flue gas condenser Articles

  • The Flakt-Hydro process: flue gas desulfurisation by use of seawater

    ABB's seawater scrubbing process (the Flakt-Hydro process) for flue gas desulfurisation has recently triggered much interest among power producers because of its simple operating principle and high reliability. The process uses seawater to absorb and neutralise sulfur dioxide in flue gases. The absorbed gas is oxidised and returned to the ocean in the form it originated in the first place, namely ...


    By Inderscience Publishers

  • What is a Condensing Boiler and How Does it Work?

    It can be all too easy to get confused about the different types of boilers and which is right for you. Today, it’s all about the condensing boiler, and building regulations specify that any new boiler installed in the UK should be a condensing type. But what are these boilers all about, and how are they different to regular boilers? What is a condensing boiler? ...


    By Green Business Watch

  • Controlling acid gas mists

    Gas cleaning New and strict pollution regulations in metallurgical plants worldwide are restricting particulate and acid gas emissions to extremely low levels. Because of that, sulphuric acid plants are being installed to remove and utilise S02 in gases resulting from the roasting of sulphide ores, smelting of ores, and burning or regeneration of spent acid or acid sludge from ...


    By Beltran Technologies, Inc.

  • Pakistan SZS Gas Fired Steam Boiler

    Heavy Oil, Light Oil, Residual Oil, Natural Gas, City Gas, and Blast Furnace Gas can be used as Fuel. The boilers can also be applied to generate electricity at some districts where electricity power is in short. So are a variety of industrial productions, living and remote areas, and oil field. Even they can be used as a power plant boiler startup. SZS series oil & gas boilers are ...


  • Removal of ecologically harmful pyrolysis gas and vapours

    Type     HOFGAS®- IFM4c/1000 Commissioning     August 2002 Site     Waste water treatment plants Situation As a result of new authority requirements, Romag AG set up operation of a plant for the drying and gasification of wastewater sludge. Drying vapours are formed during the sludge drying and pyrolysis gas during gasification. These emissions must be burned in an ecological way, ...


    By Hofstetter BV

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Advanced WESP designs assure superior gas cleaning performance

    Nowadays, many industries are facing formidable environmental challenges and there is a growing need for effective, economical gas cleaning and air pollution control equipment. Michael Beltran of Beltran Technologies, Inc. reports on a renewed interest in high-efficiency wet electrostatic precipitators (WESPs) and discusses their importance for controlling sulphuric acid mists and other ...


    By Beltran Technologies, Inc.

  • Case study - Ljusdal Energi, Sweden

    At Ljusdal Energy, a shell & tube-condenser is installed. The technique takes a bit more space and gives almost the same performance as a lamella type. However, the customer desired tube technology. The condenser will handle the flue gases of two boilers that can be in operation independently. Boiler: 2×10 MW Fuel: Biofuels ...


    By Envibat AB

  • Case study - Jämtlands Värme, Strömsund

    The boiler for Jämtlands Värme in Stromsund was built in 1987.  The old flue gas condenser, from another supplier, began leaking and needed to be replaced. Boiler: 10 MW Fuel: Bio fuels Condensor effect: 2 MW The boiler in Strömsund was built in 1987 and in 1994 it was equipped with a flue gas ...


    By Envibat AB

  • Saving waste in the boiler house

    Burner technology has improved greatly in recent years. Older Burners had a series of cams and levers that were calibrated to provide specific amounts of air for a particular rate of firing. Being mechanical items, these wore and sometimes required calibration. They, therefore, had to be regularly serviced and calibrated. Generally, new burners use frequency controlled motors and cams to open air ...


    By EBE Engineering Ltd.

  • First industrial application of an open absorption cycle for heat transformation in a district-heating network

    The first plant for high temperature utilisation of higher heating value was realised under industrial conditions in a combined heat and power plant. The technology results in an increased heat recovery temperature and a stronger dehumidification of the flue gas. Beyond that, the use of large solution flow within an adiabatic absorber enables to combine gas scrubbing and dehumidifying. Economic ...


    By Inderscience Publishers

  • Case study - HOTAB, Norway

    Hotab chose Envibat’s flue gas condensation in its boiler plant, delivered to Statkraft , Sandefjord in Norway. The plant is built on lamella technology providing a compact design while performing good temperature efficiency. Boiler size: 2×4 MW Fuel: Biofuel Envibat has supplied a condensor for Air Pollution Control for flow gases ...


    By Envibat AB

  • Thermal Energy International Raises The Bar On Thermal Efficiency At Stand H41 At Energy Solutions Expo

    Thermal Energy International Inc. (TEI) will be exhibiting its range of awarding winning energy efficiency products at stand H41 at the Energy Solutions Expo at Olympia, London on the 11th and 12th October.  TEI’s products include its GEM venturi orifice steam traps and its flue gas condensing heat recovery ...

  • Case study - WESPs: Securing a cleaner future for power-generating facilities

    This article explains why wet electrostatic precipitators remain a viable technology for dealing with today's increasingly stringent compliance issues. Despite recent, recession-related volatility in both power generation and consumption, industry analysts expect a resumption of long-term growth trends as continued global demand for energy — in both developed and developing nations ...


    By Beltran Technologies, Inc.

  • Corrosion Problems Arisen from the Use of Alternative Combustibles

    Introduction Metal Corrosion has been a subject of growing important in cement furnaces during the past few years. This development is mainly a result of the tendency to use alternative fuels with ...


    By Castolin Eutectic

  • Gatineau Sewage Treatment Plant, Gatineau, Quebec, Canada

    Project No. 1 Industrial Boiler Application A FLU-ACE waste heat recovery system installed to process all flue gases from three boilers. The system recovers up to 3.5 mmBTU/h of waste heat which is re-used for heating the digester sludge. The main fuel for the boilers is recycled methane based sewage gas generated from the plant’s anaerobic digesters. 'The installation ...

  • Industrial Wastewater Treatment: Priority pollutant behaviour in on-site treatment systems for industrial wastewaters

    The majority of wastewaters deriving from the chemical industry consist of aqueous discharges produced during the physico-chemical processing of synthetic mixtures involving operations such as filtration, centrifugation, extraction and/or distillation. The wastewater streams, referred to as ‘process waters’ can include mother liquors, washing waters from the purification of products, ...


    By IWA Publishing

  • Membrane Distillation and Applications for Water

    SummaryWater treatment is an important auxiliary process in all thermal cogeneration plants. In this context membrane distillation (MD) is a novel technology that is potentially advantageous to technologies like reverse osmosis in the following ways: ability to utilize low-grade heat, reduced sensitivity to fluctuations in pH or salt concentrations, and lower capital and O&M costs. This ...


    By Xzero AB

  • Wasting energy through steam loss

    The European Union Directive on the Energy Performance of Buildings, which relates to all member nations of the European Union, are obliged to set limits on greenhouse gas emissions, particularly from buildings. Typically steam is used for a wide range of applications within larger establishments including, humidification, hot water, space heating and air heating.  Primary energy losses in ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you