flue gas exchanger Articles

  • Numerical simulation and field test study of desulfurization wastewater evaporation treatment through flue gas

    Aimed at cost saving and pollution reduction, a novel desulfurization wastewater evaporation treatment system (DWETS) for handling wet flue gas desulfurization (WFGD) wastewater of a coal-fired power plant was studied. The system's advantages include simple process, and less investment and space. The feasibility of this system has been proven and the appropriate position and number of ...


    By IWA Publishing

  • Pakistan SZS Gas Fired Steam Boiler

    Heavy Oil, Light Oil, Residual Oil, Natural Gas, City Gas, and Blast Furnace Gas can be used as Fuel. The boilers can also be applied to generate electricity at some districts where electricity power is in short. So are a variety of industrial productions, living and remote areas, and oil field. Even they can be used as a power plant boiler startup. SZS series oil & gas boilers are ...


  • Saving waste in the boiler house

    Burner technology has improved greatly in recent years. Older Burners had a series of cams and levers that were calibrated to provide specific amounts of air for a particular rate of firing. Being mechanical items, these wore and sometimes required calibration. They, therefore, had to be regularly serviced and calibrated. Generally, new burners use frequency controlled motors and cams to open air ...


    By EBE Engineering Ltd.

  • The Right Mix for Clean Air

    Reducing air pollution is an increasingly important topic all around the world. Many governments—also in developing countries—set new limits for emissions such as nitrogen oxides in flue gas. Sulzer offers advanced mixing technology for flue gas cleaning. The installation in a large power plant shows that these high-performance mixers can cope with the most difficult requirements. ...


    By Sulzer

  • Biomass fired thermal oil heater case study

    This 12 MWth output Biomass Power Plant is one of the turnkey products of Biomass Power. The plant was fully commissioned in December 2006. The system has a capacity of 12 MW thermal output producing up to 10MWth of 300°C 10 Barg pressure hot oil, up to 10 tonnes per hour of steam and 2 MWth of 200°C hot air. This is all achieved from one grate heating three separate heat exchanges. The ...


    By Biomass Power Limited (BPL)

  • Case study - Mission Linen Supply, Santa Barbara, California, USA

    “A number of years ago Sid Abma of Sidel Systems USA Inc. approached us with his Sidel SRU flue gas heat recovery unit. I think that we, like most companies, considered it; but we took no action for some time. Finally a situation developed that made it beneficial for us to try this unit. We purchased a unit and had it installed in July of 2006. A second unit is in the process of being ...


    By Sidel Systems USA Inc.

  • Wastewater Treatment & Recycle

    Fresh water is a scarce commodity; this fact is well acknowledged by one and all. People at all levels be it general public, governmental bodies, and industries understand the implications of good quality water availability in terms of quantity, cost and wastage. As a consequence, there is a growing consensus on wastewater treatment for recycle/reuse. This paper briefly describes the treatment ...

  • How to make your waste disposal process pay for itself

    Incineration waste to energy means you can get FREE HEAT! It’s true to say that the first priority of any of the industrial waste incinerators we design and manufacture is to provide an efficient, cost-effective, environmentally responsible and legally compliant waste disposal system. ...


    By Todaysure Limited

  • 4.5 MWe Refuse Derived Fuel to Energy Plant Case Study

    This 4.5 MWe Biomass Power Plant is one of the turnkey products of Biomass Power. The plant has a capacity of 24 MW thermal and rated at 4.5 MWe producing 35,476MWh of green electricity per year, 100% of which is exported to the grid. The fuel used is segregated biomass from a commercial and industrial waste collection business. The fuel is produced by removing some of the recyclable material ...


    By Biomass Power Limited (BPL)

  • 2 MWe Biomass Power Plant Case Study

    This 2 MWe Biomass Power Plant is one of the turnkey products of Biomass Power. The plant was fully commissioned in September 2007. The plant has a capacity of 11 MW thermal and rated at 2MWe producing 15,700 MWh of green electricity per year, 100% of which is exported to the grid. The fuels used are from forestry and agricultural residues, wet woodchips, compost oversize, straw and miscanthus, ...


