flue gas emissions testing Articles

  • Emission Testing and Monitoring

    Presented in Track B4: EMISSION TESTING & MONITORING at EUEC 2011, January 31 Phoenix, Arizona B4.1  | Update on PM2.5 and Condensable Particulate Matter Emissions Measurement Methods Larry Hottenstein |  Partner, Environmental Resources Management Following the promulgation of the PM2.5 ...

  • Capture of carbon dioxide from flue gas using solid regenerable sorbents

    Carbon dioxide emissions from the combustion of fossil fuels are a significant factor in global climate change. Large stationary sources such as coal-fired electric generating plants are likely to be the most cost-effective targets for carbon dioxide capture. At present, liquid amine-based scrubbing systems are the only processes available for this application. Processes based on regenerable ...


    By Inderscience Publishers

  • Flue gas Hg measurements from coal-fired boilers equipped with wet scrubbers

    The U.S. EPA has indicated they are considering additional SO2 and NOx emission reductions, and EPA is under a consent agreement to propose mercury reduction regulations by 2004 for the utility industry. The boiler manufacturers and the utility industry have developed improved combustion modification techniques to reduce NOx emissions. These advanced ...


    By Inderscience Publishers

  • Continous Emission Monitoring (CEMs)

    Presented in Track B1: CEMs at EUEC 2011,January 31 Phoenix, Arizona   B1.1  | Particulate CEM for wet FGD plant William Averdieck |  Managing ...

  • Performance of the low-emission flare

    Job report / Elbisgraben (Bale / Switzerland) The summer of 1992 had finally arrived. The 5MW low emission furnace in the district heating station Liestal was ignited, supplied with landfill gas from Elbisgraben landfill. Since then the plant has been running continuously and the comprehensive measurements taken, verify that all targets aimed at have been achieved: plant ...


    By Hofstetter BV

  • Ford Motor Co. Ltd reduce emissions by 5.1% on gas fired boiler plant using Maxsys Fuel Systems.

    As part of an ongoing objective to reduce emissions and conserve energy at the Ford Motor Company’s Dunton Technical Centre, Maxsys Fuel Systems have been fitted to the boiler plant, helping the company to achieve over 5% reduction in gas usage with a commensurate reduction in emissions. The Energy Committee at Dunton decided to investigate ways of reducing gas usage by improving ...


    By Maxsys Fuel Systems Ltd

  • New laser-based dust emission monitoring system

    Abstract A new generation of continuous particulate matter concentration monitoring instruments is presented, covering a measuring range of 0 to 1000 mg/m3. The laser-based scattered light instrument gives an improved stability as well as excellent resolution in the low range. This enables high concentration measurement as well as especially low emission monitoring down to 0.01 mg/m3 with a ...


    By SIGRIST - PHOTOMETER AG

  • Development and Implementation of an Alternative Emissions Monitoring Program for Carbon Monoxide Compliance for Fluidized Catalytic Cracking Unit CO Boilers

    This paper presents the results of an alternative emissions monitoring test program for the Fluidized Catalytic Cracking Unit (FCCU) CO boilers at major oil refinery. Alternative emissions monitoring systems can be used in lieu of other compliance monitoring techniques (e.g., periodic emissions testing, continuous emissions monitoring) to relate monitored operating conditions which might indicate ...

  • Development and Implementation of an Alternative Emissions Monitoring Program for Carbon Monoxide Compliance for Fluidized Catalytic Cracking Unit CO Boilers

    This paper presents the results of an alternative emissions monitoring test program for the Fluidized Catalytic Cracking Unit (FCCU) CO boilers at major oil refinery. Alternative emissions monitoring systems can be used in lieu of other compliance monitoring techniques (e.g., periodic emissions testing, continuous emissions monitoring) to relate monitored operating conditions which might indicate ...

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • A chemo-biological treatment of scrubbing water from power plants with recovery of value-added products

    A chemo-biological approach for treating sulphate-rich effluent generated during wet scrubbing of flue gas emissions from fossil fuel fired power plants has been discussed. Microbial sulphate reduction was carried out in an anaerobic up-flow packed bed bioreactor (R1) using ethanol as carbon source. More than 90% of Total Equivalent Sulphate (TES) present in the effluent was reduced to sulphide ...


    By Inderscience Publishers

  • Cleaning the Air We Breathe, Coal Fired Power Plant - Case Study

    By cleaning flue gases from coal power plants, the amount of environmentally hazardous emissions can be sharply reduced. Mist elimination from Munters is a critical part of this process. Munters has worked with leading power generating companies for decades and have through testing and follow up built an extensive parameter database and design tool to be able to adapt and optimize results based ...


    By Munters Zeol Division

  • OTM 17: Determination of Metal Concentrations Using Filters and Solid Sorbents in XRF Analyisis case study

    Eli Lilly and Company (Lilly) operates a waste incineration system located at the Tippecanoe Laboratories in Lafayette, Indiana. This incinerator system includes an Xact multi-metals continuous emissions monitoring system (Xact-CEMS, manufactured by Cooper Environmental Services, LLC) for demonstrating attainment with the Hazardous Waste Combustor MACT for semi-volatile metals, low-volatile ...


    By Cooper Environmental

  • Saving waste in the boiler house

    Burner technology has improved greatly in recent years. Older Burners had a series of cams and levers that were calibrated to provide specific amounts of air for a particular rate of firing. Being mechanical items, these wore and sometimes required calibration. They, therefore, had to be regularly serviced and calibrated. Generally, new burners use frequency controlled motors and cams to open air ...


    By EBE Engineering Ltd.

  • The Right Mix for Clean Air

    Reducing air pollution is an increasingly important topic all around the world. Many governments—also in developing countries—set new limits for emissions such as nitrogen oxides in flue gas. Sulzer offers advanced mixing technology for flue gas cleaning. The installation in a large power plant shows that these high-performance mixers can cope with the most difficult requirements. ...


    By Sulzer

  • Aqua ammonia process for simultaneous removal of CO2, SO2 and NOx

    Experimental research work in applying aqueous ammonia solution for the simultaneous reduction of acidic gaseous emission from fossil fuel-fired utility plants is currently being performed at the National Energy Technology Laboratory. The traditional monoethanolamine process for CO2 removal suffers the disadvantages of low carbon dioxide loading capacity, equipment corrosion, amine degradation by ...


    By Inderscience Publishers

  • The Chemical Route to a Carbon Dioxide Neutral World

    Excessive CO2 emissions in the atmosphere from anthropogenic activity can be divided into point sources and diffuse sources. The capture of CO2 from flue gases of large industrial installations and its conversion into fuels and chemicals with fast catalytic processes seems technically possible. Some emerging technologies are already being demonstrated on an industrial scale. Others are still ...


    By SusChem

  • Case study - Bespoke Solutions

    PROJECT 5000kg/h animal remains incineration project in accordance with EU WID Makkah, Kingdom of Saudi Arabia PROJECT DESCRIPTION The purpose of the plant was to dispose of the animal waste associated with Hajj religious festi-val in Makkah Saudi Arabia. During the festival approximately 10,000 tonnes of waste is pro-duced in 4-5 days. Historically ...


    By Todaysure Limited

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you