gas calibration standard Articles

  • Primary Standard Gas Flow Calibration—The Only Guarantee of Accuracy

    At Sierra, we have a saying: “An instrument’s accuracy is only as good as its calibration.” The accuracy of your mass flow controller (MFC) is essential in assuring the efficiency, performance, and quality of your flow meter. In many cases, if your instrumentation is not calibrated, then a decline in performance is possible due to ...


    By Sierra Instruments, Inc.

  • Two Detector Solution to Analyzing Sulfur

    Sulfur compounds are reactive, corrosive to pipes, and destructive to catalysts in petroleum refineries. Sulfur emission are strictly regulated globally. When released into the atmosphere sulfur dioxide converts to sulfuric acid resulting in adverse effects on human health and the environment. Sulfur detection is found useful in many other industries; therefore, detection of sulfur compounds in ...


    By Restek Corporation

  • Environics - Reducing calibration gas cost by up to 60%

    EPA's appendix 'M' 40 CFR 51 reduces calibration gas cost by 60%By: Terrence P. Dunn, President of EnvironicsOn May 30, 1995, the EPA published the final version of Method 205 for inclusion in Appendix M of 40 CFR Part 51 entitled, 'Verification of Gas Dilution Systems for Field Instrument Calibrations.' Continuous emissions monitoring systems (CEMS) require ...


    By Environics, Inc.

  • Sonic nozzles for gas calibrators, when simplicity provides accuracy!

    Gas analyser’s calibration is a task required in many applications according to either legislation or quality systems management. This is the case for Air Pollution Monitoring or Continuous Emissions Monitoring devices installed in cabinets, for continuous analysis in remote locations. Measurements in traces range are performed and analytical devices specifications need to be validated and ...


    By LNI Swissgas

  • Follow toxic gas standards for a smoother project

    Toxic gases, such as Hydrogen Sulfide and Sulfur Dioxide, can injure and kill quickly. Therefore, mitigation of these hazards must be fast and sure. The United States Occupational Safety and Health Administration (OSHA) and other authorities take detection of these gases very seriously. The American National Standards Institute/ American Petroleum Institute (ANSI/API) and ISA industry standards ...

  • The Cost of Inaccurate CEM Calibration Gases

    Utility companies and other users of Continuous Emissions Monitoring (CEM) calibration gases often mistakenly consider them a commodity, making price the primary purchase consideration. Consequently, many are willing to settle for calibration gases that are ...

  • Compliance to standards in continuous emissions monitoring case study

    Customer: Glass Manufacturer Application: Continuous Emissions Monitoring Service (CEMS) for Glass Manufacturing Background: A glass factory is required to ...


    By Ecotech Pty Ltd

  • Gas Safety in Confined Spaces

    Introduction An offshore worker ensures a vessel is safe to enter; a plant manager enters a small plant room; a contractor inspects the lining of a sewage pipe.  All these personnel face common dangers, despite working in widely different industries.  Gas-related injury poses a serious threat in any confined space where the free movement of air is limited. A confined space ...

  • SPGAS: Specialty gas analysis software

    About SPGAS SPGAS is a user-friendly, turnkey FTIR software package designed specifically for the analysis of gaseous constituents. While providing all of the control features of a standard FTIR software package for Bomem spectrometers, SPGAS also provides the ability for 24/7/365 operation of the IRGAS analysis package. SPGAS is designed to save spectral files from each day of ...


    By CIC Photonics, Inc.

  • Gas detector communication technology for offshore oil and gas platforms

    In few applications is safety as important as on offshore oil and gas platforms. Explosive hazards from hydrocarbon gases and vapours are an ever-present risk, whilst toxic hydrogen sulphide gas and depleted oxygen environments can pose significant risks to personnel. Gas detectors are therefore essential to provide dependable early warning of gas hazards. Gas detectors are permanently installed ...

