flue gas condensation Articles

  • The Flakt-Hydro process: flue gas desulfurisation by use of seawater

    ABB's seawater scrubbing process (the Flakt-Hydro process) for flue gas desulfurisation has recently triggered much interest among power producers because of its simple operating principle and high reliability. The process uses seawater to absorb and neutralise sulfur dioxide in flue gases. The absorbed gas is oxidised and returned to the ocean in the form it originated in the first place, namely ...


    By Inderscience Publishers

  • Controlling acid gas mists

    Gas cleaning New and strict pollution regulations in metallurgical plants worldwide are restricting particulate and acid gas emissions to extremely low levels. Because of that, sulphuric acid plants are being installed to remove and utilise S02 in gases resulting from the roasting of sulphide ores, smelting of ores, and burning or regeneration of spent acid or acid sludge from ...


    By Beltran Technologies, Inc.

  • Pakistan SZS Gas Fired Steam Boiler

    Heavy Oil, Light Oil, Residual Oil, Natural Gas, City Gas, and Blast Furnace Gas can be used as Fuel. The boilers can also be applied to generate electricity at some districts where electricity power is in short. So are a variety of industrial productions, living and remote areas, and oil field. Even they can be used as a power plant boiler startup. SZS series oil & gas boilers are ...


  • Removal of ecologically harmful pyrolysis gas and vapours

    Type     HOFGAS®- IFM4c/1000 Commissioning     August 2002 Site     Waste water treatment plants Situation As a result of new authority requirements, Romag AG set up operation of a plant for the drying and gasification of wastewater sludge. Drying vapours are formed during the sludge drying and pyrolysis gas during gasification. These emissions must be burned in an ecological way, ...


    By Hofstetter BV

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Advanced WESP designs assure superior gas cleaning performance

    Nowadays, many industries are facing formidable environmental challenges and there is a growing need for effective, economical gas cleaning and air pollution control equipment. Michael Beltran of Beltran Technologies, Inc. reports on a renewed interest in high-efficiency wet electrostatic precipitators (WESPs) and discusses their importance for controlling sulphuric acid mists and other ...


    By Beltran Technologies, Inc.

  • Case study - Ljusdal Energi, Sweden

    At Ljusdal Energy, a shell & tube-condenser is installed. The technique takes a bit more space and gives almost the same performance as a lamella type. However, the customer desired tube technology. The condenser will handle the flue gases of two boilers that can be in operation independently. Boiler: 2×10 MW Fuel: Biofuels ...


    By Envibat AB

  • Case study - Jämtlands Värme, Strömsund

    The boiler for Jämtlands Värme in Stromsund was built in 1987.  The old flue gas condenser, from another supplier, began leaking and needed to be replaced. Boiler: 10 MW Fuel: Bio fuels Condensor effect: 2 MW The boiler in Strömsund was built in 1987 and in 1994 it was equipped with a flue gas ...


    By Envibat AB

  • First industrial application of an open absorption cycle for heat transformation in a district-heating network

    The first plant for high temperature utilisation of higher heating value was realised under industrial conditions in a combined heat and power plant. The technology results in an increased heat recovery temperature and a stronger dehumidification of the flue gas. Beyond that, the use of large solution flow within an adiabatic absorber enables to combine gas scrubbing and dehumidifying. Economic ...


    By Inderscience Publishers

  • Case study - HOTAB, Norway

    Hotab chose Envibat’s flue gas condensation in its boiler plant, delivered to Statkraft , Sandefjord in Norway. The plant is built on lamella technology providing a compact design while performing good temperature efficiency. Boiler size: 2×4 MW Fuel: Biofuel Envibat has supplied a condensor for Air Pollution Control for flow gases ...


    By Envibat AB

  • Corrosion Problems Arisen from the Use of Alternative Combustibles

    Introduction Metal Corrosion has been a subject of growing important in cement furnaces during the past few years. This development is mainly a result of the tendency to use alternative fuels with ...


    By Castolin Eutectic

  • Gatineau Sewage Treatment Plant, Gatineau, Quebec, Canada

    Project No. 1 Industrial Boiler Application A FLU-ACE waste heat recovery system installed to process all flue gases from three boilers. The system recovers up to 3.5 mmBTU/h of waste heat which is re-used for heating the digester sludge. The main fuel for the boilers is recycled methane based sewage gas generated from the plant’s anaerobic digesters. 'The installation ...

  • Industrial Wastewater Treatment: Priority pollutant behaviour in on-site treatment systems for industrial wastewaters

    The majority of wastewaters deriving from the chemical industry consist of aqueous discharges produced during the physico-chemical processing of synthetic mixtures involving operations such as filtration, centrifugation, extraction and/or distillation. The wastewater streams, referred to as ‘process waters’ can include mother liquors, washing waters from the purification of products, ...


    By IWA Publishing

  • Membrane Distillation and Applications for Water

    SummaryWater treatment is an important auxiliary process in all thermal cogeneration plants. In this context membrane distillation (MD) is a novel technology that is potentially advantageous to technologies like reverse osmosis in the following ways: ability to utilize low-grade heat, reduced sensitivity to fluctuations in pH or salt concentrations, and lower capital and O&M costs. This ...


    By Xzero AB

  • Wasting energy through steam loss

    The European Union Directive on the Energy Performance of Buildings, which relates to all member nations of the European Union, are obliged to set limits on greenhouse gas emissions, particularly from buildings. Typically steam is used for a wide range of applications within larger establishments including, humidification, hot water, space heating and air heating.  Primary energy losses in ...

  • Minimization of Major Air Pollutants from Sewage Sludge Fluid Bed Incinerators

    ABSTRACT Emissions of major air pollutants including carbon monoxide (CO), nitrogen oxides (NOx) and mercury (Hg) were studied at two sewage sludge fluidized bed combustion (FBC) plants. Both the North West Bergen (NWB) County Utility Authority and the Little Miami (LM) plants have air pollution control systems (APCS) that are of the wet type. Various operating conditions such as temperature, ...

  • Why You Should Consider a Sample Conditioning Unit for Taking Low NOx Measurements When Using a Portable Emissions Analyzer

    Using state-of-the-art technology, we here at E Instruments create high-quality portable industrial combustion gas and emissions analyzers that are capable of taking precise, low NOx measurements for both NO and NO2. In particular, we recommend our sample conditioning unit to those of you who need to take accurate, low NOx or SO2 ...

  • Rockwood Pigments chooses Beltran System - Case Study

    Rockwood Pigments, a global manufacturer of pigment products, has chosen a wet electrostatic precipitator (WESP) system engineered by Beltran Technologies, Inc.. to clean process gas streams before entering a sulfuric acid plant at its Easton, Pa., manufacturing facilities. Rockwood is the world's second laraest manufacturer of iron oxide and other inorganic color pigments used by paint and ...


    By Beltran Technologies, Inc.

  • AngloGold Ashanti chooses Beltran WESP - Case Study

    AngloGold Ashanti Brasil Mineracao is a leading producer of gold in the world. AngloGold was working on production plans for the Cuiaba Gold Mining Expansion Project located at Nova Lima, Minas Gerasis. The plant's production capacity is projected to be equivalent to 400 metric tons of sulfuric acid per day. The Promon Company worked on the design, procurement, construction and assembly services ...


    By Beltran Technologies, Inc.

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you