), local water circulation pipework, forced or induced draft flue gas fan and local flue gas ductwork.  TurboStripper®, water sump, recirculation ...

  • Dosing and mixing of powdered activated carbon for flue gas applications

    Subject: Powdered activated carbon (PAC) is dosed in dry powder form into flue gas for the removal of dioxins, furanes, mercury and other heavy metals from flue gases. Gericke supplies complete solutions for the handling of bulk solids. These complete installations are characterized by their clean, accurate, trouble- and dustfree operation. Application: Furnaces, incinerators, sinter ...


    By Gericke

  • Recyclone MH System to Reduce Particulate Matter from a coal or palm shell BFB Boiler Flue Gas below 150mg/Nm3 - Case Study

    Foreword Advanced Cyclone Systems, S.A. (ACS) designed and supplied a Mechanical Recyclone (Recyclone MH) for Basuki Pratama Engineering. Basuki, based in Pulogadung (Jakarta, Indonesia) is the Indonesian leading producer of non-polluting high efficiency steam boilers, as well as thermal oil heaters using fluidized bed combustor or chaingrate stoker. The installed ...

  • Advanced WESP designs assure superior gas cleaning performance

    Nowadays, many industries are facing formidable environmental challenges and there is a growing need for effective, economical gas cleaning and air pollution control equipment. Michael Beltran of Beltran Technologies, Inc. reports on a renewed interest in high-efficiency wet electrostatic precipitators (WESPs) and discusses their importance for controlling sulphuric acid mists and other ...


    By Beltran Technologies, Inc.

  • The Right Mix for Clean Air

    Reducing air pollution is an increasingly important topic all around the world. Many governments—also in developing countries—set new limits for emissions such as nitrogen oxides in flue gas. Sulzer offers advanced mixing technology for flue gas cleaning. The installation in a large power plant shows that these high-performance mixers can cope with the most difficult requirements. ...


    By Sulzer Management Ltd

  • Clean air for Moorburg

    The energy site of Moorburg at the Port of Hamburg hosts one of the most modern hard coal-fired power plants in the world: as one of the leading electricity producers in Europe and operator of the plant, Vattenfall focuses on environmental protection and resource conservation. The flue gas desulphurisation system of the power plant was equipped with wet desulphurisation and innovative technology, ...

  • Controlling acid gas mists

    Gas cleaning New and strict pollution regulations in metallurgical plants worldwide are restricting particulate and acid gas emissions to extremely low levels. Because of that, sulphuric acid plants are being installed to remove and utilise S02 in gases resulting from the roasting of sulphide ores, smelting of ores, and burning or regeneration of spent acid or acid sludge from ...


    By Beltran Technologies, Inc.

  • REVIEW OF CANSOLV® SO2 SCRUBBING SYSTEM FIRST COMMERCIAL OPERATIONS AND APPLICATION IN THE OIL AND GAS INDUSTRY

    Over the past five years, the CANSOLV® system SO2 scrubbing technology has moved from the status of an emerging technology to that of a commercially ...

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Cost-Effective NOx Control for Air-Preheated Systems

    New advancements in combustion control technologies, such as flue gas recirculation (FGR) and low NOx burners (LNB), have made it possible to achieve ultra low NOx levels without using expensive post-combustion flue gas clean-up technology. For some natural draft units it may be possible to meet the most stringent of the NOx regulations with cost-effective combustion control technologies. For ...

  • Rockwood Pigments chooses Beltran System - Case Study

    Rockwood Pigments, a global manufacturer of pigment products, has chosen a wet electrostatic precipitator (WESP) system engineered by Beltran Technologies, Inc.. to clean process gas streams before entering a sulfuric acid plant at its Easton, Pa., manufacturing facilities. Rockwood is the world's second laraest manufacturer of iron oxide and other inorganic color pigments used by paint and ...


    By Beltran Technologies, Inc.

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By SIGRIST - PHOTOMETER AG

  • Industrial Wastewater Treatment: Priority pollutant behaviour in on-site treatment systems for industrial wastewaters

    The majority of wastewaters deriving from the chemical industry consist of aqueous discharges produced during the physico-chemical processing of synthetic mixtures involving operations such as filtration, centrifugation, extraction and/or distillation. The wastewater streams, referred to as ‘process waters’ can include mother liquors, washing waters from the purification of products, ...


    By IWA Publishing

  • Pollutant emissions from modern incinerators

    Emissions of dioxins are mainly from incinerators, domestic and industrial coal combustion, and traffic. However, the major public concern and research effort are associated with the emissions of organic micropollutants from waste incinerators. This paper gives a brief overview of the more recent research and development for the removal of dioxins and heavy metals from flue-gas streams. Special ...


    By Inderscience Publishers

  • Precipitator Solves Dryer Problem

    Plum Creek Manufacturing, Columbia Falls, Montana, installed a PPC Industries electrostatic precipitator to solve a direct fired dryer dust plugging problem. The electrostatic precipitator was installed in a very congested area and the project had to be done so the dryer was off-line a minimal amount of time. Plum Creek personnel relocated existing equipment, poured concrete footings, ran all of ...

  • EVALUATION OF STRATEGIES FOR MERCURY MACT COMPLIANCE

    On December 15, 2003, the United States Environmental Protection Agency (U.S. EPA) proposed a rule with two alternatives to permanently reduce mercury (Hg) emissions from power plants. Under one alternative, which is the focus of this paper, the utilities would install controls known as Maximum Achievable Control Technologies (MACT) under section 112 of the Clean Air Act (CAA). The proposed rule ...


    By Trinity Consultants

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you