    By Biomass Power Limited (BPL)

  • NOx in Non-Utility Industries - Part II - Control options and monitoring methodology

     This the second in a two-part series. Part I, which appeared in our June 2001 issue focuses on air emission origins of nitrogen oxides (NOx) in non-utility industries. Choice of the NOx control technology is dependent on many factors, including regulatory requirements, technical feasibility, cost and public perception. Figure 1, compiled based on publications [1-5], presents a summary of ...


  • NOx in Non-Utility Industries - Part I NOx in Non-Utility Industries - Part I - Air emission origins, best control solutions and monitoring methodology for nitrogen oxides

     Problems with reducing nitrogen oxides (NOx) are widespread in the general process industries. These industries, together with medium size utility and power generators contribute about 15 percent of global NOx emissions. The emission sources addressed include various heaters employed in chemical and petrochemical plants, nitric and sulfuric acid plants, glass furnaces, iron and steel mills, ...


  • What is a Condensing Boiler and How Does it Work?

    It can be all too easy to get confused about the different types of boilers and which is right for you. Today, it’s all about the condensing boiler, and building regulations specify that any new boiler installed in the UK should be a condensing type. But what are these boilers all about, and how are they different to regular boilers? What is a condensing boiler? ...


    By Green Business Watch

  • Glass Manufacturing Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Efficient steam production in paper mills

    The paper and pulp industry is an energy and emission intensive industry. Steam is an essential part of the paper making process with steam boilers, steam distribution systems and other processes accounting for a large percentage of a paper mill’s energy costs. Useful energy is often lost from boilers and process equipment such as heat exchangers, dryers, evaporators etc, as well as from ...

  • Tuning Your Boiler for EPA Boiler MACT Compliance

    The EPA’s Boiler MACT regulations are heating up. Boiler MACT is an EPA rule to limit hazardous air pollutants (HAP) from commercial and industrial boilers and process heaters. Originally proposed in 2011 as a mandate driven by the Clean Air Act,  the rules are Area Source Boiler MACT 40 CFR 63, subpart JJJJJJ for smaller boilers (stores, hotels, apartments, ...


    By Sierra Instruments, Inc.

  • Water Sustainability

    I7.1  | Water Optimization – 30% Groundwater Use Reduction Tabatha Pellerin, Senior Program Manager, AECOM AECOM assisted the Entergy Lewis Creek gas/coal fired electric power plant with water conservation efforts prompted by a goal of 30% ...

  • Superinsulated Houses

    Superinsulated building is a method of energy-efficient construction that can be adapted to any structure, commercial or residential, in any climate. A superinsulated (SI) home can save 75% of the annual energy costs for heating and cooling compared to a standard home, and is also more comfortable and healthy for the occupants. SI houses can be of any design—Colonial, Victorian, Contemporary, ...


  • Data Requirements for Soil, Sediment, and Sludge

    Site soil conditions frequently limit the selection of a treatment process. Process-limiting characteristics such as pH or moisture content may sometimes be adjusted. In other cases, a treatment technology may be eliminated based upon the soil classification (e.g., particle-size distribution) or other soil characteristics. Soils are inherently variable in their physical and chemical ...

  • EPA Proposed “Franken-MACT” for Utilities

    EPA published the highly anticipated proposed Maximum Available Control Technology (MACT) Standard for the utility sector (40 CFR 63 Subpart UUUUU). When considered together with the growing list of proposed and final rules impacting the utility sector (Transport Rule/Cross-State Rule, Coal Combustion Byproducts Rule, Cooling Water Intake Rule, Regional Haze Rule, revised National Ambient Air ...


    By Trinity Consultants

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you