  • NovaGerar landfill gas to energy project

    Overview The objective of the NovaGerar Landfill Gas to Energy Project in Nova Iguaçu - Rio de Janeiro, Brazil is to explore the landfill gas (LFG) collection and utilization activities of the landfills managed by S.A. Paulista. This involves investing in a gas collection system, leachate drainage system and a modular electricity generation plant at each landfill site (with expected ...


    By LANDTEC

  • A Guide to Gas Detector Tubes. Your Questions Answered

    Gas detector tubes are easy to use, are low cost, and the method is intrinsically safe, allowing it to be deployed in all industries. Because detector tubes don’t require calibration, users see the benefits of this technology over electronic gas detectors due to their ease of ...


    By a1-cbiss

  • Benefits of HART Communication-Enabled Gas and Flame Detectors

    Catastrophic results can occur when a fire or a flammable/toxic gas release goes undetected in any petrochemical facility. For early warning and prompt hazard mitigation, flame detectors and gas detectors are essential tools. Clear, usable, diagnostic information from these detection instruments is extremely valuable in ensuring the devices are properly maintained, tested, and poised to protect ...

  • Selecting and Placing Gas Detectors for Maximum Application Protection

    Many industrial processes involve dangerous gases and vapors: flammable, toxic, or both. With the different sensing technologies available, and the wide range of industrial applications that exist, selecting the best sensor and locating them properly for the job at hand can be a challenge. To ensure a high level of safety, know the latest sensing technologies, which technology is best for the ...

  • Upgrading from Pellistor Gas Sensors to Infrared Technology

    In this article Andy Avenell, Crowcon’s Fixed Systems Product Manager, considers the shift towards infrared (IR) gas sensor technology in the oil and gas industry. Abstract Flammable gases and vapours can present considerable dangers in many industrial applications, none more so than the processes involved in extracting, transporting and processing oil and gas. Fast and reliable ...

  • Gas analysers support management of Swindon fire

    The capability to convene a multi-agency Air Quality Cell (AQC) was established in England in 2009 following the Buncefield Oil Storage Depot incident. A review of this event identified the need to rapidly co-ordinate the acquisition, analysis and interpretation of air quality data in major incidents. Arrangements have been made in England to bring together experts from the Environment Agency ...


    By Quantitech Ltd

  • Multiple gas impurity analyses and verification for semiconductor process tools

    With the increased emphasis on the purity of cleaning, etching and treatment gases by the semiconductor industry, advanced analysis instrumentation is required to monitor the electronic specialty gases and to verify the performance of process tools and components. This paper describes new instrumentation and software specifically designed to accomplish ppb level gas analyses in times as short as ...


    By CIC Photonics, Inc.

  • Bacteria TMDL Solution to Protect Public Health and Delisting Process in Columbus, GA

    Under the Middle Chattahoochee Watershed Plan, the Columbus Water Work’s adaptive TMDL Implementation Planning strategy utilizes comprehensive watershed modeling and implementation of innovative non-point source BMPs to address TMDLs and protect beneficial uses of two waterways in Columbus, GA. Calibrated BASINS modeling is used to demonstrate compliance with bacteria standards for waters listed ...

  • Safety Systems Depend on Reliable Field Sensors (Emphasis on Fire and Gas Detectors)

    Abstract Because not all hazards are the same, identifying and quantifying the hazard is the starting point in choosing sensing technology. Not all detectors are the same, and they should be selected according to their ability to detect the hazard. This paper gives a broad summary of technologies that provide users reliable responses to hazardous conditions, that minimise false ...

  • The World’s Largest Gas to Liquids Facility Runs on Thermo Scientific SampleManager LIMS

    Established by Shell and Qatar Petroleum in 2006, Pearl GTL is the largest gas to liquids facility on the planet. Gas to liquids (GTL) is the conversion of natural gas to liquid fuels and other products, including gasoil, naphtha, kerosene, normal-paraffin and lubricants. Pearl GTL has a capacity of 140,000 barrels per day of these products and 120,000 barrels per day of liquefied petroleum gas, ...

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you