gas calibrator technology Articles

  • New White Paper on FTIR multigas analysis

    Quantitech has announced the publication of a free White Paper on the simultaneous measurement of multiple gases in a wide variety of applications using FTIR (Fourier Transform InfraRed) technology. With the ability to measure almost any gas, FTIR monitoring technology is employed in an enormous variety of applications including Continuous Emissions Monitoring, Stack Testing, Process Control, ...


    By Quantitech Ltd

  • Environics - Reducing calibration gas cost by up to 60%

    EPA's appendix 'M' 40 CFR 51 reduces calibration gas cost by 60%By: Terrence P. Dunn, President of EnvironicsOn May 30, 1995, the EPA published the final version of Method 205 for inclusion in Appendix M of 40 CFR Part 51 entitled, 'Verification of Gas Dilution Systems for Field Instrument Calibrations.' Continuous emissions monitoring systems (CEMS) require ...


    By Environics, Inc.

  • Gas Monitor Bump Testing vs Calibration

    We are often asked to explain the difference between calibrations and bump testing. This is a controversial subject. OHS would have you do a full calibration before each use. In practice, our customers come up with their own intervals. If the gas monitor is used infrequently, say once a month, it should be calibrated every time to give you confidence that the unit is going to respond as it ...

  • How Often Should Gas Detectors be Calibrated and by Whom?

    Calibration frequency is one of the most commonly asked questions concerning the use of gas detection instruments. Common factors to consider when deciding how frequently to calibrate are: type of sensor, type of gas detector (fixed vs. portable), the required use and accuracy of the detector, manufacturer’s recommendations, how confident you are about the functioning of your instrument ...

  • Introduction of ECU Calibration tool, STARS Calibrate

    The control of engine is becoming more complicated over the years for balancing clean exhaust gas with high merchantability in addition to the fuel mileage improvement demand today and is controlled by the computer, ECU (Engine Control Unit). As the example of complexes, there are the implementation of Variable Valve Technology, Direct Injection to Gasoline Engine/Common-Rail Injection to Diesel ...


    By HORIBA Europe GmbH

  • Automatic calibration saves big

    Automatic gas sensor calibration technology was developed by Rel-Tek and proven over a decade of industrial applications involving large alternative fuel, transit bus garages.  CNG, LNG, LPG and hydrogen fuels present the possibility of explosive gas buildup indoors, so sustaining the accuracy of the installed gas monitoring system is a never-ending responsibility for the owner.  ...


    By Rel-Tek Corporation

  • Sonic nozzles for gas calibrators, when simplicity provides accuracy!

    Gas analyser’s calibration is a task required in many applications according to either legislation or quality systems management. This is the case for Air Pollution Monitoring or Continuous Emissions Monitoring devices installed in cabinets, for continuous analysis in remote locations. Measurements in traces range are performed and analytical devices specifications need to be validated and ...


    By LNI Swissgas

  • Upgrading from Pellistor Gas Sensors to Infrared Technology

    In this article Andy Avenell, Crowcon’s Fixed Systems Product Manager, considers the shift towards infrared (IR) gas sensor technology in the oil and gas industry. Abstract Flammable gases and vapours can present considerable dangers in many industrial applications, none more so than the processes involved in extracting, transporting and processing oil and gas. Fast and reliable ...

  • Gas detector communication technology for offshore oil and gas platforms

    In few applications is safety as important as on offshore oil and gas platforms. Explosive hazards from hydrocarbon gases and vapours are an ever-present risk, whilst toxic hydrogen sulphide gas and depleted oxygen environments can pose significant risks to personnel. Gas detectors are therefore essential to provide dependable early warning of gas hazards. Gas detectors are permanently installed ...

  • Valve actuation at the world’s largest flow metering calibration facility

    Currently nearing completion, EuroLoop will be the world’s largest test site for industrial flow meters. Two separate circuits are available, for testing both gas meters and liquid meters. Both circuits are fully automated, making extensive use of electric and pneumatic actuators with sophisticated control systems. Situated by the New Meuse River in Rotterdam, EuroLoop will be the ...


