furan emissions monitoring Articles

  • Emission Testing and Monitoring

    Presented in Track B4: EMISSION TESTING & MONITORING at EUEC 2011, January 31 Phoenix, Arizona B4.1  | Update on PM2.5 and Condensable Particulate Matter Emissions Measurement Methods Larry Hottenstein |  Partner, Environmental Resources Management Following the promulgation of the PM2.5 ...

  • Pollution monitoring in Cement Industry

    The rising use of waste based fuels in the cement industry, both for economic and Environmental objectives, combined with the strengthening of air emission regulations around the world is pushing many operators to face a wider list of pollutants to monitor this, with associated costs. The design of appropriate solutions meeting local regulation is the key to maximize the cost benefit of the fuel ...


    By Environnement S.A

  • Monitoring - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Proposed boiler MACT sets aggressive emission limits

    On June 4, 2010, U.S. EPA proposed National Emission Standards for Hazardous Air Pollutants (NESHAP) for industrial, commercial, and institutional boilers and process heaters at both major and area sources of hazardous air pollutants (HAP) emissions.  EPA proposed separate rules for units at major sources of HAP emissions (greater than 10 tons per year [tpy] of any single HAP and/or greater ...


    By Trinity Consultants

  • A Case Study in Implementation of the National Emission Standard for Hazardous Air Pollutants for the Portland Cement Industry at a Major Source

    The regulations at 40 CFR 63, Subpart LLL are commonly known as PC MACT because the rule establishes the maximum available control technology for hazardous air pollutants (HAPs) from portland cement plants in the United States. There are 188 HAPs specified in Section 112 of the Clean Air Act Amendments of 1990. Two classifications of HAP emitters are specified in 40 CFR 63. Major sources of HAPs ...


    By Trinity Consultants

  • Dioxin Exposure and Health in the European Union

    A study on the Evaluation of the occurrence of dioxins and POPs in wastes and their potential to enter the food chainwas financed by the Environment Directorate-General of the European Commission and coordinated by the Joint Research Centre, Environment Institute, Soil and Waste Unit and aimed at investigating to what extent the use of contaminated wastes in the production of animal feedstuffs ...


  • New boiler MACT and affiliated rules proposed

    EPA proposed three related rules (with final rules expected by December 16, 2010), intended to reduce the emission of hazardous air pollutants (HAPs) from industrial, commercial, and institutional boilers and process heaters as well as commercial and industrial solid waste incinerators. Simultaneously, it also proposed a definition of solid waste that could potentially affect some units currently ...


    By Trinity Consultants

  • Total solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • Global solution: Gas and particulate analysis in Cement industry

    Cement plants are increasingly required to install continuous emission monitoring systems (CEMS). While these represent a significant financial outlay, a range of other factors also need to be considered when selecting a suitable CEMS. To the inexperienced, selecting a suitable CEM can mistakenly be considered as simply ensuring that the applicable national regulations (eg MACT in the USA, ...


    By Environnement S.A

  • EPA Proposed “Franken-MACT” for Utilities

    EPA published the highly anticipated proposed Maximum Available Control Technology (MACT) Standard for the utility sector (40 CFR 63 Subpart UUUUU). When considered together with the growing list of proposed and final rules impacting the utility sector (Transport Rule/Cross-State Rule, Coal Combustion Byproducts Rule, Cooling Water Intake Rule, Regional Haze Rule, revised National Ambient Air ...


    By Trinity Consultants

  • EPA proposes updates to CISWI rules

    On June 4, 2010, the U.S. EPA proposed updates to the Standards of Performance for New Stationary Sources (NSPS) for Commercial and Industrial Solid Waste Incineration (CISWI) Units (NSPS Subpart CCCC) and Emission Guidelines (EG) for Existing CISWI Units (EG Subpart DDDD), collectively referred to as the "CISWI Rules." In order to describe the proposed updates to the CISWI Rules, it is necessary ...


    By Trinity Consultants

  • EPA finalizes boiler NESHAP

    EPA published the final National Emission Standards for Hazardous Air Pollutants (NESHAP) for industrial, commercial, and institutional boilers and process heaters at both major and area sources of hazardous air pollutants (HAP) emissions. EPA developed separate rules for units at major sources of HAP emissions (greater than 10 tons per year [tpy] of any single HAP and/or greater than 25 tpy of ...


    By Trinity Consultants

  • Cementing the PC MACT

    On September 9, 2010, the U.S. EPA promulgated the final amendments to the National Emissions Standard for Hazardous Air Pollutants from Portland Cement Manufacturing Industry (40 CFR 63 Subpart LLL), also known as the PC MACT. EPA’s self-proclaimed “historic” rulemaking includes some important implications for cement manufacturers and other sources that may be subject to ...


    By Trinity Consultants

  • Evaluation of Ecological Risks Associated with the use of Chlorine Dioxide for the Bleaching of Pulp: Scientific Progress Since 1993

    1.1 Scope and Objectives A small number of viable options are presently available for the bleaching of wood pulp (delignification and brightening) during the manufacture of pulp and paper. The use of chlorine dioxide (ClO2) in the bleaching process has largely superceded the earlier use of Cl2, or elemental chlorine, in the majority of North American pulp mills: It was discovered over a decade ...

  • Pulp and Paper Mills Industry - Pollution Prevention Guidelines

    Introduction Pollution Prevention Guidelines to provide technical advice and guidance to staff and consultants involved in pollution-related projects. The guidelines represent state-of-the-art thinking on how to reduce pollution emissions from the production process. In many cases, the guidelines provide numerical targets for reducing pollution, as well as maximum ...


    By The World Bank

  • Final CISWI rule

    On March 21, 2011, in parallel with publication of the Boiler National Emission Standard for Hazardous Air Pollutants (NESHAP) rules and the Non-Hazardous Secondary Material (NHSM) rule, EPA promulgated the final updates to the New Source Performance Standards (NSPS) and Emission Guidelines (EG) for Existing CISWI Units, collectively referred to as the “2011 CISWI Rules.”1 The 2011 ...


    By Trinity Consultants

  • Integrated Modeling of Fate and Effects of Persistent Organic Pollutants in Marine Ecosystems

    Contaminants reach surface waters through different pathways, ranging from atmospheric deposition, infiltration in the soil during heavy rainfalls and migration with the groundwater or transport in particulate and dissolved phase in rivers. Domestic and industrial sewage water represents a major global source of pollution for surface water. Furthermore, agricultural activities may be associated ...


  • Regionally Based Assessment of Persistent Toxic Substances

    Untitled Document EXECUTIVE SUMMARY In 1997 the United Nations Environment Programme (UNEP) Governing Council decided that immediate international action ...


  • Why high temperature combustion of landfill gas?

    Due to the accumulation of knowledge and the tightening of environmental law, the landfill technology has increasingly become concerned with the management of trace compounds in landfill gas. With landfill gas, contamination is through sulphur, chlorine, fluorine, halogenated hydrocarbons and heavy metals. Other trace elements such as volatile organic compounds (VOC), impose environmental ...


    By Hofstetter BV

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you