    By Rotork

  • Not All Hazards are the Same: Design considerations for matching flame and gas hazards to detector technologies

    Not all flame and gas hazards in facilities are the same, therefore the detection technology chosen should be specific to the type of hazard to be detected. How do users select technologies to see certain fires or detect certain gases? The intent of this paper is to give a broad introduction to the selection and use of flame and gas detector technologies. We will answer questions such as these: ...

  • Greenhouse gas emissions and reduction studies using a portable TDL gas monitor

    Boreal Laser's GasFinder is a portable open path gas monitor based on laser technology. GasFinder is uniquely suitable for studies of greenhouse gas emissions. It is specific to the gas of interest, provides one second response and has a broad dynamic range. GasFinder is permanently calibrated and is very small and light (less than 5kg). Alignment is easy and stable. No on-site electronic tuning ...


    By Boreal Laser Inc.

  • Understanding the Benefits of Fixed Gas Detection

    "Fixed gas detection is an essential method of ensuring maximum protection for personnel and plant. There are a variety of technologies available for a multitude of applications. Understanding fixed gas detection is the first step in providing safety." What is fixed gas detection? Fixed gas detection is installed with the aim of providing continuous, area and personnel protection. ...


    By a1-cbiss

  • FTIR gas monitor for diverse applications

    QUANTITECH, a leading supplier of environmental monitoring instrumentation, has recently supplied EURO Environmental Services in Ireland with a transportable Gasmet FTIR multiparameter gas analyser which EURO Environmental's Managing Director Geoff Fitzpatrick says, “is proving invaluable in many varied applications across a broad selection of industries.” With headquarters in Drogheda in Ireland ...


    By Quantitech Ltd

  • Danger and Detection of Hydrogen Sulphide Gas in Oil and Gas Exploration and Production

    A rig worker smells rotten eggs near the well head, rubs his itchy eyes as he investigates the frosty pipe connections. After a few moments, he believes all is fine as he no longer smells the tell-tale hydrogen sulphide odour. In this scenario, we can only hope the worker recognises the danger and quickly leaves the site. Oil fields, especially mature ones, can produce hydrogen sulphide gas ...

  • FTIR becomes best option for multi-gas emissions

    Globally, the number of industrial processes and emissions being monitored with Gasmet’s FTIR multi-gas technology has increased enormously in recent years as process managers exploit the benefits of being able to monitor a wide range of gases simultaneously and with minimal maintenance and calibration requirements. Gasmet CEMS (continuous emissions monitoring systems) are used for ...


    By Gasmet Technologies Oy

  • Chlorine Dioxide gas detection: A comprehensive guide

    Introduction Some years agoago, the bleaching process in the paper industry was changed from using Chlorine (Cl2) as bleaching agent to Chlorine dioxide (ClO2). This was a challenge forThis posed a major challenge to industrial hygienists, as there were no sensors or detectors available that were specific to Chlorine dioxide: There was no sensor technology for gas detectors available that ...

  • Benefits of HART Communication-Enabled Gas and Flame Detectors

    Catastrophic results can occur when a fire or a flammable/toxic gas release goes undetected in any petrochemical facility. For early warning and prompt hazard mitigation, flame detectors and gas detectors are essential tools. Clear, usable, diagnostic information from these detection instruments is extremely valuable in ensuring the devices are properly maintained, tested, and poised to protect ...

  • FTIR gas analysis improves container safety

    Introduction Entry to freight containers represents a significant hazard to staff responsible for inspection, stuffing or destuffing because of the large number of airborne chemicals that can be present. Research in Germany and the Netherlands found hazardous levels of gases and vapours in around 20% of all containers and this level of contamination is now accepted as commonplace. It ...


    By Gasmet Technologies Oy

  • Wastewater Treatment Plant Monitors Greenhouse Gas Emissions

    Globally, little attention is paid to gaseous emissions from wastewater treatment processes. This contrasts greatly with the regulatory monitoring that is applied to the quality of water emissions from such facilities. However, in Helsinki, Finland, a large municipal wastewater treatment facility continuously monitors its emissions of greenhouse gases (GHGs) to help in the city’s efforts to ...


    By Gasmet Technologies Oy

Need help finding the right suppliers? Try XPRT Sourcing. Let the XPRTs do the work for you